The specific meaning and grade classification of the mesh number of stainless steel polishing

The unit of measurement particle size refers to the size of the raw material particles, which is generally expressed by the maximum length of the particles. The mesh is the size that represents the mesh size of a standard sieve. In Taylor's standard screen, the mesh is the number of mesh holes in a centimeter (1 inch) length, or simply the mesh.

Taylor standard screening: The indexing of Taylor screening is based on the mesh size of 200 mesh, multiplied or divided by the square root of the main modulus (n 1, 2, 3......) to obtain a coarse or fine mesh size than 200, if the fourth power root of the number 2 (to the nth power to multiply or divide, you can get a finer series of mesh sizes.

The larger the mesh, the finer the particles. Similar to the magnification of metallographic structure.

The number of meshes, which is the number of holes, is the number of holes per square inch. The larger the mesh, the smaller the aperture.

1 mesh to 635 mesh, width 1 meter, meter, meter, meter, meter, 2 meters, meter, meter (mainly production of 150 mesh, 180 mesh, 200 mesh, 230 mesh, 250 mesh, 270 mesh, 280 mesh, 300 mesh, 350 mesh, 400 mesh, 420 mesh, 450 mesh, 500 mesh, 600 mesh, 635 mesh, special specifications can be processed and customized).

Stainless steel mesh specifications: width: 1 meter, meter, meter, meter, meter, 2 meters, meter, meter.

Mesh: 150 mesh, 180 mesh, 200 mesh, 230 mesh, 250 mesh, 270 mesh, 280 mesh, 300 mesh, 350 mesh, 400 mesh, 420 mesh, 450 mesh, 500 mesh, 600 mesh, 635 mesh.

It refers to the surface effect of 8k, 10k, 12k, the higher the grade, the better the surface effect, and the higher the **.

8K corresponds to 400 meshes, 6K corresponds to 320 meshes, 10K corresponds to 600 meshes, and 12K corresponds to 1000 meshes, all of which refer to the number of international high-precision meshes after the grinding of emery materials.

Generally, the brightness detector is divided into 2k, 5k, 8k, and 12k

It depends on what you're throwing around.

As long as you can buy abrasive materials.

or the tools you currently have.

If it's small, use our polisher.

Both water sandpaper and metallographic sandpaper will do.

Now there are two shaft grinding machines up and down, there are a lot of Yangjiang, replace the grinding wheel, or hemp wheel, nylon wheel, and then wax, you can grind any light you want, clamp the workpiece with a shelf, and clean it with wax removal water after grinding.

The larger the mesh, the finer the particles. Similar to the magnification of the metallographic structure.

The number of meshes, which is the number of holes, is the number of holes per square inch. The larger the mesh, the smaller the aperture.

Magnetism is also very different.