-
In fact, the xenon lamp is not necessarily better than the original yellow light, it just looks brighter on the outside, and it looks very majestic in the distance, much brighter than other cars. To a large extent, the installation of xenon lamps is favored by everyone, because in the eyes of the Chinese people, it looks relatively bright.
Generally speaking, it will not be reversed, because the filament of the low beam and the high beam is very different, if you find that your high beam is not as good as the low beam, it is possible to install the wrong (ps: it seems that this problem rarely appears, because the light must be checked after installation).
The light is not concentrated and low is not suitable for your position, because the adjustment is adjusted by the repairer according to his height and habits, if you are not satisfied, you can go back to the factory to adjust, and you yourself sit in the driving position, while ** the light at the same time according to your own vision to let the master adjust until you are satisfied (generally do not charge money, collect money to complain about him).
-
It's better to change back to the original light Xenon lamps are not very focused.
-
The high beam is H1, and the low beam is H7, yes.
It's just that the structures of the two lights, Philips H1 and H7, are completely different and cannot be interchanged. The sockets of the two lamps are different, and the maintenance personnel will not install the two lamps incorrectly.
It's best to go to the place where the lights have been changed to confirm it. The metal part of the H1 has only one leg, and the H7 has two legs.
The headlamps have adjustment screws on the outer cover that allow the angle to be adjusted, and can be seen when the hood is opened. It may be that I forgot to adjust the light after changing it, and the landlord can go to the 4S store to adjust.
-
The light is not concentrated, and the xenon lamp also needs to be equipped with a lens, and there will be a clear dividing line between light and dark after installation.
It may be that the color temperature of your xenon lamp is too high, the color temperature is too high and it looks very bright, but the penetration is very low, it is recommended to install it with a color temperature of about 4000k, and the penetration is strong.
-
Landlord, you go to die, it's not good to change the lights and stun the opposite side.
The landlord's heart eye is worse than the ball eye.
-
Hello, Yuqing is very happy to serve you and give you the following answers: A: The solution to the common problem of 230 xenon lamp is mainly in the following steps:
1. Check whether the power cord of the xenon lamp is in good contact, and if it is bad, it should be replaced in time. 2. Check whether the power supply voltage of the xenon lamp is normal, if not, it should be adjusted in time. 3. Check whether there is a short circuit in the circuit of the xenon lamp, and if so, it should be eliminated in time.
4. Check whether the filament of the xenon lamp is damaged or dismantled, and if so, it should be replaced in time. 5. Check whether the lampshade of the xenon lamp is polluted, and if so, it should be cleaned in time. 6. Check whether the control circuit of the xenon lamp is faulty, and if so, it should be repaired in time.
Personal tip: When using xenon lamps, you should pay attention to regular inspections, find problems in time, and deal with them in time to avoid unnecessary losses.
-
Nissan 16 Teana High Beam Model: High Beam: H9 12V 65W; Low beam and fog lamp: H11 12V 55W
Banquet high beam replacement steps: spring leak 1Open the hood; 2.
Disconnect the negative wire of the battery; 3.Unscrew the bulb connector counterclockwise and remove the bulb connector. 4.
Remove the high beam bulb, being careful not to shake it; 5.Install the new bulbs in reverse order.
Note: The high-pressure halogen gas is enclosed in the bulb, and if the glass cover is scratched or dropped to the ground, the bulb may burst; When disassembling the bulb, do not touch the glass cover directly with your hands.
-
If the original headlights really affect daily driving, then it is recommended to replace them quickly, after all, safety first, it is recommended to change a set of xenon headlights, do not change naked, the effect of naked change is general and astigmatism. Changing the xenon headlight bifocal lens, the effect can be increased by 3 5 times compared with the original, including brightness, irradiation distance, paving effect and other aspects.
Changed the lighting effect of the APA Xenon lamp set.
Fengshen S30 Pentium B50 Roewe 550!! It can be regarded as the independent work of the three giants of China's car industry!! It will not disappoint the Chinese people, and Dongfeng is the second automobile, which made China's first passenger car 50 years ago!! >>>More
1. Tiida is actually one level lower than Civic and Sylphy, although Sylphy is also lengthened from Tiida's platform, but it is also better than it, first eliminate Tiida; >>>More
Xintida can only use the AUX audio cable**The songs in the mobile phone are standard ports The same size as the headphone port of the mobile phone Buy a male to male can be. The original car does not have a memory card and Bluetooth**, and needs to be equipped with another relevant device to replace the original car's CD player.
C2 embodies a new urban lifestyle of life and nature C2 is positioned for vitality. >>>More
You don't need to learn MATLAB, you can go to university and learn it again. >>>More