What s going on with the Cadillac Escalade s elevated idle?

1. General spark plug problems will lead to poor engine work, such as difficult starting, unstable idling, poor acceleration, urgent refueling and tempering, excessive exhaust gas, and increased fuel consumption. If the carbon deposition in the engine is serious, the valve will not be tightly closed, so that a cylinder will not work completely because there is no cylinder pressure, and even stick the valve to prevent it from returning. At this point, the valve and piston will interfere with the movement, which will eventually damage the engine.

It can be seen that the impact of carbon deposits on the engine is very large.

Second, the solution.

1.When unplugging the high-voltage wire joint, it should be gentle, and the spark plug insulator should not be shaken vigorously during operation, otherwise the spark plug sealing performance will be damaged.

2.The engine can be disassembled only after cooling, when the spark plug to be removed is loosened, blow the dirt around the spark plug one by one with a thin hose, and the dirt falls into the combustion chamber after the spark plug is unscrewed out.

3.The screw area, spark plug electrode and gasket must be kept clean, dry and free of oil stains, otherwise it will cause leakage, air leakage, spark weakening and other failures.

4.When installing, first use the sleeve to align the spark plug with the screw hole, gently screw it in by hand, screw it to about 1 2 of the full length of the thread, and then tighten it with an afterburner lever. If the hand feeling is not smooth when twisting, you should exit to check whether there are any entrained impurities in the screw mouth or thread, and you must not blindly tighten it, so as not to damage the screw hole and affect the cylinder head, especially the aluminum alloy cylinder head.

5.It should be tightened according to the required torque, too loose will cause air leakage, too tight will make the gasket lose elasticity, and it will also cause air leakage. Since the tapered spark plug does not use a gasket, it is particularly important to comply with the tightening torque.

6.When the carbon deposit and oil accumulation on the spark plug are not very serious, you can soak it in gasoline or kerosene and acetone solvent, and after the carbon deposit is softened, brush the carbon deposit on the electrode and the porcelain core and the cavity of the shell with a non-metallic brush, and dry it with compressed air. After cleaning, the spark plug is checked for clearance.

3. Preventive methods.

After completing the above, the installation test will be carried out, and the owner will be reminded to do regular maintenance to keep the oil and gas circuits clean; It is recommended to clean the air grid every 4000-8000km (according to the use of the vehicle and the actual situation) (replace it according to the actual situation), clean the throttle once, and clean the fire nozzle; Every 15,000-25,000km (according to the use of the vehicle and the actual situation), clean the intake pipe, throttle combustion chamber and related oil circuits, check the gasoline grid and replace it according to the situation; Avoid idling and stopping for a long time, avoid turning off the engine immediately after high-speed driving, avoid high-speed driving immediately after starting, and avoid low-speed gear shifting.

Idle shaking, difficult starting, high idle speed, and excessive exhaust gas are all problems such as carbon deposition caused by poor combustion, and must be cleaned. It's a bit normal, just don't do it for a long time, because this will cause serious carbon deposition in the long term, resulting in a decrease in engine performance. It is best to adapt to 10,000 kilometers of fuel additives, so that there will be no idle instability.

Hello, it is recommended that you go to the 4S shop to check or the big repair shop to check, I hope to help you, hope!

My car is a 07 Cadillac Escalade, the engine always shakes badly at idle, the throttle and spark plugs, high-voltage wires, chicken feet are replaced and cleaned, and the car's idle motor is on the throttle cooker. It is mainly used to bear the idle speed of the car, and its purpose is to adjust the idle speed according to the engine load at the time of idling, and the idle jitter can check the pointer fluctuation of the idle speed meter, and the general performance is not good combustion, if it is a new car, there will be no problem of damage to the idle components, because the combustion requirements of the turbo direct injection vehicle are very engaged, or clean the oil circuit first, before the idle pointer fluctuation idle jitter in the fuel tank after adding the Si Youpu fuel additive to run two tanks of oil is completely good.

Cadillac Escalade Idle Rise, Idle Jitter High idle speed is not a problem with accessories, the problem comes from poor combustion, which will cause such a phenomenon. The oil circuit can be cleaned, and the gas station also regularly cleans the oil storage tank, not to mention the fuel tank of the private car. The oil circuit of the fuel tank is dirty, and if it burns badly, it will miss the post and catch fire.

Cadillac Escalade idling speed increase High-speed cleaning of carbon deposits:::Gear at 1 when running for 5 minutes, 40 mph, 3 when 90 mph 10 minutes 4 when 120 mph 15 minutes total, can only clean the keratin of the fuel injector can not remove carbon deposits. It will also increase carbon deposits.

Running at high speed can only clean part of the gum, can not remove carbon deposits, to thoroughly clean can only rely on fuel additives is the most convenient, no matter how to use it is burning, it is impossible to avoid carbon deposits. Regularly clean the oil circuit, only this one way, I used to idle the car shaking, the exhaust pipe was black, the master did not check the problem and finally said that it may be carbon deposits, add me 2 Si Youpu fuel additives poured in the fuel tank, ran two sesame oil, it was very smooth. The exhaust pipe is now metallic, which I think is caused by carbon deposits and dirty oil circuits.