Are bonsai orchids easy to live? Are orchids easy to feed

Generally, potted plants should be good, if the potted plants are much larger than plants, they are easy to rot after watering, after all, orchids are all fleshy roots, and the water is too poor.

Bluegrass is the easiest to transplant to survive. They can be transplanted with bare roots, and we can often see some vendors, carrying hundreds of orchids in big bags, setting up stalls to sell, because orchids are not afraid of bare roots, not afraid of drought, afraid of watering too much and the soil too wet.

Yes, it is better to go to the florist and buy a special bag of stones for the orchid. After planting, water it in time and place it in a cool and ventilated place indoors. It is best to spray potassium dihydrogen phosphate frequently. It is resistant to drought and is afraid of direct exposure to the sun

It's hard now because the summer temperature is so high that the orchids basically stop growing very slowly, and if you repot the flowers, the bacteria are also very rotten and will wilt even if they don't have long roots. It is best to plant in the fall.

Orchids are easy to raise, most of the ordinary varieties are not difficult to raise, novices raise orchids, it is recommended to raise some ordinary varieties, not only easy to raise but also cheap. The orchid that I just bought is good to feed, first spread it out to dry, cut off the rotten roots, and soak it with potassium permanganate solution for disinfection. Keep the temperature in the chamber at 20 degrees, do not water the land immediately, and water again when the soil is dry.

Orchid growth habits.

Orchid flower language is indifferent, beautiful, virtuous, it likes shade, afraid of strong light, likes moisture, likes fertile, well-drained, soft soil planting.

Are orchids easy to feed.

Orchids are easy to raise, most of the ordinary varieties are not difficult to raise, but there are some varieties that are more difficult to maintain, novice orchids, it is recommended to raise some ordinary varieties, not only easy to raise and ** also cheap.

Can orchids feed in the north.

Orchids can feed in the north, the weather in the north is cold, and the orchids are afraid of cold, so you can choose the tenacious vitality of the orchid in the green cloud plum, iron bones, golden silk horsetail planting.

Can orchids feed indoors.

Orchids can be fed indoors, and they can purify the air and improve the quality of the air when they are kept indoors, and the indoor environment is also more suitable for its growth.

Is the orchid you just bought easy to raise.

The orchid that I just bought is good to feed, first spread it out to dry, cut off the rotten roots, and soak it with potassium permanganate solution for disinfection. Keep the temperature in the room at 20 degrees, do not water immediately, and water again when the soil is dry.

How to feed orchids.

1. Watering: If the orchid is watered once every 5 days in winter; Water once every 3 days in spring and autumn; In summer, when the temperature is high, you can water it twice a day.

2. Temperature: The orchid maintenance temperature is best kept at 16-24 degrees, not more than 30 degrees in summer, and not lower than 5 degrees in winter to avoid frostbite.

3. Illumination: Orchids can not be exposed to strong light, and should be shaded in summer, and can receive astigmatism in the morning and afternoon, and can bask in more sun in winter.

4. Pruning: Orchids should be pruned properly, the old leaves and yellow leaves should be cut off, especially the leaves infested by diseases and insects should be removed immediately, and disinfected after pruning.

Now this season is not suitable for transplanting, spring and autumn season is appropriate.

1. According to the size of the orchid plant, how much to choose the right right.

of the orchid pot. 2. Select or prepare suitable planting materials according to the species and region of orchids.

3. Prune the root system of the orchid properly, cut off rotten roots, hollow roots and excess old roots, and cut off the roots that are too short and too long.

4. Rinse the whole orchid plant, carry out comprehensive and thorough sterilization and disinfection, and hang it upside down to dry the surface moisture.

5. Continue to sterilize and disinfect the used disinfection and sterilization solution for the blue basin, and take it out for later use.

6. The used disinfection and sterilization solution continues to sterilize and disinfect the planting material, and take it out to dry.

7. Dry the surface moisture of the orchid plant and dry it until the orchid root is chalky white and soft.

8. Dry the planting material until it is wet but not wet.

9. On the pot transplanting, the bottom of the pot should be placed with a suitable draining bowl, etc., the bottom layer should be covered with a layer of coarse particles, and then some appropriate bottom fertilizer should be added.

10. Add a layer of slightly smaller particles and implant them into the orchid plant to make its roots stretch naturally.

11. Slowly fill the planting material around the plant, the lower part is slightly thicker, the more upward the thinner, and gently pat the pot wall while adding the planting material, so that the planting material fills the root space and closely combines with the root root.

12. The finest particles should be made in the top layer, so that the upper part of the pseudobulb of the orchid plant should be exposed to the soil surface.

13. If conditions permit, spread a layer of moss on the pot surface soil, which can moisturize and solidify the planting material in the pot.

14. On the second or third day, water the root water thoroughly, and put it in a suitable location for ventilation, light, temperature, humidity and other conditions to maintain carefully.

