The tricycle test section two around the pile skills, the section two around the pile tricycle out o

1. Before the drill pipe starts, the rider also needs to relax his mind and muscles, and his legs naturally clamp the car body. After the start of the pile, it is necessary to find the angle and speed of the input rod, if the angle is too large or the speed is too fast, it will cause the car body to not have enough steering space and press to the limit width line. The correct approach is to choose to enter from the middle of the sideline and the benchmark in the first or second gear, and after entering, it is necessary to properly cooperate with the oil separation, and try to maintain a semi-linkage state, so that the power output can be cut off in time for corresponding adjustments.

Refueling should be gentle and gentle, and when you find that the position of the vehicle does not match your expectations, you can't pinch the brakes to death. In short, in this process, everything is based on the principle of "slow". But this "slowness" must be well known, and you can't "slow" past the limit of your balance.

2. In the process of drilling pipe, when moving from the space between the two rods to the next space, you need to pay attention to the position of yourself and the car body to avoid hitting the benchmark. Drivers who are accustomed to driving in first gear can properly fuel when they first enter, and need to slow down when they drive out. With the second gear, the driver can try to pass at a constant speed.

It should be noted that in some driving school regulations, when you have completed a trip, you need to turn around, and then complete it again, and there is a distance limit for making a U-turn, so don't capsize in the gutter.

What should I pay attention to when getting started?

Branch 2 around the pile tricycle out of the line means that the body is not driving correctly, not going right, the pants are slippery and the body is hanging to the sideline, for example, it can be the front, tail, side and so on. Hu Yila is the body line when the mold is lacking in the turn. <>

Mikes.

The trick is to grasp the distance between the wheel and the sideline and the timing of the space between the two piles, for example, from the right side of the pile.

1. Before entering the pile circumference project area, the body and the right road side line should be balanced, and the rear wheel should be kept at a distance of about 30 cm from the road sideline;

2. After entering the test area, when passing the first pile, drive slowly forward, and when the shoulder or carriage pillar coincides with the pile, fill the steering wheel to the left.

Enter the section. 1. The space of the second pile;

3. Bypass the first pile or, the wheel is about to hit the road edge line back to the right, and slowly adjust the direction to the right to prevent the front wheel from crimping;

4. Continue to observe the position of the second pile and the body, and similarly, when the shoulder or carriage pillar is aligned with the hail book around the pile, drive the right full direction;

5. After driving out of the second pile, repeat the steps back to the positive direction and then enter the next pile, and so on.

Three-wheeled motorcycle pile-winding trick formula.

Walk to the side before wrapping the pile, and the edges are 30 cm apart;

Prepare the shoulder measurement around the pile, and align it with the direction of the pile;

Do not press the line by wrapping the pile, and turn slowly back to the front of the car;

Don't be careless through one pile, and continue to observe the second one;

Shoulder the second pile, hit the full direction and continue to wrap around;

The method is the same later, stabilize the speed of the car and go around in turn.

It is not difficult for the three-wheeled motorcycle to go around the pile, the skills and the source of the picture Wang Hongjie are here, remember to grasp the distance between the wheel and the sideline and the timing of the Lingheng pile.

Summary. Hello.

1. After the pile wrapping starts, it is necessary to find the angle of the rod and maintain a suitable speed.

Tricycle subject 2 pile-winding skills.

Hello tricycle subject two pile-winding skills. 1. After the pile wrapping starts, it is necessary to find the angle of the rod and maintain a suitable speed.

2. Choose to enter from the middle of the sideline and the pole at the speed of first gear. After entering, it is necessary to properly carry out the oil separation coordination and try to maintain a semi-linkage state.

The front wheel is turning in the middle, or the body is turning over the pole.

3. In the process of drilling the pipe, when moving from the space between the two rods to the next space, you need to pay attention to the position of yourself and the car body. When the body is over, it is crutched.

The body is crutched when it crosses the pole, right?

Yes. How to maintain the distance of the unilateral bridge.

Hello. The body is 30 cm from the sideline.

Look at the right third of the front of the car.

When the third of the front of the car coincides with the right sideline. The car is just 30 centimeters away from the sideline.

I don't understand. It is to divide the front of the front of the car into three equal parts in your mind. Then, when the third of the front of the car coincides with the right sideline.

That is, your eye sees the right third of the way to coincide with the edgeline.