-
Titanium is about the same hardness as steel, and its weight is almost half that of the same volume of steel, and although titanium is slightly heavier than aluminum, it is twice as hard as aluminum. Now, in space rockets and missiles, titanium is massively used instead of steel. According to statistics, the amount of titanium used in aerospace navigation in the world every year has reached more than 1,000 tons.
Very fine titanium powder is also a good fuel for rockets, so titanium is known as a cosmic metal and a space metal.
Titanium has good heat resistance, with a melting point of up to 1725. At room temperature, titanium can lie unharmed in a variety of strong acids and alkali solutions. Even the most ferocious acid, aqua regia, cannot corrode it.
Titanium is not afraid of seawater, someone once sank a piece of titanium to the bottom of the sea, five years later to take a look, there are many small animals and seabed plants stuck on it, but there is no rust at all, it is still shiny.
Now, people have begun to use titanium to make submarine one - titanium submarine. Due to the fact that titanium is very strong and can withstand high pressures, such submarines can sail in the deep sea at depths of up to 4,500 meters.
Titanium is corrosion-resistant, so it is often used in the chemical industry. In the past, the components of chemical reactors that contained hot nitric acid were made of stainless steel. Stainless steel is also afraid of the strong corrosive agent - hot nitric acid, and every six months, this kind of parts must be replaced.
Today, titanium is used to make these parts, which are more expensive than stainless steel parts, but they can be used for five years on end, which is much more cost-effective.
In electrochemistry, titanium is a one-way valve type metal with a negative potential and usually cannot be decomposed with titanium as an anode.
The biggest disadvantage of titanium is that it is difficult to refine. This is mainly due to the fact that titanium is extremely capable of compounding at high temperatures and can be combined with oxygen, carbon, nitrogen, and many other elements. Therefore, care is taken to prevent these elements from "attacking" titanium, both in smelting and casting.
When smelting titanium, air and water are of course strictly forbidden to approach, and even the alumina crucibles commonly used in metallurgy are also forbidden to use, because titanium will take oxygen from the alumina. Today, titanium is extracted by interacting magnesium with titanium tetrachloride in the inert gas helium or argon. People take advantage of the strong compounding ability of titanium at high temperatures, nitrogen is easily dissolved in molten steel when making steel, and when the ingot cools, bubbles will form in the ingot, affecting the quality of steel.
Therefore, steelmakers add titanium metal to the molten steel, so that it is combined with nitride, and becomes slag - titanium nitride, which floats on the surface of the molten steel, so that the steel ingot is relatively pure.
When a supersonic aircraft flies, the temperature of its wings can reach 500 . If the wings are made of more heat-resistant aluminum alloy, one to two or three will be unbearable, and there must be a light, tough, and high-temperature resistant material to replace the aluminum alloy Acetitanium, which can meet these requirements. Titanium can also withstand the test of more than 100 degrees below zero, and at this low temperature, titanium still has good toughness without brittleness.
By using the strong absorption power of titanium and zirconium to absorb air, the air can be removed and a vacuum can be created. For example, a vacuum pump made of titanium can pump air to 1/100,000,000 left.
-
The attributes of the two knives are exactly the same Don't buy a titanium short knife It's a pit Right-click unless you hit the head Otherwise you can't die It's the same as an ordinary knife.
-
Nitinol wire can be shortened when energized, and restored when power is off.
-
I don't think there's a metal that shortens when electrified!
1. The wire will heat up after being energized for a period of time, and it will elongate due to the heat expansion and cold contraction.
2. The wire is wound into a compass, and the solenoid will be shortened by the rule of the right hand, 3. Some non-metallic crystals, metal oxides, salts, polymers, etc. will be strained in the electric field, which is called magnetostrictive effect.
Is it confirmed that it is metal? How much can it be shortened? How much contraction? Curious :) How did you get it? I just need some electrostrictive material and I just can't find it!
-
Metals are basically electrified.,Although a very small part of it is weak.。。。
-
Titanium is a metallic element, gray, with a melting point of up to 1668 4 . The density of titanium is grams per cubic centimeter (20), titanium is not magnetic, and titanium can be turned by temperature or voltage changes.
