Courtship Epson K590 dot matrix printer driver, thank you 35

It is recommended that you go to the official driver life**,Open the driver**page,In the printer options,Find the model of Epson printer,Open the following will list the drivers of each operating system,**Install it;

Try it with other drivers that come with the system, such as 1600k.

The first thing I want to ask you is, what operating system is your computer?

It's not a problem with the gap between the print heads, it should be that the adhesion of the paper is not good or the inside of the print head is clogged. The problem of paper jam in the drum printer is also inevitable, but the size of the paper jam probability is a problem, or buy a flat push type, now the printer is not expensive, a new 1500-1700, the performance is much better, and it is a three-year warranty.

It should be that the runner of the pressing unit is broken or spins slowly.

The 590k printer is really not bad. Hehe. That's a lot on my side. Most of them were sent directly for repair. No way.

The rotation pump generally does not move, maybe you have a problem with the paper feeding sensor, do not feed the paper, so the rotation pump does not move!

Pay attention to the selection of the paper feeding direction, the large lever on the right, sometimes others accidentally dial to the place that is not commonly used, you can't use it. Just dial it back.

The paper feeding claw does not work, there is a foreign object or the sensor is broken (if it is broken, it should be reported that there is a shortage of paper).

When printing in the software, Biyuan Waiting,You should regret that the wild state can have a print attribute to select,Go in and set the printing direction to horizontal。

If it doesn't work, "Start" - "Settings" - "Print Spine Machine and Fax", after opening the printer and fax window, right-click on the printer and select "Printing Preferences".

If the above solutions still do not solve your problem,

Break the blue clip of the bucket up, and then the two liquid skin grinding jammed paper can move freely, and then break the blue one after the paper is stuck, and then break the blue one and lock it, you are continuously holding the paper input from behind, and the front paper feeding lever picks up the "continuous paper feeding".

Try different drivers, drive elves, drive life, the original driver is not necessarily the best. In addition, win10 can also find the installation driver by itself. Cancel the virtual memory setting and give it a try.

It's not the latest driver is the best.,The driver that comes with the original disc is the most compatible.,It is recommended that you still use the original driver.,My 590s is the original driver.,No problem.。

As long as it is a dot matrix printer, I use EPSON LQ630K is also very good, with a good printer to choose a good printing software, I recommend one to you, I am using it now, the little bad wolf express single printing software, I have been using it for almost 2 years, the service is also good, the template is updated very quickly, now there are 200 are planted, you might as well try.

I reinstalled the driver wizard and the driver problem was solved. The driving elf is really amazing!!

I remember there was an all-English disc that was a drive disk! Have you tried all of them? And if there is no corresponding model, teach you a trick! Go to the K580S i7 to check it out! Maybe it will work!!