The satellite dish can t receive the station, urgent!

FTA-3000 is a paid low-end receiver used by Yihua to receive the KU beam of the APSTAR-5 satellite at 138 degrees east longitude. If there is no signal quality, it means that the satellite is not aligned, and the azimuth, elevation, and polarization angles of the antenna should be adjusted according to the latitude and longitude of your location. Use a group of Great Wall 12535 vertical 41250 or a group of 12354 vertical 43000 in Hong Kong to find stars, if there is still no image after the signal quality, it is likely that there is no cost, you should contact the dealer.

Look at your introduction should be a small pot to receive the Zhongxing 9, the signal strength is there, the signal quality is not, it should be that the pot is not aimed at the satellite, you must first carefully check the cable, the outer shield must be completely connected with the f head. To receive a satellite, the triangle in it, i.e., the azimuth angle, elevation angle, and polarization angle must be completely correct (if it is a Zhongxing-9, because it is a circular polarization signal, the polarization angle does not need to be considered).

In addition, you said that you have received a lot of satellites, is it not possible to have a dual-mode machine? In the case of the Zhongxing 9 special machine, it can only be used to collect the Zhongxing 9, and the basic local oscillator frequency is also fixed. But if you use it to collect other satellites, you need to change the corresponding local oscillator frequency to receive the signal.

I've been doing satellite TV for ten years.

You have to change the local oscillator frequency in the antenna settings to 11300, or the antenna is not tuned.

1. It's not a small pot of 9, because the 9 is only 35 cm, and the pot is too big and wasteful.

2. After installation, the signal strength shows 96%, which just means that you have connected the line and there is no problem with the high-frequency head.

3. One thing to note is that a small pot of 45 cm will not be able to receive 6.

4. Do you want to confirm which star to receive? The small pot can receive 1082 138 134 146 75, of course, you can also receive the middle nine, but the machine is different.

5. Enter the parameters to receive the star, and then go up and down, left and right, and swing until the signal quality of the receiver is above 30%, or the indicator light is green, and that's it.

6. Restore the receiver to factory settings.

8. To add that the local oscillator parameter is 11300, not 5150.

Reason:

1. In case of rain, snow or fog, it can be recovered after the weather improves.

2. There is water and snow on the surface of the satellite antenna.

3. Before and after the spring and autumn equinoxes, due to the influence of the sun on satellites, it is sometimes impossible to watch at noon.

4. The antenna is crooked or there is a shelter in front of the antenna.

The common reasons for the large clutter of the receiving satellite program are:

1. The receiving antenna is not aligned with the satellite, so that the signal is too weak. You should first adjust left and right to find the position where the image is best and the clutter is the smallest, and then move it up and down to fix the position where there is no clutter.

2. The frequency drift of the high-frequency head causes the intermediate frequency signal to drift, and the amplification decreases a lot. The frequency of its local oscillator should be adjusted so that the clutter disappears.

3. In heavy rain, heavy snow, and foggy weather, the signal (especially the Ku-band) is attenuated. It will return to normal after the rain and snow have passed.

Summary. Possible reasons why the satellite TV suddenly cannot receive the station: 1. The signal cable plug connecting to the set-top box is loose or has fallen off.

Solution: Reconnect the signal cable to restore the signal. 2. The lid of the pot is shifted in the direction of the satellite.

Solution: You need to adjust the position of the lid of the small pot accurately. 3. There is an obstacle in the direction of the satellite where the lid of the pot is aligned.

Solution: Remove the obstacle so that the direction of the lid is kept open, and there should be no obstruction. 4. The signal demodulator of the set-top box is broken.

Solution: Ask a professional to replace the signal demodulator. 5. The high-frequency head connected to the antenna is broken.

Solution: Replace a high-frequency head that can be used normally.

Possible reasons why the satellite TV suddenly cannot receive the station: 1. The signal cable plug connecting to the set-top box is loose or has fallen off. Workaround:

Reconnect the signal cable to restore the signal. 2. The lid of the pot is shifted in the direction of the satellite. Workaround:

It is necessary to adjust the position of the lid of the small pot accurately. 3. There is an obstacle in the direction of the satellite where the lid of the pot is aligned. Workaround:

Remove the obstacle so that the lid is left open and there should be no obstruction. 4. The signal demodulator of the set-top box is broken. Workaround:

Let the professional master replace the signal demodulator. 5. The high-frequency head connected to the antenna is broken. Workaround:

Replace it with a high-frequency head that works normally.

There is strength but no quality.

I just bought how to install it yesterday.

1.There is signal strength. The line is connected correctly.

2.There is no signal quality. Indicates that the pot is not aligned.

Please fine-tune the pot and high-frequency head up, down, left and right. 3.If it was bought near your home.

When I went back, I put the pot in the same direction. Then turn left and right in the direction should be adjusted. If the place where it is sold is far away from your home.

There are two points that should be paid attention to when adjusting the pot. One is that if the north and south are far apart. You have to readjust the elevation angle.

Because satellites are located over the equator. The elevation angle increases to the north. The elevation angle to the south decreases.

Second, the distance between east and west is relatively long. If it was bought in Chubu. To the west and east, adjust the azimuth.

It's like an actor performing on stage. Those on the left should look to the right. Those on the right should look to the left.

Because satellites are relatively stationary over the equator. Specifically, the elevation and azimuth angles of the satellite pot are different according to the geographical location. Hope the answer is helpful to you.

There can be a variety of reasons why a satellite dish can't receive a Taiwanese TV show, and here are some possible reasons for Enga:

1.Installation orientation deviation: The satellite dish needs to be accurately facing the satellite. If the installation is not accurately pointed at the satellite, it will lead to a decrease in the quality of signal reception, or even no reception.

2.Weather Impact: Sometimes the weather is bad (such as high winds, heavy rain, thunder, etc.), or in certain weather conditions, the signal transmission will be disturbed.

3.Weak signal: Make sure the satellite dish receives a strong enough signal. If the signal of the satellite is weak, it will lead to poor reception of the TV signal.

4.Satellite issues: Faulty satellites or other issues can also cause signals to not be received.

5.Problems with receiving equipment: If the satellite dish is aging or the receiving TV equipment is malfunctioning, the signal may not be received.

It is recommended that you first check and adjust the direction and angle of the satellite antenna, check whether the equipment and cables are installed correctly and tightly connected, try to receive the signal in good weather, and check whether the sail behavior of the home satellite receiving equipment is normal, and it is recommended that you contact professional maintenance personnel to assist in solving the problem.