The surface changes into colorful, and the plasticity of titanium is also very good, and various shapes can be processed. It can be burned in nitrogen and has a high melting point. Blunt titanium and titanium-based alloys are new structural materials, mainly used in the aerospace industry and aerospace.
Maritime industry. Titanium can effectively prevent the erosion of weak acids, so titanium heating wire has a certain anti-corrosion function, which is suitable for weak acid corrosive liquids.
Because titanium is a new type of jewelry material, and it is "biophilic". In the human body, it can resist the corrosion of secretions and is non-toxic, and is suitable for any sterilization method, and will not cause any harm to the human body in contact with **. The above information**Yancheng Yuheng search on the Internet, about titanium heating wire related questions can be directly added or searched.
-
Divalent titanium ions can displace hydrogen in acid, so titanium metal cannot be precipitated in aqueous solution, and hydrogen in water preferentially gains electrons to become hydrogen.
-
Because titanium is relatively stable and not easily obtained by electrolysis, there is no way to achieve frozen storage.
-
Titanium alloy is widely used in the aviation industry, aerospace industry, shipbuilding industry and other aspects due to its advantages of low density, high specific strength and specific stiffness, and good corrosion resistance. Compared with other ordinary welding technologies, laser welding has the advantages of high energy density, good weld forming, simple operation and high production efficiency. Titanium alloy material has high chemical activity, and is easy to react with oxygen, hydrogen and nitrogen in the air under high temperature conditions, reducing the mechanical properties of the weld, and the protection of the high temperature zone of the weld is the key problem to be solved by titanium alloy laser welding.
The existing titanium alloy laser welding device has a complex structure, and the protection device must be close to the surface of the sample to be welded, which has its limitations in application. In addition, according to the characteristics of laser welding, the spatter and smoke gas produced in the laser welding process are easy to pollute the focusing lens, in order to protect the focusing lens, the splash and the smoke must be blown away by the transverse air curtain nozzle, the existing transverse air curtain is mostly straight pipe or narrow slit form, this structure nozzle blows out the airflow velocity is low, can not effectively blow off the spatter, and because the negative pressure area is formed after the airflow is ejected simultaneously, the disturbance of the air around the welding area is caused, the air is rolled into the welding shielding gas, and the welding effect is affected. In this paper, the mass and movement velocity of the spatter particles generated in the laser welding process are studied by using high-speed camera and other experimental methods, and the minimum air velocity is close to the speed of sound is calculated to blow the spatter particles.
The schlieren experiments show that the gas blown out of the air curtain is a straight laminar flow, and the influence range of the air flow is small. Laser welding experiments show that the design of supersonic transverse air curtain can effectively blow out the spatter particles and realize the protection of the laser focusing lens. According to the welding heat transfer and combined with the high-speed camera to observe the process of laser welding of titanium alloy, the protection range of high-temperature weld of titanium alloy laser welding was estimated, and the structural size of titanium alloy protection nozzle was determined.
The design titanium alloy laser welding protection nozzle is composed of the main protection nozzle and the additional protection nozzle, the main protection nozzle blows out gas to control the plasma generated and the welding molten pool during the laser welding process, and the additional protection nozzle blows out the gas to protect the high temperature area of the weld. The gas flow regime of the nozzle with different gas flows is studied by the schlieren instrument, and the protective gas of the main protection nozzle and the additional protection nozzle are laminar flow, which will not interfere with each other, and the laminar flow length can reach 25mm. The experimental results show that when the laser power is 3500W, the welding speed varies from 2m min to 6m min, and the nozzle is less than 10mm away from the welding specimen, the well-protected weld can be obtained by adjusting the shielding gas flow.
-
Any source that can produce the same electromagnetic wave can produce electromagnetic interference, and the higher the frequency, the greater the interference. Although titanium alloy material does not interfere with electromagnetic waves, it is a metal that will still hinder the transmission of electromagnetic waves.
-
Theoretically, when a person is exposed to a very strong magnetic field, the person's brain waves are disturbed by the outside world, and unexpected behaviors or thoughts can occur.
