Computer: Why is it booted up in the form of a reboot every time the computer is turned on again aft

1. The computer always enters the safe mode when it is turned on.

And the power is suddenly turned off, which is the result of loading too many important files at one time, and it is necessary to sort it out when you turn it on and off.

2. Check the power supply, it should be that the voltage of the power supply does not meet the needs of the computer itself, and the power supply of the state bucket has taken automatic protection, so the power is off. This situation is manifested by grinding, pressing the computer's power button, and then the CPU fan turns and stops the shutdown. Let's see if the computer is a similar problem, and if so, it's a power supply problem.

1. Keep restarting when you turn it on.

But. Safe mode.

Under Normal, it means that there is a problem with some of your hardware.

2. Memory. Goldfinger.

It has also been wiped, and it can be displayed when it is turned on, indicating that the memory and graphics card are good.

3, the cup is only 60 degrees, which is also normal.

4. I can upgrade.

Kill soft. and success.

Installing the system, disks and network cards is also good.

5. Well, the power supply or voltage is the most likely, in line with the perspective of saving money. It is very likely that the voltage of the alternating current where you are located is unstable, this instability is usually related to a slight short circuit in the power supply board, it is recommended to buy a new power supply.

Sockets. Try it.

First of all, check the blue screen ** to solve the problem, if you need to reinstall the system, you need to use a disc or USB flash drive to reinstall. It is recommended to use the [Xiaobai one-click reinstall system] tool, Xiaobai provides the original pure system of Microsoft, the specific operation is as follows:

Small white U disk system preparation tool:

1. One-click reinstallation of the tool.

2. A USB flash drive larger than 8G (it is recommended to back up the important data of the USB flash drive first).

3. A computer with normal Internet access.

Detailed steps of the small white U tray system:

1. Insert the USB flash drive into a computer that can access the Internet, open Xiaobai and reinstall the system software with one click.

2. Wait for the software to complete the detection and click on the production system on the left.

3. The software will automatically recognize the USB flash drive letter, and the production mode is just default, click to start production.

4. Select the system that needs to be installed, Xiaobai software supports x86-64-bit system installation, pay attention to the number of system bits when choosing, and start making after selection.

8. After the U disk startup disk is made, there will be a successful prompt, click Cancel.

9. Then we click on the shortcut key to check the start hotkey that will be used later.

11. Exit the USB flash drive and install it on the computer that needs to reinstall the system.

12. Immediately after pressing the boot button, click the USB flash drive boot hotkey, the boot selection interface appears, select the USB disk option, and press enter.

15. Install it on the C drive of the system disk, and then click Start Installation in the lower left corner.

16. Click OK in the prompt window.

19. After waiting for the optimization settings of the system, you can use it when you enter the system desktop (note: there will be several computer restarts during the period, no need to worry, let alone other operations).

The above is the method of installing the system on the USB flash drive, I hope it can help you.

Incompatible software drivers.

1,。If you can enter the system after a new boot, uninstall the newly installed software. (With the help of 360 is also possible).

2.If you can't enter the system after repeated startup, boot F8 into safe mode and uninstall the driver.

3.None of the above can be operated, then you can only reinstall the system