-
Take out the SIM card and SD card at the same time, and then press the volume down button + power button for more than 10 seconds to test whether it can be turned on. If it still can't be turned on, there may be a problem with the system program or hardware, it is recommended to send the phone to the nearest Samsung service center for testing.
Introduction: On March 2, 2015, Beijing time, Samsung released the Samsung Galaxy S6 in Barcelona and appeared at the MWC2015 product launch conference. The Galaxy S6 is covered in glass at the front and back, and has curved metal bezels on the sides.
It is equipped with its own Exynos 7420 octa-core 64-bit processor, which is a 14nm process, and the 3GB running memory is upgraded to LPDDR4, and the overall configuration is also top-of-the-line.
Expansion: Samsung Group is the largest multinational conglomerate in South Korea, but also a listed company in the world's top 500 companies, Samsung Group includes many international subsidiaries, its subsidiaries are: Samsung Electronics, Samsung C&T, Samsung Airlines, Samsung Life Insurance, etc., business involves electronics, finance, machinery, chemistry and many other fields.
Samsung Group was founded in 1938 by Lee Byung-cheol.
-
The low-priced Samsung S6 unboxed, but it couldn't be turned on, did it overturn?
-
There are many factors that cause the phone to be unable to open the phone, such as battery drain, virus in the phone, and hardware failure of the phone.
You need to perform a self-test on your phone, and the operation is as follows:
1. Remove SIM card and SD card;
2. Press the volume down button + power button for more than 10 seconds;
3. Test whether the boot is successful, if there is still no state matching, it may be a mobile phone system program failure or hardware failure, and you need to go to a professional maintenance agency and outlets for further inspection and maintenance.
-
If your Samsung S6 suddenly has a black screen and won't turn on, you can try to fix the problem according to the steps below:
1.Check the battery level: Make sure your phone is connected to a charger and fully charged. Plug in the charger and wait a few minutes, then press the power button to see if it turns on.
2.Force Restart: Press the power key and the volume down key, and wait with both keys held down until the screen shows the words "Samsung Galaxy S6".
At this point, release all the keys and wait a few seconds to see if it turns on properly.
3.Enter recovery mode: Press the Power key, Volume Down key, and Home button, and wait with all three keys held down until the screen shows the Samsung logo, release the Power key, but keep holding the Volume Down key and the Home button until you enter the recovery mode screen.
In recovery mode, try clearing the cache partition or doing a factory reset.
If none of the above methods can solve the problem, you can consider contacting Samsung customer service or professional technicians for repair or repair.
-
Depending on the situation you described, it is recommended that you follow the following method:
1.It is recommended that you press and hold the volume down button + power button of your mobile phone for 8-10 seconds to observe whether the machine can be turned on normally.
2.It is recommended to take out the expansion card and SIM card and click the power button again to try to power on.
If the problem persists through the above methods, please bring the purchase invoice, repair card and machine to the Samsung service center, and the engineer will check the machine.
-
1.Check whether the battery is too low, please connect the phone to the original charger to charge it for a period of time and then turn it on.
2.If the battery supports disassembly, remove the battery or replace it with other original batteries and reinsert them and turn them on again.
3.If the problem persists, it is recommended that you bring the purchase invoice, warranty card and mobile phone to the local Samsung service center for professional engineers to help you test.
It is recommended that you bring the purchase invoice, warranty card and mobile phone to the local Samsung service center, and a professional engineer will help you test.
-
Hello !
What is the reason for your Samsung Galaxy not turning on?, it is recommended to press and hold the power button for 10 seconds to turn off the phone and then try to turn it on after charging.
If this persists, we recommend that you try the following steps:
When the device is fully charged, after backing up data, press and hold the [Power Button] and [Volume +] buttons for 10 seconds with the device off (off).
After entering recovery mode, move the cursor with [Volume+], Volume-] (see figure below).
Operate 2-wipes again
Select Wipe Data Factory Reset > yes, home] to confirm.
Select wipe cache partition > yes , home] to confirm.
Select reboot system now > yes , home] to confirm.
After doing so, restart and you're done.
If the problem persists after 2-wipes, it is recommended to press and hold the [Power Button] and [Volume-] buttons for 10 seconds to enter Downloading Mode
Connect to your PC and flash the official ROM repair system with Odin.
Hope this helps you!!
-
There are many factors that cause the phone to fail to turn on, such as battery drain, virus in the phone, and hardware failure of the phone.
You need to perform a self-test on your phone, and the operation is as follows:
1. Remove SIM card and SD card;
2. Press the volume down button + power button for more than 10 seconds;
3. Test whether the boot is successful, if it is still not successful, it may be a mobile phone system program failure or hardware failure, and you need to go to a professional maintenance organization and outlets for further inspection and maintenance.
-
There are many factors that the mobile phone cannot be turned on, and the battery, mobile phone software, and hardware will cause this kind of failure to turn on. We recommend trying the following:
1. Take out the SIM card and SD card at the same time, and then press the power button for more than 10 seconds to test whether it can be turned on.
2. Check whether the battery is too low: connect the phone to the original charger and charge it for a period of time and then try to turn it on.
If the problem persists according to the above methods, please bring the purchase invoice, repair card and machine to the Samsung service center for inspection.
-
The low-priced Samsung S6 unboxed, but it couldn't be turned on, did it overturn?
Hello: According to your description, it is recommended that you: >>>More
Dear Samsung users: According to your description, the Samsung S4 mobile phone application is installed in the built-in memory of the phone by default, if you want to move the software to the SD card, please try: Settings - Application Manager - Select a program - Move to SD card (if there is no such option, this function is not supported) [Note] Not all programs can be moved to the SD card, depending on the ** software you can also move the multi** and other files stored in the phone to the external SD card: >>>More
About Samsung mobile phone root problem: 1. Samsung mobile phone obtains root permission through third-party software, which can access and modify almost all files in the mobile phone operating system, but this operation may affect the stability of the mobile phone, and there will be human failures such as crash and restart. 2. In addition, after obtaining permissions, it generally causes defects to the main components of the motherboard such as memory and CPU. >>>More
Hello, due to the risks of flashing, such as mobile phone problems caused by self-flashing, it may also affect the repair, so it is not recommended that you flash the phone by yourself. If there is a problem with the phone due to flashing the phone by itself, it is recommended that you send the machine to the Samsung after-sales service center for an engineer to help check and deal with it.
Make sure that the battery of your phone is sufficient, and then connect your phone to a power source to charge it for a period of time before trying to turn it on. You can also press and hold the "Power Button" and "Volume + Button" at the same time to try to enter the recovery mode, select "Clear Data" first, and then select "Restart" after the interface jumps.