-
Anonymous users2024-02-07Mine is also a problem.,Other computers can access the Internet.,Mobile phones are OK.,It's this win10 when you automatically get the IP (Ethernet doesn't have a valid IP configuration) manually enter the IPv4 attribute in the (IP address:Subnet mask:Default gateway:
DNS preferred: . I can't connect either.
The diagnostic result is (the default gateway is not available) and looking at the network properties is (connected to.
Unknown network. No Flow).
It's been 48 hours. It turned out to be good, I connected 3 monitoring devices behind the gateway, and there was a mobile phone that couldn't be connected, and the wired network was fine. It didn't work if it was restarted, so I removed the monitoring equipment, and it didn't work.
The power went out for a few hours, and then the phone worked, and I took back the wired monitoring computer couldn't be connected, and now it's all withdrawn and restored to its original appearance, and this is the result.
-
Anonymous users2024-02-06There will also be when you get something off.
It doesn't matter how many numbers you have on your internet connection.
As long as there is no packet loss, the network is smooth.
-
Anonymous users2024-02-05Sometimes, when the computer is turned on, it will show that it is connected to an unknown network but there is no traffic, what is the matter?
There are only two possibilities, pin and harass you are automatically assigned IP through routing, the first can be, the Internet account and password on your route are wrong, or the route settings are incorrect, and the second is what the friend said above, you can have the gateway not set up. In fact, the computer you said shows that the network is connected, that is just the physical line is no problem, whether you can get on the internte is to see the sending and receiving of your traffic, there is no traffic display you can not go to the Internet, this chain is closed to ping, send data packets, but can not receive data packets.
-
Anonymous users2024-02-04If you have turned on the data but there is no network connection, it may be due to the following reasons:1Unstable cell phone signal:
Especially in places with poor signals, such as basements and elevators, mobile phones may not be able to receive the signal, resulting in no network connection. 2.Data is not turned on:
Some operating systems or apps need to be set up before they can use data. Please check whether you or the phone next to you has data enabled, and make sure that the data quota is sufficient. 3.
Phone software glitches: In some cases, your phone may have a software glitch that prevents you from connecting to the network. You can try restarting your phone and reconnecting to the network for testing.
4.Carrier failure: If another subscriber is experiencing the same issue, it's likely that the network provider is having a problem.
You can consult your carrier's customer service or wait for a while before trying to connect to the network. 5.If the mobile phone is in arrears, it will also cause the traffic to be turned on and there will be no network.
-
Anonymous users2024-02-03I turned on the data but it didn't show the network status and I couldn't connect to the Internet.
I turned on the data traffic, but it didn't show the network status, and I couldn't connect to the network, because 1Check your phone's settings Open your phone's Quick Center (swipe down at the top or swipe up at the bottom) to see if data is turned on. 2.
Confirm the status of the mobile phone card Make sure that the balance of the mobile phone card is sufficient, if the mobile phone is shut down in arrears, please restart the mobile phone after the recharge is successful. Check with your carrier to see if you've met the data limit. If necessary, you can change the SIM card that can access the Internet normally to confirm.
3.Check your phone's signal If your phone uses a metal, magnetic case or bracket that has an impact on your phone's signal, we recommend removing it and trying it. If you are in an underground parking lot, elevator hall and other environments, the coverage of the mobile phone signal is susceptible to these environmental impacts, the signal will be relatively weak, and the data network will also be affected, it is recommended that you go to an open area, such as an outdoor open environment for testing.
4.To view the network permissions, please go to Mobile Phone i Manager - Traffic Management Traffic Monitoring - Network Management or Set Applications and Permissions --
-
Anonymous users2024-02-02Summary. Traffic on no network can be caused by the following reasons: Bad network signal:
If you're in network coverage, but the network signal is not good, and the data is turned on, you can't connect to the internet. Networking setup issues: If your device is set up incorrectly, for example, the APN is set up incorrectly or mobile data is disabled, it will cause traffic to turn on but no network connection.
Carrier failure: If your carrier is down or maintained, it can cause traffic to be turned on but unable to connect to the internet. Device Failure:
If your device's hardware or software fails, it can cause traffic to turn on but you can't connect to the internet. It is recommended that you try the following solutions: restart your device and wait for a while to try the internet connection again.
Confirm that your device's internet settings are correct. If your carrier is undergoing maintenance, please be patient and pay attention to your carrier's notifications. If necessary, contact your device manufacturer or carrier for further support.
Traffic turned on without network can be caused by the following reasons: Bad network signal: If you are in network coverage but the network signal is not good, the traffic is turned on and you can't connect to the internet.
Internet Setup Issues: If your device is set up incorrectly, such as Rana, APN is set incorrectly, or mobile data is disabled, it will cause the traffic to turn on but no network connection. Carrier failure:
If your carrier is down or maintained, it can cause traffic to be turned on but unable to connect to the internet. Device failure: If your device's hardware or software fails, it can cause Streaming Divine to turn on but not be able to connect to the internet.
We recommend that you try the following solutions: Restart your device and wait for a while before trying to connect to the internet. Confirm that your device's internet settings are correct.
Fellow, I really didn't understand, I can be more specific.
It is possible that the mobile phone is in arrears, or the data is used up and capped.
First of all, it feels like you are sharing the Internet in a local area network, and we will analyze it with the elimination method. First of all, you said that the network cable can be plugged into other computers to access the Internet, indicating that the end of the network cable interface is normal, and the conclusion is that 1. Your computer may have software and hardware problems that cause you to not be able to access the Internet. 2. Your computer is restricted by the server or router. >>>More
691 You should use PPPOE dial-up Internet access, this problem arises, mainly: >>>More
Hello, it can be solved by the following methods:
2. Directly click on the network signal in the lower right corner - start the network and sharing center - troubleshooting - click according to the prompts to automatically fix the wrong IP; >>>More
If it is wifi, it is recommended that you click Settings - WLAN - Advanced Settings to select Never sleep, and click Settings - WLAN - to find this wifi, click the small arrow on the right, do not save the network, re-enter the password to try, you can also try to restart the router to try, if this problem still occurs, it is recommended that you try the wifi network in other environments to see if this problem still occurs. >>>More
It is estimated that your desktop is set with a fixed IP, the Internet Neighbor right-click attribute, then find the local connection right-click attribute, find the Internet Protocol to see if the IP address is automatically obtained.