How to use the interior wall dotting instrument, I don t know how to use the interior wall plasterin

Generally speaking, there are three types of laser levelers on the market: blister laser leveler, automatic leveling laser leveler, and electronic automatic leveling leveler. It is mainly used for horizontal scanning or vertical scanning, and the general use method is as follows:

1. It is used for horizontal scanning.

Place the instrument on a tripod, on a stable flat surface, or on a wall. The instrument is basically upright, and the inclination should not exceed 5°.

2. It is used for vertical scanning.

Place the instrument on a stable flat surface with an inclination of no more than 5°.

If the instrument is improperly placed, or if the instrument is tilted more than 5° due to other reasons, the manual auto-leveling mode indicator and the laser beam flash at the same time, and the instrument should be relocated.

When using the laser leveler, the first thing to do is to turn on the power supply, that is, the battery, and then understand the function and use of the specific buttons, and then follow the instruction manual. In addition, the use of a laser scanner creates a plane and a straight line. If it is placed vertically, it will automatically produce a horizontal plane and a plumb line, while horizontal will automatically produce a plumb plane and a horizontal line, as follows.

Putty powder replaces the previous white cement, so most interior walls will now be made of putty powder, so will this be difficult to use? Steps for the use of interior wall putty powder: 1. Remove the dust on the original wall; 2. If there is a place where the skin is peeled, take a putty knife and clean it; 3. Pour the putty powder into the bucket and add an appropriate amount of water to dilute it into gelatinous putty;

The corner of the wall should be square, you must use more than five lines of infrared rays, play the cross perpendicular line, and measure it with a tape measure to make the distance from the relative perpendicular line to the corner of the side wall consistent.

When the plastering wall is made of ash cake, it is necessary to hang the line and pay attention to the axis of the opening, strictly control the thickness of the wall panel, and the axis of the opening is uniform, and the ash cake must be vertical, smooth, smooth and consistent, and the spacing of the ash cake should not be too large.

Interior wall plastering must pay attention to the wire box, behind the bathroom pipes, air conditioning outlets, exhaust holes, and behind the pipes must be plastered before installation, so that the pipes can be installed, and the surface is smooth and smooth.

The popular point is called the level, and the professional is called the laser infrared leveling instrument with a cross.

(Standard process of porcelain powder for hardcover apartment decoration).

One: It is necessary to vertically dot the infrared side of the wall, vertically cramp the square of a square square about a meter wide, and hang a net in the brick and concrete place. Then use the square square to level the leveling process. The wall surface of the door should be kept at the same thickness.

Two: Then measure the size of the door and window cover to place an order. The floor tiles are laid, and the top surface is a stone high slab shaped ceiling.

Three: scrape porcelain powder, stone high plate joints at the gap hanging net stone high leveling installation of yin and yang corner strips, yang angle strip is recommended to use aluminum porcelain powder special yang angle strip, so as not to be damaged, and then scrape porcelain powder, grinding, painting, brush latex paint is recommended to brush a bottom two times.

Head of Quality. Leng Fucheng: 18785706588