Help: My internet speed is limited by software, please crack! 15

It's telecom itself that is idle. Restrictions set on Telecom's own linked servers. It's hard to crack.

You should have wired internet, right? If yes, then your bandwidth should be 2m, **speed is about 150-250k, but from what you said, it is not the telecom speed limit, because the telecom speed limit is according to the 2m speed limit, Xunlei** should be about 200k (if the resources are good), there will be no frequent drops and other problems, your current problem I think the possibility of line problems is very high, it is recommended that you call 10000** to report the fault, just say that the total drop, it will drop once in a few minutes, and you can't access the Internet normally, Generally, within 24 hours, there will be line personnel to come to your door for testing and processing. Another point is anti-virus (of course, the possibility of a virus causing it is very small).

If it's wireless Internet access, it depends on what you are**, there is no limit to the amount of traffic but to limit the hours, such as: 80 packs of 90 hours (unlimited traffic), limited traffic** (time limit), there is also a limit to the flow of time (such as 50 packs of 100 hours or 15g), no matter what, as long as you are in**, it will not limit your speed, one case, that is, after exceeding** how much traffic will be given disconnection, you check whether it is this problem. If this is the case within **, there are a few points to note:

1. Is the signal very unstable recently, because sometimes there is a problem with the base station equipment. This point can be determined by paying more attention to the number of signal grids of the network card. 2. If there is a problem with your wireless network card, you can find someone else's wireless network card, remove your original driver, and install the driver of someone else's network card to try it (it is best to use the Huawei brand network card, stable!).

Another point is that as the number of users increases, the Internet speed will definitely be slow during peak hours (6 pm to 10 pm), so you should check it at other times first. If the above is okay, then call 10000 to complain.

No, there are other channels, but I believe that number 10000 will solve it for you.

As for the restrictions you mentioned, it should be based on the network access agreement or ** standard, if your agreement or ** is like that, then there is no need to say, if not, then complain. You will win.

Hope it helps.

That's not a limit, it's **software when you click** select **location start**, so when you click OK, it's already **some **software detects that when you click OK, it's already 20m, a second later, it's 22m, it will display 22m s, and then 2 seconds when it's 24m, it will be divided by 2 seconds to calculate, and it becomes 12m s, so it slowly becomes 220k s, and your actual **speed is fixed, generally speaking, the bandwidth you handle is a few m**speed It's about a number divided by 10, so a 4m broadband is 400k s.

In this case, please analyze and solve it from the following aspects:

To keep your computer normal, free of viruses, malware, etc., it is recommended to use 360 regularly

Tools such as Guardian and Kingsoft Guardian clean up system garbage and temporary files generated by surfing the Internet (ie

caching), detect and kill malware. Restart your computer when you're done.

The cat has been open for a long time, it is very hot and hot, it is recommended.

Try to place the cat in a ventilated place and not overlap the router. So as not to be too high, otherwise there will be a fake crash, restart the cat is better, it's really not good.

It is recommended to change to a cat with good performance (I called the telecommunications to go to the telecom, and changed it for free).

Several computers share the network, and because the router is too poor, others use P2P

Watching movies, etc., will drag the router to death, restarting the router will be better, the long-term solution is, it is recommended to change to a better enterprise-level router.

Modify the IP to static settings to avoid slow boot of the computer

After the lease expires, the IP address cannot be configured and the network is disconnected.

Someone on the network has installed and used the speed limiting software, so it is recommended that you enable it.

ARP firewall (360 has ARP protection).

It is recommended to manage the boot startup items and stop the useless startup items, especially those that are not used.

Look**、**The software runs in the background when it is booted, accounting for the network speed. Start - Run - Enter msconfig - OK - Click "Start" - Start in the "System Configuration Utility" window.

Except for the input method (CTFMON) and anti-virus software, general programs can be turned off. You can also use 360 and other software to intelligently optimize boot acceleration.

It is recommended to install only one main antivirus software, as installing multiple will take up computer resources, which will make the computer slower and the Internet will feel slow.

2.Click All Tools - System Tools - LSP Repair;

3.After opening, click Restore to the previous state, then click Automatic Repair, and then restart the computer when you are done.

3.Again, check the computer settings, open the computer network properties, and set to automatically obtain IP address and DNS

1. Install P2P Terminator software to limit the speed of other users, and improve your own speed.

2. If someone secretly installs P2P software in the intranet, then it will not work on the previous step, and anti-P2P software should be installed.

3. If the above two situations are not the same, then the restriction must be on the router, and the number of should be set by logging in to the router operation interface. (More professional, don't go in if you don't understand).

4. Poor contact of the first line may also cause the fault of poor network, it is recommended to go to the computer room to reconnect the first line and the connector of the router.