What is the standard for reversing in subject 2?

1. Those who do not follow the prescribed route and sequence are not qualified;

2. If the body is out of the line, it is unqualified;

3. If the warehouse is not entered, it is unqualified;

4. If it stops halfway, it is unqualified;

5. More than 4 minutes, unqualified.

Subject 2] Subject 2, also known as the road test, is part of the motor vehicle driver's license assessment, is the abbreviation of the field driving skills test subject, the car C1C2 test items include reversing into the garage, side parking, ramp fixed-point parking and starting, right-angle turning, curve driving (commonly known as S curve) five compulsory tests.

Key points of the reversing and warehousing test].

1. Without a reference object (bamboo pole), you can only observe the position of the vehicle through the rearview mirror. Therefore, when practicing, it is necessary to strengthen the use of rearview mirrors;

2. You can't stop during the test, and you have higher requirements for the use of the clutch. When practicing, you must use the clutch more, learn to use the clutch flexibly to control the speed, so that it is slow and does not stop, keep the speed at about 5 kilometers per hour, and slowly complete the entire reverse rod action.

The content of the second subject is reversing and warehousing:

Pour from starting point A into warehouse B and stop straightening. Proceed to Return Area C and stop. Pour into warehouse B from the return area and stop steadily. Return to A from library B and the exam is complete.

Judging criteria: Those who do not follow the prescribed route and sequence will be unqualified.

The body is pressed and reversed, and it is unqualified.

If the reversing is not completed in more than 210 seconds, it is unqualified.

5 points will be deducted for each stop.

The deduction criteria for reversing into the warehouse are as follows:1. If you do not follow the prescribed route sequence, 100 points will be deducted;

2. 100 points will be deducted for the body qualification;

3. If the warehouse is not entered, 100 points will be deducted;

4. Before reversing, the two front wheels are not touched beyond the control line, and 100 points will be deducted;

5. If the project completion time exceeds 210s, 100 points will be deducted;

6. If you stop for more than 2s in the middle of the road, 5 points will be deducted each time.

Usually practice car must develop good habits, first right to the library, and then left to the library, the test must be in accordance with the regulations, if not in accordance with the prescribed route, even if your operation is perfect, it is useless.

Summary. Dear, hello, the size of the driver's license test subject 2 inverted library test area is 16m long and wide; The garage size is long and wide.

First, the content of the inverted test:

1. Pour it into warehouse B from the starting point A and stop it.

2. Go to the return area C and stop steadily.

3. Pour into warehouse B from the return area and stop steadily.

4. Return to A from library B and the exam is completed.

Second, the evaluation criteria for the reversal:

1. Those who do not follow the prescribed route and sequence are not qualified;

2. The body is out of the line, reversing is not entering, and stopping halfway is unqualified.

3. More than 210 seconds without completing the reversing and warehousing is unqualified.

Dear, hello, the size of the test area is 16m long and wide; The garage size is long and wide. 1. The content of the reversing test: 1. Pour from the starting point A into the B library, and stop correcting.

2. Go forward to the return area C and stop steadily. 3. Pour into warehouse B from the return area and stop steadily. 4. Return to A from the Sail B library, and the exam is completed.

Second, the evaluation criteria for reloading: 1. Those who do not follow the prescribed route and sequence will be unqualified. 2. The body is out of the line, reversing is not entering, and stopping halfway is unqualified.

3. More than 210 seconds without completing the reversing and warehousing is unqualified.

Pacific Automobile Network] Section 2 reversing and warehousing deduction rules: 1. If you do not drive in accordance with the prescribed route order, you will be deducted 100 points; 2. 100 points will be deducted for the body qualification; 3. If the warehouse is not entered, 100 points will be deducted; 4. Before reversing, the two front wheels are not touched beyond the control line, and 100 points will be deducted; 5. If the project completion time exceeds 210 seconds, 100 points will be deducted; 6. If you stop for more than 2 seconds, 5 points will be deducted each time.

If you do not follow the prescribed route sequence, 100 points will be deducted; 100 points will be deducted for the body qualification; If the warehouse is not entered, 100 points will be deducted; Before reversing, the two front wheels did not exceed the control line at the contact point, and 100 points were deducted; If the project completion time exceeds 210 seconds, 100 points will be deducted; If you stop for more than 2 seconds, 5 points will be deducted each time.

