If there is an error in the system, how to solve the problem when the system occurs

I know what kind of machine you're going to install.

Error Cause Analysis: The computerz file in your system is corrupted, and an error message will appear when a software reads it.

Error workaround:

If you don't have Master Lu software installed, you can follow the steps below:

1. Counter-register computerz files.

4. Re-register the computerz file.

Missing the DLL dynamic chain, is it a hardware master with 360 installed? If so, use 360 Security Guard to repair the operating system.

It's not a system error, it's a system crash. Just change the system disk with good compatibility and reinstall the system, so that the system crash problem can be solved automatically and smoothly throughout the process. These are possible with a USB flash drive or hard disk, and the installation speed is very fast.

But the key is: to have good compatibility (compatible with IDE, ACHI, RAID mode installation) and can be automatically and permanently activated, can automatically install the machine hardware driver sequence of the system disk, which can be the whole process of automatic and smooth reinstallation of the system. Here's how

1. U disk installation: ** A verified system installation disk file (ISO file), use ultraiso software to make a boot U disk to install the system, and use this to start the machine after the system U disk guide is used to install the system smoothly;

exe" to the non-system partition of the computer, and then run "Install the system." exe", directly press enter to confirm the restore operation, and reconfirm the automatic installation operation. (Pay attention to back up the important data of the C drive before execution!)

3. **version tutorial: How to give you the detailed **version installation tutorial in this regard? Can't be attached. will be judged by the system as a violation. The address is in .........si xin zhong………Yes! Hope!

This is an illegal shutdown or other reason that causes the disk to be damaged, please fix it (fix it for each disk or only fix C).

Built-in disk repair method:

The specific steps are as follows: select the drive letter c in my computer, right-click the right mouse to select the properties, select "Tools Start Checking" in the pop-up drive properties window, and select "Automatically repair file system errors" and "Scan and recover bad sectors", and then click Start, the scanning time will vary depending on the disk capacity and scanning options (after doing it according to the above method, a box will pop up, the point is, repair it at boot after automatic shutdown, win7 select the disk check button according to the plan).

Bad sectors on the hard drive will lead to corruption or loss of computer system files, computer failure to boot or freeze. Hard disk bad sectors can be repaired using NDD Disk Utility or Scandisk.

If the fault persists, please restore the system or reinstall it (it is still not possible to format the hard disk and repartition and reinstall it, if it doesn't work, you will have to replace the hard disk, or overhaul it).

This may be a disk issue.

It is recommended to run chkdsk to detect it.

There are many situations that can occur, such as a problem with the hard disk [a high rate of hard disk read errors or a failed hard drive], and an aging or loose data cable. Problems with memory modules. Then there is the udma mode, which generally does not appear.

There are times when you can't turn on the machine? You can try to unplug the hard drive cable and plug it in again to see if this situation will occur, usually only when the machine plugs in the mobile hard disk and operates with each other! Is your hard drive Seagate's?