The IR adapter can t be installed, why can t the IR adapter be used after installation

Add me Q and I'll send you a driver. 6513250: Yes.

Yes, your IR adapter is not compatible with your computer!

There is infrared setting in the control panel.

If the driver is installed correctly, it should be a hardware conflict, and you can press it when you boot it"del"Go to BIOS and find the relevant IRQ settings.

If your IR adapter doesn't work, follow these steps.

Enter " in "Run", then find a service called "infrared monitor", make sure the startup type is "Automatic", if it is "disabled", right-click on it, and set it to "Automatic" in "Properties"; Then in the "Dependencies" column of "Properties", you find that this service is dependent on the two services of "Remote Procedure Call (RPC)" and "Terminal Services", so please make sure that the startup type of "Remote Procedure Call (RPC)" is "Automatic" and "Terminal Services" is manual; Restart your computer.

Install the IR adapter driver and install the phone kit.

Follow the instructions to connect, and if it's still unsuccessful, I'm sure you've bought a fake IR adapter (rule out some miscellaneous issues, I think most of them do).

It may be a motherboard issue, some motherboards don't support infrared!

I've also encountered it, and other machines will work!

If you're using a laptop, it's that your IR adapter isn't turned on.

This is the case where you previously turned off the IR adapter, but you can still see it in Explorer!

Turn on the IR adapter in the BIOS and you're good to go.

This happened with my notebook.

I have this infrared device, and the driver that I use is from.

Reduce the rate to try.

Go directly to My Computer and open the Removable Disk to transfer files.

Turn your phone back on.

Mizuki has a compatibility problem with things.

That's right, it doesn't support drivers running in the environment of win xp, you need to go to the official ** to find a patch! After typing, restart the computer and drive it again!

The next driver wizard on the Internet, it's all done.

Unplug the IR ray and plug it back in a few more times, and then install it may be OK, the IR contact problem seems to be very bad, and I used to do the same.

Judging from the post replied above, if the infrared adapter costs 140 yuan, it is better to choose a Bluetooth adapter, which is not only cheap but also has a fast transmission speed. A Bluetooth adapter costs about 50 to 80 yuan.

Bluetooth driver is best to use the adapter comes with the CD, XP driver is not good,; The infrared adapter needs to align the two infrared signal ports and the distance is relatively short, if it is not necessary, it is not recommended

If the computer is an XP system, the system will generally automatically identify, if you can't identify it, you can install a driver, and you will bring a drive disk when you buy Bluetooth or infrared.

Adapter + driver, in addition, the infrared alignment distance should not be too short.

The easiest way is to run the setup program in the disc, if not, plug it in and find the driver to automatically scan the disc.

Infrared is like thatI don't have high technetium 7360The DKU-5 data used in the line dust argument is very easy to use. Maybe you have a problem with that adapter7360 is incompatible.