My USB flash drive plugged into the computer is not reflected at all!!

You uninstalled the wireless card driver to see if there is a driver conflict.

Reinstall the motherboard driver...

Try it on a different computer, if it is still the same can not be recognized, click on the computer right-click management device manager to see if the driver is installed, if it is not installed, the next U disk universal driver is installed, if it is not good, it is recommended that the U disk mass produce it (use software), if it doesn't work, it means that the U disk is burned out when plugging and unplugging!

Can the USB flash drive be read out normally on other computers? If you can, then you can do a one-click recovery of the machine, or redo the system.

It may be that the chip of the USB flash drive is not too hard and the compatibility is poor.

Right-click on the computer - open the device manager - other devices, the USB drive model shows a question mark inside, right-click to update the driver - browse my computer to find the driver - let me choose from the list of available drivers on the computer - disk drive - next, it's OK, the test is successful.

In this case, you can press the [F1] key to enter the recovery environment (WinRe) by pressing the on-screen prompt. Then in the winre environment, you can repair or reset the system.

Once you're in WinRe, you have three options:

Continue: Go back to the window system before entering the recovery environment.

Troubleshooting: WinRe's core features.

Turn off your computer: Turn it off.

If you need to reset your PC, you can go to Troubleshooting—>Reset this PC].

Depending on your actual situation, select "Keep My Files" or "Delete Everything", and then follow the on-screen prompts to complete the system reset.

<> System Restore: Restores the system to the restore point you choose that is most appropriate.

Command Prompt: Here you can use some command-line tools to fix or set up your system.

System Image Recovery: You can recover a system from a disc or system image.

Startup settings: After clicking [Restart] in the interface, you will be asked to choose the desired restart method during the restart process.

Startup Repair: Checks whether the boot configuration file and boot partition affect the system and automatically fixes the boot issue.

Roll back to a previous version: Roll back the system to an earlier version.

What should I do if the USB flash drive is inserted into the computer and it does not display, the USB flash drive is not displayed in my computer. I believe everyone likes to use a USB flash drive to connect with the computer,Copy some files or ** movies or something,But some people found that there was no response after the two were connected,Let me talk about what to do if the USB flash drive is inserted into the computer and does not display,My computer does not display the USB flash drive。

First of all, we can first check whether the interface of our computer is worn or damaged.

Secondly, let's go back and see if there is any problem with the insertion port of the USB flash drive.

If it is a problem with the interface, then we need to find a professional maintenance personnel at this time.

After checking that there is no problem with the interface, we should think that it is a driver problem.

Install a Driver Master software on our computer.

Once installed, open this software.

After opening the software, it will automatically detect that your devices do not have drivers installed, and then we can install the corresponding drivers.

The first two diagrams are uncertain because there are many failure causes that can cause both of these scenarios.

The third picture,If it is not displayed,There is only one reason,That is, the version of the USB flash drive is not compatible with the current UEFI BIOS system of your computer,The relevant installation PE file,Not recognized,You still have to do a new USB flash drive,It is to use the format of your computer's recognition。 Made in compatibility mode.