How to access wireless routes in a LAN

Connect the wireless router to the LAN and then set up to get the IP address automatically, your wireless router settings page has wireless settings Click Turn on Set Password to prevent others from using your wireless signal.

First of all, when you don't use a wireless route, do you have to dial up or get it automatically.

How do you get online, just set up a wireless router, how to go online, it's online, you're connected to it, and that's it.

Yes, if you are using a company to assign your IP, the route will be set to a fixed IP mode.

1. First of all, after opening the mobile phone, click the small white dot on the iPhone, and after popping up, click [Control Center].

2. After the control center pops up in the background, click to turn on the wireless network, blue means open.

3. Click to open the [Camera] that comes with the Apple phone.

4. The mobile phone camera is facing the wireless network***, and the prompt of the message wireless network *** pops up at the top, and click the message prompt.

5. At this time, the mobile phone will pop up a message about whether to join the wireless LAN, click [Join].

First of all, we must be clear about a few things, 1 your network segment address 2 subnet mask 3 gateway address 4 dns server address.

If you have a computer on your local area network, you can obtain the above information by doing the following.

Click Start Run to enter CDM to enter the command symbol interface.

In the command symbol page, enter ipconfig all

ip address. .IP address.

subnet mask .Subnet mask address.

default gateway .Gateway address.

dns servers .DNS server address.

Make a note of the above information and need it when configuring the router.

Then let's start the next step, use a network cable to access the router, no need to connect the WAN port, just connect the LAN port.

After connecting the router, we start to configure the router, and the main modified parameters are as follows:

1. Set the LAN port address of the network cable (in the same network segment as the LAN, and the subnet mask address, the same as the previous record).

2 Set the SSID, turn on the wireless function, and configure the password.

3 Configure DHCP (optional) The gateway address, DNS server address, and subnet mask address of DHCP are consistent with your record, and the assigned address range is optional, and it should be in the same network segment as the local area network.

Note: If you have a device on your LAN that has DHCP enabled, please do not enable this feature.

4 Restart the router and the configuration is complete.

At this time, you can use the wireless signal of the wireless router to access the Internet, or you can connect to other LAN ports of the router through the network cable.

I am an amateur of the Internet, if you have any questions, you can write to discuss.

1.First of all you need a wireless router, you don't need the kind with a cat, like the DI-624 will do, 2Plug in your fiber, then dial in.

3.Don't use a fixed IP, auto-assign an IP will do the trick.

In addition, you can also use the soft AP mode to implement your Wi-Fi sharing. However, that requires a wireless network card that supports soft AP. For example, 3070 and so on.