After the computer is powered off, it turns on and displays Restart Remove Others is a blue screen W

Is your computer blue screen or black screen? Workaround for not turning on:

1. Turn on the computer, after the computer brand is released, immediately press [F8] [Enter] [Enter] to enter [Safe Mode] [Advanced Start] [Options], the last correct configuration, [Enter] [Enter], take a look.

2. If it doesn't work, then enter [Safe Mode] [Normal Start] [Enter] After going to the desktop, the whole disk is disinfected.

3. Use [360 Security Guard], click [Trojan Horse Killing] [360 System First Aid Kit] [System Repair] to select all

4. Not yet, unplug the graphics card and memory module, erase with an eraser, and then use a brush, you can use a hair dryer to blow a cold air around the main chassis, mainly to clean the dust of the slots and fans, or replace the memory slots, etc.

6. Reboot, if it still doesn't work, you need to [one-click restore] or reinstall the system.

7. If there is a problem with the hardware, replace or send it for repair.

Have you upgraded your drivers or installed patches? Press F8 to enter the safe mode when the device is turned on, and select the latest correct configuration to try.

This is caused by poor board contact.

It is too troublesome to solve the specific problem, it is recommended that you redo the system, and the redo system may be incompatible with your computer hardware.

Remove the battery from the computer for 5 minutes before installing it.

Since it's good, use it first, this kind of problem is very difficult to solve.

Unplug the power cord and press and hold the power on button for five seconds to release.

Remove the motherboard battery and discharge it before attaching it.

Plug and unplug the memory.

Remove the motherboard coin cell battery first. In case of power failure. Remove for 5 minutes and reattach the CMOS clearly

There's a lot more English, and if you say that, no one will help you solve it.

hardware-induced. Pluggable memory. If it doesn't work, just reinstall the system!

Press the F8 key to enter safe mode when powering on and select the last correct configuration.

If there is a problem with the memory, first wipe the gold finger of the memory with an eraser. Try another one if possible.

Assemble the computer handle, the parts are not allowed to be integrated, can not.

Is it to detect the blue screen of the hard disk, it may be that there is something wrong with your hard disk, but it does not affect the use, and this problem will occur if the hard disk is not used properly.

Some configurations are incompatible, reinstall the system

I'll tell you!The probability of memory module problems is more than 75%, and the 25% chance is that the hardware temperature is too high, resulting in a crash or protective reboot or blue screen. Rule out the case of high temperature and blue screen of death restart.

Open the chassis. Plug the memory module back in. Two memory sticks. Just plug in just one.

Check whether the air dissipation of the CPU is running normally, whether there is a gap between the CPU and the heat sink, and whether the silicone grease is dry or cracked or lost.

Add silicone grease and debug the air dissipation. Unplug all the hardware and clean it up.

In addition, the chassis has now been opened. Use a hair dryer to clean up the dust. Don't forget to go to the door and deal with it.

Otherwise, the house will be filled with smoke.

If it's still a blue screen. Just find a normal memory module and try it. Probably just fine. That means your memory module is broken.

If you are Ben. It's sad ... It's better for novices not to disassemble the machine by themselves.

If it's a book, take it out and find a repair point, disassemble it, and try to change the memory.。。。 It is risky for novices to split the book. Think again.

There is also a 15% chance that it is a disk error caused by a 00000000ed error.

and drivers and other programs. The workaround is to disable all startup items in safe mode before starting.

It may be caused by a mismatch between your software program and hardware, think about whether you have recently installed some software, especially about the system, uninstall them one by one and give it a try!

Question: The laptop battery is not very good.

Options, last correct configuration, Enter, Enter, press to try!

2。No more, enter the safe mode, start normally, press enter, and after going to the desktop, the whole disk is disinfected!

Question: Unexpected power outage results in a blue screen.

Again: Start first aid!After restarting, click on "File Recovery", select all, and delete the files completely!

7。If there is a problem with the hardware, send it for repair!

You belong to the battery loss, the computer is powered off, and the abnormal shutdown leads to the blue screen of the computer again.

You try the above operation to see if it works, remember to back up all the files after normal boot, your computer battery has a problem, next time it may suddenly lose power, it is recommended that you can replace the battery.

Hope it helps! Have a great day! If you think it is helpful to you, please give it a thumbs up!