How to flash the parallel Samsung S5830i? ? The baseband is S5830iZCKL2

For details, please refer to the corresponding section of the Jifeng Forum, as long as you are bold and careful, you will have no problem! In addition, it doesn't matter if the flashing machine and the baseband version, the baseband can be brushed separately.

Preparation before flashing:

4. Please ensure that the battery power is sufficient, and the data cable connection should be good. It is recommended to close other programs when flashing the computer to prevent the computer from crashing.

Detailed steps of Samsung S5820 flashing tutorial:

Line brush process: 1. Manually shut down, press and hold the home button + volume down + power button at the same time to see a prompt, and then press the volume up button according to the prompt to enter download mode:

2. Run the odin flashing tool, if the driver is installed successfully and our phone enters the download mode, there will be an identification in the port, as shown in the following figure:

3. We choose the official ROM and choose the official ROM Here we have to pay attention to whether you are brushing the all-in-one package or the kit:

If it is an all-in-one package, select it according to the figure below, and select it directly in the second item of the firmware package option

If you are a kit, we have to choose according to the picture below (the text is not clear, you can save the picture and zoom in to see):

4. After confirming that the flashing package is selected correctly, we click the start brushing button, and the flashing will begin, and some changes will occur in the status grid above.

5. The whole process of flashing the machine will take a long time, we need to wait patiently, we can't unplug the data cable halfway, and we can't cut off the power until the upgrade is completed, and the pass prompt will be displayed, as shown in the figure below.

6. At this time, we unplug the data cable, cut off the battery for 10 seconds and then install it, and we can enter the new system after turning it on.

It is recommended to go to the after-sales brush,It's best not to brush its5820The configuration is not high,The higher the system version of the brush,The higher the configuration requirements for the mobile phone,I don't believe you try,Or go to the after-sales people don't give you a brush,Brush it to you to test is the result of the card, and you have to brush it back。

You can bring your own one.

I don't know what to say.

You go check this.

Your phone isn't unpopular.

My phone is more unpopular than yours, and there is no root when I just got the phone.

I succeeded in flashing the phone.

In fact, there are only a few steps (to tell you about card swiping).

RootRecovery first

Put the flashing package in the root directory of the memory card.

Enter the Android robot and flash into the system.

Reboot system now restarts, booting may take a bit long, this is normal, waiting for boot.

This is the approximate step, and it may be a little different from the link, but it doesn't matter, you do what I send your link.

Yes, I don't know if you've seen it.

If you haven't seen it, take a closer look, and if you have seen it, take a closer look.

Follow the steps step by step and don't be afraid of trouble.

If there is any problem, I will tell you what I know.