Reversing warehousing operation skills:

1. Before getting in the car, observe whether the body is adjusted, and after getting in the car, fasten the seat belt, adjust the seat, observe the rearview mirror, and lightly step on the brake and clutch to find the feeling.

2. If the body is not right, the body should be adjusted in time, and when the shoulder coincides with the ground control line, stop and hang the reverse gear.

3. When the lower edge of the left rearview mirror coincides with the ground control line, quickly hit the direction to the right, and pay attention to the 30cm margin between the body of the right rearview mirror and the sideline, this point is very important, less than 30cm back to a circle.

4. After the body is put into storage, when the body is parallel to the sideline, return to the positive direction, pay attention to the rearview mirror, which side is wide to which side to adjust the direction.

5. Stop when the lower edge of the left rearview mirror coincides with the ground control line.

6. Hang 1st gear, observe the rearview mirror, the margins on the left and right sides and the body, the body is not right, and under the fine-tuning, avoid the outbound line.

7. Observe through the left rearview mirror, when the wheel presses the storage line, quickly kill the direction to the left, complete the left reverse warehouse, and the following point of view is the same as the right reverse warehouse.

Photo by Tai Zhi Ping Yang Automobile Network Q&A called the beast).

The standard of reversing and warehousing deduction is chaotic: 100 points will be deducted for not driving in accordance with the prescribed route sequence; 100 points will be deducted for the body qualification; If the warehouse is not entered, 100 points will be deducted; Before reversing, the two front wheels did not exceed the control line at the contact point, and 100 points were deducted; If the project completion time exceeds 210 seconds, 100 points will be deducted; If you stop for more than 2 seconds, 5 points will be deducted each time. The following is an introduction to the skills of the exam operation:

1. Preparation for getting into the car: Before getting into the car, observe the body and adjust the seat after getting on the car, fasten the Qiyuan seat belt, observe the left and right rearview mirrors, and lightly step on the brakes and clutch to find the feeling. 2. Adjust the body:

If the body is not right, first adjust the body to the right shoulder and stop when the ground control line coincides. 3. 30cm margin between the body and the corners: pay attention to the right rearview mirror when reversing, the 30cm margin between the body and the corners is less than 30cm, and it is easy to crimp the line when the half circle is greater than 30cm.

There are 6 deduction criteria for reversing in the subject 2 exam: as follows.

1. Points will be deducted for reversing and warehousing.

1. The project completion time exceeds 210 seconds: 100 points will be deducted (key points will be deducted) 2. Driving not according to the prescribed route and order: 100 points will be deducted.

3. Before reversing, the front wheel contacts are not driven through the control line: 100 points.

4. Stopping for more than 2 seconds: 5 points will be deducted.

5. Failure to enter the warehouse: 100 points will be deducted.

6. Body qualification: 100 points will be deducted.

2. Deduction of points for universal pina pants.

1. Failure to wear a seat belt: 100 points will be deducted.

2. Failure to close the door: 100 points will be deducted.

3. If the gear is not in neutral when starting the engine: 100 points will be deducted.

4. Failure to turn signals (including starting, changing lanes, overtaking, turning, and pulling over); The turn signal is turned on for less than three seconds; Forgetting to turn off the turn signal or using the turn signal incorrectly: 10 points will be deducted.

5. Turn off the fire once: 10 points will be deducted.

3. The content of the subject 2 exam is divided into five items: fixed-point parking for uphill starting, side-oriented parking, curve driving, right-angle turning, and reversing into storage. The total score is 100 points, and the score of 90 points for the quasi-driving type of large buses, tractors, city buses, medium-sized buses, and large trucks is qualified, and the scores of other quasi-driving types are qualified if the score reaches 80 points.

Module 2 is designed to test students' driving skills and their judgment of spatial orientation. Therefore, the standard of deducting points in the subject 2 exam is closely related to the basic operation of the students.

In the subject 2 exam, the width of the warehouse is meters, and the length of the library is meters. The length of the road in the test area is 16 meters, and the width of the road is meters.

Reversing into storage judging criteria hail letter.

1. Those who do not follow the prescribed route and sequence are not qualified;

2. The body is out of the line, reversing is not entering, and stopping halfway is unqualified.

3. More than 210 seconds without completing the reversing and warehousing is unqualified.