Why is it easy to dry the soil of high rise buildings in planted pots?

Updated on society 2024-07-29
20 answers
  1. Anonymous users2024-02-13

    The main reason why the soil is easy to dry is that the wind speed here is relatively large, the sunlight is relatively sufficient, and the water evaporates quickly. In summer and autumn, potted plants placed in the open air are watered more and more frequently than potted plants placed indoors.

  2. Anonymous users2024-02-12

    What is a bonsai? It mainly depends on the characteristics of potted plants, like yin and yang, like drought or moisture, each type of potted plant has different characteristics, and it is necessary to find the reason more specifically.

  3. Anonymous users2024-02-11

    Gardenias like wet and good fertilizer, and are estimated to be dry or iron-deficient.

  4. Anonymous users2024-02-10

    Put the pot in the tray, add some water to the tray, and let the bottom of the pot soak in water for a long time.

  5. Anonymous users2024-02-09

    Are you sure you have drainage holes at the bottom of your pot and it's not blocked?

    The dipping method is a method of watering plants. This method is to put the plants into a tray or a shallow pot without holes, and let the water slowly seep into the pot from the bottom of the drainage hole at the bottom of the potted flower until the topsoil on the surface of the pot is moist, and then the potted flowers should be taken out immediately.

  6. Anonymous users2024-02-08

    You have too little water to soak in the basin. Because the newly installed soil is relatively loose, it does not form a capillary to transport water upwards, and the water at the bottom cannot be transported upwards, so the upper part is dry. The solution is to let the water flood more than half of the basin. Hope you can adopt thanks!

  7. Anonymous users2024-02-07

    The water level must be higher than the mud surface.

  8. Anonymous users2024-02-06

    When planting flowers, it is best to put clay in the lower layer and sandy soil in the upper layer, so that the water will not stay in the upper part when watering, but will seep into the roots of the plant.

  9. Anonymous users2024-02-05

    A layer of small pebbles is placed at the bottom, sand is placed on the stone, and soil is placed on the sand. And judging from your introduction, you plant shade-tolerant plants and keep them indoors all the time, otherwise you won't only water them once a few days. Plants are always rotten, you think it's the cause of waterlogging, but in fact, there is another reason, it's a lack of light.

    No matter how shade-loving plants are, they should not be placed indoors for a long time, and they should often be moved to the balcony to see some strong light (do not bask in the sun), otherwise it is not only easy to rot the roots, but also the branches and leaves will not grow well. Mild cases suffer from poor growth and severe cases of death.

  10. Anonymous users2024-02-04

    1. Put more permeable broken tiles or briquettes at the bottom of the pot.

    2. If you can find the whole tile, cut it into three pieces and insert it into the basin along the wall of the basin, which can not only adjust the moisture but also enhance the air permeability.

  11. Anonymous users2024-02-03

    Mix more sandy soil, crushed briquettes can also be (soaked into soil), so that the drainage permeability is good.

  12. Anonymous users2024-02-02

    A small flower pot is upside down to make the bottom empty, which is lighter to move and more breathable.

  13. Anonymous users2024-02-01

    Buy two bags of Junzi Orchid nutrient soil and mix it with your current soil, and you won't be afraid of waterlogging when you plant any flowers.

  14. Anonymous users2024-01-31

    First, put a layer of water-insoluble blocks at the bottom of the pot, (such as styrofoam, large vermiculite, etc.), which accounts for about a quarter of the height of the pot. Then put a layer of four-eye-thick slag, fill the coarsest part of the nutrient soil on top, and then put flowers to fill the soil.

  15. Anonymous users2024-01-30

    The soil is too hard, so you have to turn it over from time to time, and it is best to put some dead leaves before sitting on the soil.

  16. Anonymous users2024-01-29

    The soil is too hard, and you will find that the soil is sticky after watering, impermeable and not breathable, and the soil should be mixed with some particles or small stones, so that the soil is permeable and the plants can grow well.

  17. Anonymous users2024-01-28

    The soil is oily, and even if the soil is very soft, it will not be poured into it, and it will float on the surface.

  18. Anonymous users2024-01-27

    Watering do not wait until the potting soil is completely dry, or even dry and cracked before watering, the surface of the potting soil can be watered, and watering must be watered thoroughly.

    It is recommended that the first two or three times of watering can be used to soak the pot (of course, the pot is not too heavy), that is, the pot is soaked in water, soaked in about two minutes.

  19. Anonymous users2024-01-26

    Put the pot in the water and wait for it to slowly suck the water up, and wait until the soil on the surface of the pot looks damp before taking it out, and often do this so that the soil will not crack, and drought-tolerant plants will forget it.

  20. Anonymous users2024-01-25

    What kind of mud is used? The one on the 1st floor is too general.

    People who are new to growing flowers generally go to the flower shop to buy nutrient soil, which is the prepared soil.

Related questions
10 answers2024-07-29

First of all, the public share is large. High-rise real estate, because the overall total construction area is too large, and the public area is also relatively large, which leads to the shared area of the house. >>>More

3 answers2024-07-29

There may be several reasons for the abnormal noise of small high-rise floor slabs: >>>More

13 answers2024-07-29

You can buy it on every floor.

Real estate is the name of a property when buying and selling real estate in Hong Kong, and a real estate can be a unit, a building or a housing estate; Even a piece of land, a parking space, off-plan **, etc. The information of the property includes square meters of floor area, decoration, view, number of floors, location, price, number of rooms, clubhouse facilities, and even utility rate. The information stated above may not be required by law, and misrepresentation may be possible. >>>More

13 answers2024-07-29

You can buy it on every floor.

Real estate is the name of a property when buying and selling real estate in Hong Kong, and a real estate can be a unit, a building or a housing estate; Even a piece of land, a parking space, off-plan **, etc. The information of the property includes square meters of floor area, decoration, view, number of floors, location, price, number of rooms, clubhouse facilities, and even utility rate. The information stated above may not be required by law, and misrepresentation may be possible. >>>More

11 answers2024-07-29

When it comes to several layers of good air, I first want to talk about a concept, that is, the so-called "ash layer" that everyone often considers when buying a house, and it has been rumored on the Internet that "9 to 11 floors are ash layers, and you can't buy them", in fact, this statement is wrong, whether it is PM10 "ash" particles, the closer to the ground floor, the higher the concentration. Physics experts say that at a height of thirty or forty meters above the ground, the dust does not stop. Therefore, now the general high-rise buildings do not have a gray floor, it is recommended to choose a floor, try to choose a floor that suits you. >>>More