What are the brake pads for the K2 rear brake, Kia K2 rear brake pad replacement tutorial

Rear wheel drum brakes. Same as Reo.

1. Before replacing the brake pads, you should open the lid of the brake fluid reservoir in the engine compartment to see the height of the brake fluid page, if the brake fluid page is above the highest limit, you should suck out some brake fluid to prevent the brake fluid from overflowing during the replacement process;

2. Prepare the brake pads to be replaced and remove the wheels where the brakes are located. In the process of dismantling, the rim should be scratched in the sail;

3. Remove the bolts of the brake caliper with a wrench combined with the sleeve, and then remove the brake pad (if there is a brake induction line, the brake induction line should be removed first). Observe whether the brake pads are overworn, or cracked, and replace them in the next step;

4. Since there will be a lot of sand or mud in the brake caliper, it should be cleaned with a rag, and then applied silencer paste to prevent abnormal noise when braking;

5. Press the piston to the position that cannot be pressed with the piston pressure pump, then install the brake pads on the brake caliper, install the new brake pads in place (Qi state should also install the brake induction line) Hail, tighten the guide bolts, and the installation is completed;

6. After installation, cover the lid of the liquid storage tank, enter the car and press the brake pedal a few times, and reset the brake. Then observe the brake fluid height and be within the appropriate height range. After changing, test drive to check whether the braking effect is reflected.

Kia K2's braking response speed is still relatively fast, but due to the lack of brake calipers, it can not give full play to the advantages of tires in the early stage of braking, and the deceleration G value has not yet reached the deceleration of -1G, and the brake caliper can provide good braking ability until the speed drops to 12m. At the end of the brake, the ABS jumps so much that even the pedals can feel a strong bouncing phenomenon, which needs to be improved. The K2 hatchback has a braking score of 100 km/h in meters.

The Kia K2 has a slightly larger roll around the pile, but this is also for comfort. The 195mm tires have good ground resistance when catching reeds when rolling, and the overall handling is relatively stable. When the vehicle is thrown out, the throttle vehicle can quickly regain control.

The Kia K2 has fewer 4AT gears, so there will be fewer shifts. Coupled with the maturity of the technology, there is no obvious frustration when shifting gears, and the comfort is still acceptable. Although there are few gears, the K2 does not have a high cruising speed of 1500rpm at 60kmh, 2000rpm at 80kmh, 2500rpm at 100kmh, and 3000rpm at 120kmh.

This achievement is ideal for a naturally aspirated engine with a displacement and makes a significant contribution to improving fuel economy.

Millions of car purchase subsidies.

The replacement time cycle of brake pads is not fixed, it depends on the road conditions of the vehicle, the frequency and strength of the driver pressing the brake pedal, generally speaking, the life of the brake pads of the front brake is 35,000 kilometers, and the life of the rear brake pads is 6-10w kilometers, so it is recommended to check the front brake pads every 30,000 kilometers.

The thickness of the new brake pad is generally about that, with the daily friction loss, when the naked eye observes that the thickness of the brake pad is only 1 3 brand new, it is necessary to increase the frequency of inspection, and be ready to replace the new brake pad at any time.

There will be small raised signs on both sides of the brake pads, and when the brake pads are level with it (2-3mm), it means that it has reached the limit and must be replaced.

Hello, this one is based on how often you use the brakes. The more you apply the brakes, the more the brake pads wear out naturally. Wear and tear naturally costs! On average, it can be replaced for 4-60,000 kilometers! I hope my answer is helpful to you.

Hello, the brake pads of this car are generally recommended to be checked every 40,000 kilometers, and if the thickness is too low, it is recommended that you replace them directly.

If you don't understand something, feel free to ask, and I will give you a satisfactory answer!

Hello, under normal circumstances, it is generally replaced once every 4 to 50,000 kilometers.

The specific needs depend on your driving habits.

If the brakes are used frequently, they need to be replaced at about 3 to 40,000 kilometers.

Hello, the suggestion is 40,000 check checks, if it is too thin, or the brake clearance is too large, it is time to change,

Generally, if there is a distance of more than 10,000-30,000 kilometers, the brake pads need to be replaced. However, if you hear a grinding sound from the wheels, you should replace the brake pads, regardless of the mileage.

The rear wheels of the Dongfeng Yueda Kia K2 are drum brakes.

The general drum brake is composed of a rotating part, a fixed part, an actuating part and a positioning adjustment device. It is composed of brake floor, brake cylinder, brake shoe and other related connecting rods, springs, pins and brake drums. At present, it is only commonly used on the rear wheels.

Drum brakes have an iron cast shaped like a tambourine, called a brake drum, which is fixed to the tire and rotates at the same speed. Disc brakes have the advantages of better responsiveness and stability, better heat dissipation, and easy replacement. Drum brakes are less expensive and have higher absolute braking power, and are often used in the rear wheels of small cars.

However, the wear rate is higher, so the overall cost is higher.

The K2 uses disc brakes.

Disc brakes are also called hydraulic brakes or oil brakes. When braking, the high-pressure brake fluid pushes the brake pad to clamp the brake disc to produce a braking effect.

Drum brake is a traditional braking method for friction between brake pads and wheel drums.

The difference between drum brakes and disc brakes: heat dissipation and braking efficiency.

1. In high-speed driving, the drum brake heat dissipation is not good, and it is easy for heat accumulation to cause heat exhaustion in the brake part and weaken the braking force; The disc brake has good ventilation, fast heat dissipation, and is not easy to produce heat exhaustion.

2. The disc brake is caliper-type, the brake pad and the disc are in plane contact, the contact surface is large, the time is consistent, and the braking is rapid; The drum brake pad and the brake drum are in curved contact, from point to surface, and the braking efficiency is relatively low.

Disc brake is good, look at the current direction of the car's brake development direction, hehe, I hope it will help you drum brake brake brake front and rear wear unevenly, sometimes lead to soft brakes, disc brake is a sudden stop, and the stock brake.

The Kia K2 has disc brakes both front and rear.

Among the K2 models, only the 2015 hatchback MT GL model has a front disc and a rear drum, and the others are front and rear disc kills. Front ventilated disc kill, rear solid disc kill. (disc kill and disc brake).