The orchid potting procedure is as follows:

After the pots, culture soil (or cultivation medium), and orchid seedlings are ready, they can be planted in pots. The first is to pad the pot, the principle is that the pot should be empty, easy to drain, conducive to the growth and development of fleshy roots. Usually 3 5 thin tiles or worn-out flower pot fragments are used to cover the hole in the bottom of the pot.

The tiles should be concave side down, convex side up, cross and stack, cover the entire hole bottom, and have pores with each other to facilitate smooth drainage. After the tiles are covered, a layer of drainage is spread on top of them, usually with chestnut charcoal, and the size of the granules varies from one or two centimeters to five or six centimeters depending on the size of the pot. First, spread the large particles on the bottom of the pot and cover it with fine particles.

In addition to chestnut charcoal, walnut shells, chestnut shells, peanut shells, unrotten leaves and fern roots sieved from humus soil, as well as volcanic stones, broken bricks, plastic fragments, etc. can also be used as drainage. The height of the padded drainage layer can reach 1 4 l 3 of the basin height. After the basin is mated, use a small shovel to shovel a small amount of a layer of sterilized culture soil to cover the drainage layer.

Then hold the pseudobulb in your left hand and let the root system fully stretch in the pot, and the height of the top of the pseudobulb is about 1 2cm from the mouth of the pot. Holding a small shovel in the right hand, gradually fill the culture soil into the pot. When filling the pot 3 4 high, use the fingers of the right hand to reach into the root system, and stuff the stone into the space between the roots.

Then continue to add soil to the mouth of the basin.

1cm。Lift the strain slightly upwards with your left hand and shake the pot with your right hand to allow the soil to fully enter the gaps in the root system, and then compact. The soil surface in the pot is slightly higher, and the surrounding area is slightly lower than the edge of the pot 1 2cm, which is in the shape of a steamed bun.

The soil surface can be covered with a layer of moss, stone grains or fern roots to avoid splashing soil after watering or rain, which can pollute the foliage. This completes the potting procedure. Soak the well-potted orchids in a bucket with a water surface slightly higher than the basin surface, and let the water slowly seep into the pot through the bottom hole until the basin surface is completely soaked.

Then take out the orchid pot and drain the water in the pot, and spray the entire orchid pot and orchid plant with a watering can at the same time, and spray the leaf dust and the soil on the edge of the basin to clean it. Place the freshly planted orchid pots in the shade for 1 2 weeks, and then place them on the prepared flower stands for cultivation. When potting, the whole cluster of orchids should be placed in the ** of the pot, so that there is enough space between the new shoots (new pseudobulbs) and the edge of the pot.

That is, the direction of the so-called "dragon head" of the orchid plant should leave room for germination and new sprouts. If several clumps of orchids are planted in a pot, keep the distance between the orchids and let the sprouts face the edge of the pot.

First of all, it is best to disinfect the newly bought orchids, soak the roots of the orchids with diluted potassium permanganate solution, and then pad the pot, in addition to the method mentioned upstairs, you can also get a palm from the palm trees outside, wash it, spread it under the pot, and then spread a layer of large particles such as peanut shells, then a layer of nutrient soil, and then large particles of peanut shells and the like. The rest is what the upstairs says.

1. Prepare the material in advance: spray the prepared planting material and seal it with a plastic bag for 1 to 2 days to make the planting material evenly moist (avoid over-wetting).

2 pots: the current market business has porcelain pots, tile pots, plastic pots, purple sand pots, sweat mud pots and so on, as long as according to the size of the orchid seedlings, the number and length of the root system, to choose the right orchid pot, the use of planting materials corresponding to the characteristics of the orchid pot, coupled with the potting skills and normal management in the future, no matter what material of the orchid pot, can raise a strong, healthy and beautiful orchid.

3. Potting: Regardless of the new pot or the old pot, it can be soaked in the bactericidal solution for 1 hour before use to play the role of annealing and sterilization. Put the drain buckle at the bottom of the orchid pot, and then fill it with a large particle base material with a uniform ratio to 1 5 of the height of the pot bottom, grab the slightly coarse planting material in the planting material and add it to the position close to the bottom of the orchid root, and then start to add the planting material normally, support the seedlings with one hand, grab the planting material with one hand and add it evenly around the root in turn, add it to 1 2 places of the length of the orchid root, gently shake or pick up and pat the surrounding of the orchid pot to make the planting material sink and stick to the roots.

Then gently raise the seedlings so that the false bulb is slightly above the horizontal position of the pot surface.

The above is the method and step of potting orchids, among these method steps, the most important step is undoubtedly potting, if not, it is best to follow the above method steps.

How do I pot an orchid I just bought?I harvested potted grass in the countryside and shared the basic 5 potting steps.