What should I do if Volkswagen Xia Lang, who has only been burning engine oil for two years, is seri

The engine oil itself has a certain amount of consumption, and excessive consumption is the problem of burning engine oil. Burning engine oil is caused by the following factors, as long as the following problems are solved, burning engine oil can be solved. There are many factors that affect the burning of engine oil, such as:

Fuel quality, driving conditions, driving habits, maintenance habits, etc., the above reasons will aggravate the oil consumption and cause the engine oil to burn, so that the vehicle appears: 1. Carbon deposition occurs in the combustion chamber, which makes the air ring of the piston ring stuck and poor sealing. 2. Oil sludge is generated in the lubrication system, and the oil sludge blocks the oil return hole of the oil ring and weakens the oil scraping performance.

3. Wear occurs between the piston and the cylinder wall. 4. The valve seal is corroded and aging, and the sealing performance fails. In addition, cars now have crankcase ventilation systems (exhaust valves), which can also exacerbate oil consumption if there is a problem.

In the past, the problem of burning engine oil could only be solved by dismantling and repairing, but now there is a plan to solve the problem of burning engine oil without dismantling and repairing, which can be understood by taking a look.

Burning engine oil means that the engine oil enters the combustion chamber of the sail hole machine through a certain way, and participates in the combustion together with the mixture. This is mainly due to a cylinder leak caused by damage to the piston rings, and oil escapes into the combustion chamber. It is recommended to carry out maintenance as soon as possible, if this is the case for a long time, not only the fuel consumption of the engine car is large, but also the impurities generated by the combustion of the engine oil will cause the increase of carbon deposits in the combustion chamber.

If the engine burns oil seriously, it is necessary to call Hongxing engine overhaul, replace the cylinder liner, piston, piston rotten ring, and then carry out cylinder head valve reaming, replace the valve oil seal, and Zheng Lishu can solve the problem of burning engine oil.

It is recommended to check the following aspects: 1. Crankcase forced ventilation valve; 2. Carrying orange exhaust valve; 3. Whether the model of oil deficit is up to standard; 4. Whether the turbocharger is working normally. Hope to pick up the pin key acceptance.

It is a matter of time before the Volkswagen car burns engine oil, and improper use or improper maintenance can easily cause the serious phenomenon of burning engine oil to be purely judged. However, if the maintenance is reasonable, the phenomenon of burning engine oil will be slightly better, but due to the existence of turbocharging technology, the phenomenon of burning engine oil basically exists for European Pat Zhao cars.

Volkswagen Sharan burns engine oil seriously, how to solve the old slippery problem? If the Volkswagen Charon burns the engine oil seriously, then let the wild you only have to change the spark, plug the spark plug, change the oil and burn the oil, seriously, then you only have to repair and rebuild, rebuild and upgrade, and the big bell big bell big bell, at least 1000 yuan.

Volkswagen turbocharged models burn engine oil is a common problem, if it is very serious Xianzhou, you can try to clean the throttle, replace the waste valve, if there is no obvious improvement in Kaisheng, it will have to be overhauled.

The engine of any model burns oil severely, then only overhaul is necessary. Replace the cylinder barrel piston rings. Re-grind to find the gap.

It should be a lot of engine oil, if this car burns engine oil, then hurry up to find the manufacturer, or find a four-s shop, and go and take a look. Is it possible to change the car? If He Shen can't change it, hurry up and repair it, it's not a good problem to have less, hey, this is also a big problem, so You buried and said to hurry up and find him to shoot the ants.

If you say that this is a very thin situation, then you can choose to go to the tank room to iron a post, which is very simple and simple, and then it is a matter of spending more money.

What else can I do if I change cars???

Summary. Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.

Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.

Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.

The large oil consumption is mainly due to the relatively large gap of the live destroyer plug ring in this engine, or the valve oil seal is caused by the pure question. If the oil consumption of 5000 kilometers is more than a blind liter, then this needs to overhaul the engine, if the oil consumption does not exceed one liter, then this is a slight oil burning, you don't need to deal with it.

Thank you. You are welcome.

I want to buy a 6-seater car. But only Sharon is suitable. I want to buy a 6-seater car.

But only Sharon ( check price |Car model detailer eggplant socks ) suitable. The third-generation EA888 basically does not burn engine oil, and the performance of all aspects is selected to hold the second-generation 888, you can refer to my post. Rest assured to buy 130,000 kilometers ago is no problem, come over 130,000 to start burning oil, now my car has traveled 190,000 kilometers, less than 1,000 kilometers to make up a liter of oil, plus 5w-40 is the same, engine design problems 380, the first shock more than 20,000 normal.

