What should be paid attention to during the run in period of Wuyang Honda scooter new Youyue 110

The speed is not 40, it is best to carry only one person, pay attention to changing the oil.

Five sheep Honda scooter new superior 110 run-in period precautions:

1) Long-distance driving: When driving for a long distance during the run-in period, it is necessary to pay due attention to the "rest" vehicle, and at the same time, the owner can also relax and avoid fatigue driving. When driving long distances, the power works continuously for a long time, which can easily lead to irregular or abnormal wear of new parts of the engine.

Proper "rest" can "deload" the engine.

2) Do not overload the vehicle: If the vehicle is fully loaded or overloaded during the run-in period, it will cause a certain degree of "damage" to the chassis and engine. It is recommended not to drive with full load or even overload within the first 1000km.

3) Do not brake urgently: If you brake urgently during driving, it will not only impact the braking system during the run-in process, but also increase the "shock" load on the chassis and power of the vehicle. It is advisable to maintain a certain speed within the initial driving distance of 1000km and avoid frequent use of emergency braking (except in emergency situations, of course).

4) Don't drive at high speed often: there is a certain speed limit during the run-in period, refer to your own manual, pay attention to the "tachometer and speedometer" of the engine when driving, and ensure that it is proportional to the engine speed within a certain speed range (refer to the manual). Refer to the following recommendations (Common Criteria only):

a. Initial 1 1 1000km, generally 70 80km h or less, the speed should not exceed 2200 rpm.

b. The maximum speed of 1k-2km can be appropriately increased, generally between 90 and 100km h or below, and the engine speed is about 2500rpm.

The speed (maximum) after km 5 km can be controlled between 110 km h and 120 km h or less. The rotational speed is around 3000 rpm.

The run-in period is 500 kilometers, no more than 60 yards.

The light riding Suzuki Lezhi 110 is carburetor, while the Wuyang Honda Youyue 110 is EFI, which is better in this regard, but the power Leyue 110 is stronger, the ground clearance is also higher, and it is more suitable for manning and hilly areas. In fact, for the most advanced technology, there is no obvious difference between EFI and carburetor in the use, and most of the current motorcycles using EFI are due to environmental protection requirements, and the carburetor car is still more convenient in terms of maintenance and maintenance, and the cost is lower. Lezhi's ** is also lower than Youyue, the fuel consumption of the two cars is actually about the same, and Lezhi's models and engines are updated.

Light riding Suzuki does not have a "Jiacai 125" scooter, now there are only Ruicai, Licai and Fengcai, the power of Lezhi is basically the same as the 125 pedal, of course, it must be 125, and the power is still slightly stronger.

Under normal circumstances, the weight capacity of the scooter is not very strong, and the design is just right for two-wheeled riding, and it is not suitable for any pedal to carry three people. The quality of these cars is relatively good, there will be no major problems in normal use and maintenance, there is no need to worry about the quality, but it must be maintained according to the regulations, especially do not use the best unknown oil and oil filter element, maintain the air filter on time, and drive in the right way.

Due to processing and assembly errors, the frictional resistance of the moving parts of the new car is always much greater than normal when it starts to run, and the running-in (also known as walking) effect in the early stage of the car will have a great impact on the service life, working reliability and economy of the car. Therefore, the run-in regulations must be strictly implemented when using new cars.

1. Run-in regulations for new cars within 1000 kilometers:

1) Never drive at full speed.

2) - Generally not to drive at a speed of more than 100 km/h.

3) Avoid driving at high speeds in all gears.

2) The run-in of the vehicle between 1,000 and 15,000 km: it can be gradually increased to the maximum speed or at the maximum permissible speed of the engine.

2. After the run-in period, attention should be paid to:

1) When driving a car with a tachometer and shifting into the approaching high speed, the maximum engine speed allowed for a short time is 5 500 rpm when the pointer reaches the red indication zone at the latest. The maximum permissible speed in each gear is 40 kmh in the first gear, 65 kmh in the second gear, 100 kmh in the third gear, 135 km/h in the fourth gear, and 165 kmh in the fifth gear.

2) Avoid running the engine at unnecessarily high revs, and switch to high gear early to save fuel and reduce noise.

3) Do not drive the engine speed too low, and only change to low gear when the engine is working hard.

4) The speeds and rotational speeds listed in the instructions are only applicable to engines with normal temperatures. When driving cold, do not allow the engine to work at the highest revs, whether in neutral or in other gears.

5) New tires don't have optimal adhesion when they start with use, so new tires also need to be walked, slower for the first 100 km, and driven with care.

6) The new brake friction plate also needs to be run-in, in the first 200 kilometers of driving, there is not yet the ideal friction, if the braking effect is slightly worse at this stage, the pressure of the pedal can be appropriately increased. The same applies after each subsequent replacement of the brake pads.

7) Under possible conditions, the new car should avoid continuous driving for a long time during the run-in period, so as to avoid the engine and chassis parts continue to work for too long, resulting in the aggravation of the wear of the parts, and directly affect the service life of the car. Also to avoid full load operation, generally in the first 1000 kilometers of driving, the line type gear is best to run below 80% of the rated load. Also, try to avoid driving at high speeds, and don't go faster than 70% of the top speed with the throttle open for the first 2,000 km/h.

8) during the run-in of the new car, the driver should heat up in situ after the initial start of the new gear chaotic car, wait for the water temperature to rise to the working temperature range and then start, the driving tenant should choose a good road surface, and slow down when the road condition is poor; When driving, the throttle should be smaller, the operation should be light, once the engine or chassis sound is found to be abnormal, it should be stopped to check the fault in the embryonic period.