How to tear the insurance logo, how to paste the insurance logo

Use a hair dryer to blow your hair, turn it on as a warm breeze, blow it for a minute, and tear it off with a gentle hand.

Also, don't do that next time, there are many ways to use it now!

1. Use plastic wrap.

The plastic wrap scissors are strongly insured, and the annual inspection logo is the same size, pasted on one side, and then pasted on the front windshield glass of the car, but it will fall off in a few days.

2. Transparent glue.

After pasting, it is still troublesome to tear it off, 3. A small bag with a suction cup is sold online for 15 yuan, and the compulsory traffic insurance is packed into a plastic small bag, and the suction cup is sucked on the glass, but it always feels unsightly. Weird. There was something shaking on the front windshield.

4. Electrostatic film, sold online for 6 yuan.

Confirm that the side with the electrostatic film will tear off the word inspection and environmental protection logo upwards, and the side with glue will be glued to the electrostatic film to smoothly glue the word inspection and environmental protection label to the static electricity.

On the film, tear off the electrostatic film from the bottom paper, wipe the windshield clean (there can be no dust), stick the word inspection and environmental protection logo stuck to the electrostatic film, stick it to the fixed position of the windshield, and discharge and compact the air by hand.

If it is attached to the windshield, it is best not to tear it, as it will make the glass smear.

If the front flap is not attached, take alcohol or a two-pot head.

Some people say that they use a hair dryer to blow a blow and then tear a corner, and then tear it off. Personally, I tried it and felt that it was a little inappropriate, what should I do with the windshield film?

If there is any residue after tearing it off, apply it with alcohol or wind oil, and wipe it off with a cloth after 2 minutes.

Tried it, and it's ok.

In the future, it is better to use electrostatic film or logo bag.

Stick it to the front glass of the front passenger seat, which is the upper right corner. It is best to buy an electrostatic transparent sticker, sprinkle the logo sticker on the electrostatic sticker, and then put the electrostatic sticker on the glass. In this way, the next time the sticker is not coarse, the glass will be smeared, and it is easy to sprinkle it down, remember to stick it inside the car, not on the outside of the glass.

Apply a thin layer of milk to the front of the car insurance logo, then attach it to the car, dry it with a hair dryer, and it is also easy to tear it off.

The car insurance leakage insurance mark is one of the important signs to determine whether the motor vehicle participates in the compulsory traffic insurance. It is annotated with the words "supervised by the China Insurance Regulatory Commission", the policy is brown, the main text adopts the international advanced red fluorescent anti-counterfeiting ink, and the horizontal line under the text is composed of miniature text, and the anti-counterfeiting performance is better. In addition to the area reserved for different operating companies to print the company's logo, the specifications and styles of insurance policies are unified across the country.

The motor vehicle insurance mark on the windshield of the motor vehicle is the sign that the motor vehicle participates in the compulsory third-party liability insurance of the motor vehicle. As a basis for insurance, the traffic police can know whether the insurance is insured and whether it is valid.

The car insurance logo only has the compulsory traffic insurance sign and the commercial insurance stove stool bad card. There should be compulsory traffic insurance signs, annual inspection signs, and environmental protection signs on the sticking car. The last two belong to the DMV.

Here are a few ways to try:

1. If the expired label is directly attached to the glass, wet the label first, and then scrape it with a paper cutting blade. The glass is relatively hard, as long as it is not brute force, it will generally not scratch the glass.

2. Tear off the non-absorbent paper on the surface of the label, then point wind oil, edible oil or other organic solvents on the viscose, soak it for 2 minutes and remove it with a cloth.

3. If the label is attached to the sun film, it is not easy to do, you can try to use an eraser to remove the crack field division, that is, first moisten the expired label with water, and then wipe it with an eraser while dripping water. In this way, the sun membrane underneath will not be damaged.

4. A one-and-done approach. Use static electricity stickers, after this clearing, you need to paste signs in the future, it is recommended to use static electricity to slip and shout stickers, the cost is only 1-2 yuan a piece, but let the hunger a lot easier.

The method of pasting the vehicle insurance sign is: 1. The hall high vehicle insurance sign must be pasted, and there is a specified position, which should be pasted on the glass on the right side of the co-pilot's front window. If you don't stick it, once the traffic police find it, you will be fined;2. The Traffic Safety Law stipulates that motor vehicle drivers must bring their driver's license, driving license, insurance policy and compulsory traffic insurance signs.

If the motor vehicle on the road is not placed with a compulsory traffic insurance sign, the traffic management department may detain the motor vehicle in accordance with the regulations, notify the party concerned to provide a strong traffic insurance sign or go through the corresponding procedures, and may be given a warning or a fine of not less than 20 yuan but not more than 200 yuan;3. The full name of compulsory traffic insurance is "compulsory insurance for motor vehicle traffic accident liability", which is a compulsory liability insurance for the personal and property losses of the victim (excluding the vehicle personnel and the insured) caused by the road traffic accident of the insured motor vehicle within the liability limit4. Compulsory traffic insurance is the first compulsory insurance system implemented by national laws and regulations in China. The premium is the implementation of the national unified charging standard, which is uniformly stipulated by the state, but the compulsory traffic insurance of different car models is also different, and the main influencing factor is the "number of car seats".

1. The compulsory traffic insurance sign must be pasted, otherwise it will be punished accordingly, according to the relevant provisions of the traffic law, the motor vehicle driving on the road is not placed with the inspection mark, the insurance sign, the warning or 20 yuan and 200 yuan below the fine of Huiyuan, a 1 point.

2. Motor vehicles that fail to place the annual inspection mark on the road will be punished with 1 point and 50 yuan before a penalty.

3. Motor vehicles that fail to place insurance signs on the road will be deducted 1 point and fined 50 yuan.

4. Failure to paste the environmental protection mark will also be fined 50 yuan.

The car needs to be affixed with the inspection mark and the insurance mark. It should be attached to the front glass of the passenger seat, which is the upper right corner.

According to laws and regulations, different circumstances will be imposed on Zhen Min Shi with different fines:

1. If the motor vehicle fails to place the inspection mark and insurance mark in accordance with the regulations, a fine of 200 yuan and 1 point will be deducted;

2. If you do not carry an insurance sign, the traffic police will detain the car according to law, take the trip and impose a fine of 200 yuan and deduct 1 point;

3. If you forge, alter or use other motor vehicle insurance marks, you will not only be detained and fined 1,800 yuan for forging and diverting the loose use signs, but also be fined twice the basic premium of the compulsory traffic insurance, that is, 2,100 yuan, and the total fine will be 3,900 yuan;

4. If the insurance certificate is lost and still continues to go on the road, the traffic police will detain the vehicle, impose a fine of 200 yuan and deduct 1 point, until the vehicle is returned after the sign is reissued;

5. If the vehicle is not insured with compulsory traffic insurance, the traffic management department will not inspect the vehicle.

1. First of all, the original sticker is next and the surrounding area is scrubbed clean, and there can be no dust.

2. Then take out the electrostatic film and scrub it clean.

3. Envy and then remove the strong risk sign. Be careful not to get dirty.

4. It is not attached to the car glass, but to the electrostatic film, compacted and squeezed out of the air.

5. After pasting, remove the electrostatic film and paste it on the glass.

6. Once it may not be tightly attached, there will be bubbles in the oak air, at this time, if you are waiting, you will use your fingers to drive out the air, and you can stick it tightly.