380, 30000 km normal wear 3805000 km oil is fine What model? **The engine does not burn oil, and the problem of oil leakage is gone. My car has run more than 7000 kilometers, no problem If you are 280 Sharon, I recommend you use the oil model I have above.

However, the EA211 engine is not a big problem. The 540 magnetic protection I use and the 280 must use the 4S 502A3 B45-40W Castrol EXTREME. @2019

The causes and solutions of Sharon's model burning engine oil.

1.The main reason for burning engine oil.

2.It is the problem with the fittings, the wastegas valve, the valve seal, the cylinder pulling the cylinder, and the cylinder pressure is insufficient.

3.It is a long-term unclean oil circuit, the antifreeze is not replaced in time, the oil service life is too long, the piston ring is stuck, and the more common situation is that the piston ring is stuck.

4.Solutions for burning engine oil.

5.To overhaul, maintenance of multi-person operation technology is not unified and assembly is not good, room temperature assembly engine hot and cold value is not enough, overhaul 1 to 40,000, vehicle depreciation 3 to 60,000, the disadvantages of overhaul, not a last resort, do not open the engine, after opening, there are traces of disassembly, the car instantly depreciates a lot, and the result of assembly is unknown, in the process of dismantling and assembly, the humidity of the air, constant temperature, low temperature are unable to meet the environment of dust-free workshop operation, plugging and assembly is carried out by many people, the craftsmanship is not the same, And assembly because of screws and other links can not ensure the stability of a machine, often the later volume of the car is unable to cost fuel, shaking and other phenomena are found, there is no serious pull cylinder do not disassemble the engine, after the overhaul 2000 kilometers to change a fully synthetic engine oil to two times in a row, plus to find a good road conditions to run in alone, 3000-5000 kilometers to complete the run-in, the cost of oil + gasoline is very high, the cost of ordinary car overhaul run-in is 2000 yuan. And once the police call the police, immediately call a tow truck,

Yes. There are two ways to solve the problem of burning engine oil

Overhaul. PNF restoratives.

Benefits of this one:In the case of overhaul, the cost is very high, the vehicle depreciates quickly, and the later run-in is also very troublesome. First of all, you need to find out the reason for your burning oil, oil circuit blockage, carbon deposits, piston ring stagnation can be repaired with PNF repair agent, there are many riders who have successfully repaired through PNF repair agent, you can refer to it.

Hello! Please go to the repair shop to check where the engine oil is burned!

Volkswagen Shalang burns engine oil seriously, in addition to the user often checks the oil balance to add oil, the individual can not deal with it, during the warranty period can only reflect the situation to the 4S store to request replacement, return, beyond the warranty period can only wait for the manufacturer to recall. Article 20 Within the validity period of the three guarantees for household automobile products, if the conditions for replacement and return of these provisions are met, the consumer shall replace or return the goods by the seller with the three guarantees voucher and the car purchase invoice.

Within the validity period of the three guarantees of household car productsIn any of the following circumstances, if the consumer chooses to replace or return the goods, the seller shall be responsible for the replacement or return:

1) A total of 2 repairs have been carried out due to serious safety performance failures, and the serious safety performance failures have not been eliminated or new serious safety performance failures have occurred;

If the warranty period is exceeded, you can only wait for the manufacturer to recallFor example, some imported 2012-2014 Sharan series cars produced between November 5, 2011 and March 15, 2014, totaling 20,472 units. Some vehicles within the scope of the recall may have increased contact resistance due to wear and corrosion of the contact surface of the fuel pump connector, resulting in overheating and failure of the plug on the inside of the fuel tank, which in turn may cause the vehicle to fail to start or break down while driving, which is a potential safety hazard. Volkswagen will replace the fuel pump caps and wiring harnesses for the fuel pumps of vehicles covered by the recall to eliminate the defects.

I switched to an oil-water separator and it was much better.

Reduce the power of the oil burner, and at the same time cooperate with cooling measures to ensure that its operating speed is within the normal range.

You should directly call ** to the official after-sales service to help deal with this problem, if the official after-sales service is unwilling to deal with it, contact ** to help come forward.

Volkswagen's other styles are like this, not just Sharon. It can be sent to the factory for maintenance, and the most direct way is to replace the engine directly. In this way, the serious problem of the oil burner can be solved.