If you agree with my answer, please adopt it in time, if you agree with my answer, please click the [Accept as satisfactory answer] button in time Friends who ask questions on their mobile phones can comment on [Satisfied] in the upper right corner of the client.
Your adoption is what keeps me going.
-
Under normal magnetic field conditions, no. The magnetic field is abnormal and will interfere because it is a conductor material.
-
Titanium alloy materials interfere with electromagnetic waves. As long as it is a metal material, it interferes, and electromagnetic waves are only strong or weak.
-
Titanium gold will not interfere, aluminum alloy because of the fast electromagnetic conductivity, the research of Dongyou update too fast, social development is getting better and better
-
It does not interfere with electromagnetic waves, and titanium alloy does not induce magnetism.
-
Among the mid-to-high-end outdoor watches, the one that has been selling more recently is the Casio Mountaineering series. You can start with 5,000 yuan, which is fully functional and fashionable in appearance, which is very suitable for young people to wear. Casio PRW-7000FC-1B is the first to be used, with a third-generation triple sensor, using a six-bureau radio wave and solar system to increase range and improve measurement accuracy.
-
No one can say these things well, but I still remind you that it is recommended to go to a third-party platform and not to trade online privately. Especially send a collection store, merchants and the like don't believe it. Either trade offline or go through a third-party platform.
No one can say these things well, but I still remind you that it is recommended to go to a third-party platform and not to trade online privately. Especially send a collection store, merchants and the like don't believe it. Either trade offline or go through a third-party platform.
-
Iron, copper, aluminum, cobalt, nickel, titanium, gold, silver, magnesium.
In fact, it is a metal, and the principle is similar to that of electrostatic shielding, which can weaken the change in the electric field.
Among them, iron, cobalt, and nickel work better because they are not only able to conduct electricity, but they are also ferromagnetic, which is able to conduct magnetism.
-
Interference deliberately used to achieve a certain purpose, such as electronic countermeasures, is beyond the scope of this article. Any electrical and electronic equipment is subject to human interference. Here are just a few common sources that interfere with the measurement environment.
1) Radio transmission equipment: including mobile communication systems, radio, television, radar, navigation and radio relay communication systems.
-
When I got home, I felt that I should hurry up and hurry up the password, right?
-
When there is no electrical appliance, the circuit is disconnected, and when there are electrical appliances working, it is in the path, and the normal Jingshi path is also a safe loss, but if there is an electrical short-circuit, it will cause the circuit to be in the path and the resistance is very small, and the current is very large, so it is very dangerous.
Summary. Hello, the golden bear will not die if it eats cold egg whites. Especially in the summer when it is hot, it is cold and cold, and animals like to eat it. >>>More
In the hot weather in summer, in order to prevent the golden bear from heat stroke, you can lay cat litter or corn cob in the cage as bedding, among which the tofu cat litter is more recommended, it is highly absorbent, non-sticky hair, and the touch is cooler. If the economic conditions of the breeder are better, you can also place a marble Kai group for the golden bear to cool down. >>>More
A: No.
Humanity will not become extinct because of the spread of the novel coronavirus. Throughout the history of human development, it is a history of constant struggle against various diseases. Smallpox, a virulent infectious disease, has been basically eradicated, and plague, cholera, and other virulent infectious diseases have also been effectively controlled. >>>More
First of all, I wish you a speedy **!
If he wants to propose a breakup, there is no way to do it! I hope you don't get too sad! Because this thing cannot be forced! >>>More
Cervical spinal cord injury due to the lack of delayed spastic painful paraplegia, early onset of Western medicine, early Western medicine surgery, only restored the diameter of the spinal canal, so as not to damage the nerve again, and completed their mission, but the damaged nerve is still in a state of paralytic shock and can not be recovered. In addition to self-repair, the recovery of its nerve function can be carried out with this scheme**, if the damaged nerve is secondary to ischemic degeneration due to too long, there is no hope of recovery of the disease, and it will become spastic paraplegia and severe muscle atrophy. **Scheme 1: Use traditional Chinese medicine to enhance and improve spinal cord blood circulation, so that the damaged nerves can get sufficient blood supply. >>>More