What to do with Samsung S6Edge infinite restart?

If your Samsung phone has a boot screen but can't boot on to the standby screen normally, you can do the following:1Take out the SIM card and SD card at the same time and try to power on again.

2.When you see the "Samsung" logo icon when you reboot, press and hold the [Menu Key] (left touch-sensitive button)For recently launched models, press and hold the [Volume Down Button] until the word "Safe Mode" appears in the lower left corner of the screen, and then let go, back up data (e.g.: contacts, text messages, **, etc.), and restore factory settings3

If you can't enter the safe mode or the problem persists after operation, it is recommended to bring the three-pack certificate of the mobile phone and send the mobile phone to the nearest Samsung service center for testing and repair.

1. Press and hold [Volume Up], [Home Button], and [Power Button] at the same time in the shutdown state, and wait for the screen to light up before you can release it and enter Recovery mode. After entering the recovery mode, the English selection interface will appear, select wipe data factory reset to confirm - and then select the middle line yes--delete; Are you sure. Select Wipe Cache Partition again.

Finally, select the first option, Reboot System Now, and restart your phone.

2. Uninstall and delete the recently installed software to rule out whether it is caused by software incompatibility. Try replacing it with another original battery.

3. If there is an external SD card in the mobile phone, it is recommended to temporarily remove the SD card to observe whether the same situation will occur. Back up your data (contacts, text messages, **, etc.) and try after a factory reset.

4. Check whether the phone has a firmware system update prompt. If so, please upgrade your phone to the latest version. If the problem persists, it is recommended that you bring the purchase invoice, repair card and mobile phone to the local Samsung service center for professional engineers to help you test.

1. The boot cable is not normal and the boot is not turned on.

Under normal circumstances, when pressing the power button, the trigger terminal voltage of the power button should change significantly, if there is no change, it is generally due to poor contact of the power button or the power line is broken, the component is soldered, and damaged. When repairing, use an external power supply to supply power, observe the change of the ammeter, if the ammeter does not respond, it is generally a disconnection of the power line or a bad power button.

2. The battery power supply circuit is not turned on due to poor operation.

During maintenance, the power supply can be provided by different power supply methods in order to distinguish the fault range and determine whether the electronic switch is normal. Generally speaking, if the power supply circuit is bad, pressing the power button ammeter will not respond, which is very similar to the bad power line.

3. The software is not normal and does not boot.

In the process of turning on the mobile phone, if the software can not be passed, it will not be turned on, the software error is mainly due to the abnormal memory data, when the line is not obviously disconnected, you can replace the normal chip, version or rewrite the software, some of the circuit in the chip will be damaged, and it can not be passed when rewritten. When rewriting the software, the original data should be saved for emergency repair.

The appearance of a smartphone malfunction can be affected by a lot of factors. If there is a conflict with third-party software, viruses, or excessive cache usage, it will cause automatic restart. It is recommended to try the following methods:

1. Uninstall the recently installed third-party software and preliminarily eliminate the cause of system software conflicts.

2. Back up your phone's data (**book, text message, **, etc.), and restore your phone to factory settings If the problem still exists through the above methods, it is recommended to send your phone to the nearest Samsung service center for testing.

Hello !

As per your description, the problem with your Samsung Galaxy S6 Edge, it is recommended to try it as follows:

When the device is fully charged, after backing up data, press and hold the [Power Button] and [Volume +] buttons for 10 seconds with the device off (off).

After entering recovery mode, move the cursor with [Volume+], Volume-] (see figure below).

Operate 2-wipes again

Select Wipe Data Factory Reset > yes, home] to confirm.

Select wipe cache partition > yes , home] to confirm.

Select reboot system now > yes , home] to confirm.

After doing so, restart and you're done.

If the problem persists after 2-wipes, it is recommended to press and hold the [Power Button] and [Volume-] buttons for 10 seconds to enter Downloading Mode

Connect to your PC and flash the official ROM with the attached file Odin to repair the system.

Hope this helps you!!

If your phone freezes, it is recommended to do the following:

1.If it can't be turned off, it is recommended to press and hold the power button for 8-10 seconds to restart the machine to try, shut down, restart the machine to try, if it still can't be turned off, you need to send your phone to the service center for processing, if it can be turned off, you can continue to operate the following steps.

2.If an external SD card is inserted into the body, take it out for testing. Rule out 3Test the third-party software that was operated before the crash to rule out the third-party software that is incompatible with the phone and cause the crash.

4.Back up your phone's important data and restore it to factory settings.

If the fault persists, it is recommended to bring the machine, purchase invoice, and warranty card to the nearest Samsung service center for testing and repair.

How to force a shutdown of Samsung S6:

1. Plug in the charger, press the power button + volume reduction button, and release the power button and volume button when the phone screen is completely black;

2. Then the charging sign appears, then unplug the charger, and it will not restart.