What kind of sticky is used for the flute film, and how to use the solid flute film glue

The more advanced use of "Ejiao", generally just use water, you breathe on the mulch, and then use your fingers to smooth the flute around the film.

Doesn't it stick with water?! Don't stick it

As follows:

1. Cut off about two centimeters of flute membrane.

2. Gently stretch the flute membrane and soften it with warm water.

3. Next, apply the glue block evenly around the flute hole.

4. In this process, it is necessary to pay attention to flattening and not leaving gaps.

5. Just put on the flute film protective case.

The general solid flute film glue is Ejiao. Ejiao is actually a tan solid glue made from donkey skin, which is boiled and concentrated.

Ejiao itself is a warm Chinese medicine that is rich in protein. It is these proteins that make Ejiao viscous and elastic, so it is suitable for use as a gel for sticking the flute membrane to the flute. When attaching the flute film to the flute, pay attention to adjusting the tightness before the glue dries.

Do not mix too much water when mixing with water to avoid being too loose.

1. Cut about 2 cm of the flute membrane from a long section of the flute membrane, as shown in the figure below.

2. Trim the 2 cm flute membrane completely, as shown in the figure below.

3. Dip the glue block in a little warm water to soften, as shown in the figure below.

4. Apply Ejiao evenly around the flute hole, as shown in the figure below.

5. Stick the flute film flat without leaving a gap, as shown in the figure below.

6. Finally, put on the flute film protective case, as shown in the figure below.

In general, <> use paste to stick the membrane is not ideal. The reasons are as follows: First of all, the paste is not strong enough to provide sufficient support, and for this kind of high-strength ** device, if the bond is not strong, Shifu will affect the performance effect.

The second type, the paste is a water-containing material, and if applied directly to the flute membrane, it may cause the flute to deform or lose its elasticity, or even fail completely. Finally, the membrane usually needs to be bonded with a special glue to ensure that its surface is completely flat and not affected by external interference. The use of non-special glues and tools can easily lead to problems such as unstable installation and sound distortion.

Therefore, it is recommended to use special glues and tools when sticking the flute film to ensure the quality and effect of the bonding, so as not to affect the playing experience of the instrument.

I am happy to answer for you, the following is the result of your query for the silver core: Yes, the paste sticky flute film can be used to paste the vibrating table of the sound of the flute, and the jujube can be used to repair and repair the flute. To use paste viscous film, you need to prepare several materials first:

Paste, diaphragm, flat sharpening, and finally hot water. First of all, the paste is evenly applied to the flute membrane, and then the flute membrane is firmly attached to the surface of the flute; Next, use a flat sharpener to stick the flute membrane tightly; Finally, soak the diaphragm in warm water for a while to finally allow the diaphragm to stick to the surface of the flute. Ruguo wants to repair the flute, in addition to the paste sticky flute film, you can also use modified melt resin, which is combined with ceramics and lacquer, can be cured in a hot environment without shrinkage, can be cured instantly, can maintain the color and timbre of the flute itself, and effectively improve the performance effect and sound of the flute Fengyan digger.