How to use a nebulizer to do nebulization at home?

Here's how to make a simple atomizer at home:

1. We connect the atomizer and the transformer, put the atomizer into a beautiful tray with water, and the water must not pass through the atomizer to avoid dry burning. This atomizer head will spray water upwards when placed in water, and there is also a set of plastic brackets in the packaging box of the atomizer, which is used to place a water-blocking glass or plastic sheet above the humidifier to prevent water splashing during the humidification process.

2. A large Coke bottle, a thin needle, and an old plastic bowl. Use the thin needle we prepared to prick a few holes in the Coke bottle, be careful not to make too big eyes, and then place the Coke bottle inside the plastic bowl with the bottom of the bottle close to the plastic bowl.

Fill the Coke bottle with a certain amount of water, and if the water does not squirt out, it is considered a success. Oak or then put the lid on the plastic bottle. As long as the water in the bottle slowly flows out and the bowl has water, then your air humidifier is considered a success.

3. There are many ancient methods of humidification, such as drying clothes and sprinkling water, which are the safest methods. We summarized the advantages and disadvantages of these two methods, in general, the advantages are very good, the effect is also good, the disadvantage Liang Wu is that there will be water on the ground when drying clothes and sprinkling water underground, and there is a risk of slipping people, and the other is that the time is not long, and the humidification will stop after the clothes and the ground are dry.

4. The method is very simple, that is, use a basin to beat half a basin of water and put it on the table or stool, and then put the towel on the edge of the basin and hang it down, one-fifth of the towel is placed in the water, and four-fifths is hung down. If you are afraid that the towel will fall, I use something to put in a basin to press the towel, and I use a mineral water bottle with water.

The specific steps for the use of household atomizers are as follows:

1. Before atomization, open the atomizer and work for 2-3 minutes for follow-up work.

2. Pour in the doctor's nebulization fan potion, into the nebulization cup, and close the lid of the nebulization cup tightly.

3. The nebulizer conduit is connected to the nebulizer and the nebulizer to the hail cup respectively.

4. Turn on the atomizer switch, and you can use the household atomizer normally.

The correct way to use the atomizer is as follows:1. Add 25ml of cold distilled water to the sink, and the liquid level height is about 3cm, and the sound permeable film at the bottom of the atomization tank should be submerged.

2. Put the liquid medicine in the atomization tank, dilute it to 3-5ml, screw the lid of the tank tightly, put the atomization tank into the water tank, and close the lid of the water tank.

3. Prepare all the supplies and bring them to the bedside, check them, and explain them to the patient to obtain cooperation.

4. Turn on the power supply, first turn on the [power] switch, the [red indicator light] is on, preheat for 3 minutes, then turn on the atomization switch, the white instruction light is on, and the liquid medicine is sprayed out in a mist at this time.

Place the atomizer flat in the water container, and then inject clean rock water into the container until the water surface exceeds the atomizer sheet by about 50mm (that is, the water level should exceed the door shape or 1 shape of the sensor head). Connect the power cord of the atomizer and the transformer, and then connect the transformer to the power supply (note that the input voltage of the transformer must match the local voltage), the LED indicator on the atomizer emits a bright light, indicating that the atomizer is in operation, and at the same time starts to make fog and produce a small fountain, and the non-LED atomization movement directly produces water mist.

After the nebulizer mask is covered, you can do nebulization inhalation. The atomizer has the function of automatic water cut-off protection, if the water level is lower than the sensor, the atomizer head will automatically stop working, and the atomizer will be damaged if it is dry burned for a long time.

1. The atomizer can be sustainable: working time" = 4 hours before the sink is filled with water, and the water in the tank is poured after the machine is turned off.

2. The wafer is a consumable, and the wafer should be replaced if there is a phenomenon such as small fog or vibration when it stops.

3. Shut down and invert every day, dry better indoor humidification with a large atomizing cup, must be equipped with a large oscillation film, otherwise water leakage.

4. The liquid medicine in the large atomization cup shall not exceed 350ml, and the liquid medicine in the small atomization cup shall not exceed 150mlWhen using the large (small) atomization cup, a large (small) sealing ring and a large (small) oscillating film must be used. It can be used only after tightening it vigorously without water seepage.

5. The oscillating diaphragm is not allowed to be stacked. Oscillating film (can not be stacked in several pieces, otherwise it will not be excavated and fogged.)

6. Shut down in time after atomization, otherwise it is easy to break the diaphragm. The diaphragm is haired, which affects the amount of atomization, and should be replaced. No liquid medicine is easy to break the diaphragm.

I use Pari's atomizer at home, and I will take its atomizer as an example to talk about how to use it.

1. First go to the hospital to prescribe good medicines, if there are 2 or more kinds of medicines, remember to ask the order of nebulization and whether you need to add saline.

2. Prepare the atomizer, install the power cord and connecting pipe correctly, and install the atomizer cup (I use the PARI Juniorboy, the atomizer cup will be dismantled and cleaned and disinfected every time it is used, so the inner core must be installed when you use it), and install the mouth absorber or mask according to your own needs.

3. Add medicine, there is a nuclear degree in the cup, the general amount is 2-6ml, too little too much is not good, if the amount is more, it can be divided into two morning and evening atomization.

In addition to these, there are a few things to keep in mind.

1. Before and after atomization, it is necessary to do a good job of oral flushing and facial cleaning. 2. The atomization cup should be kept vertical during atomization, and the person who is atomized should also maintain a sitting position, which is conducive to the arrival of the qi and fog to the lungs. 3. Do not eat half an hour before atomization.

4. If the child is crying, press and caress it first and wait until it is not crying and then atomize, and the atomization effect is not good when crying. 5. To choose a suitable nebulizer It is not recommended to buy it if it is too cheap, although some parameters are written to meet the standard, but the actual particles must be very large and cannot enter the lungs at all, and the effect is naturally not good.

My pari nebulizer is good, the brand has a history of more than 100 years, many atomization pharmaceutical factories will choose this brand for pre-market clinical trials, it can be seen that the stability and durability of the machine can stand the test, I have been at home for almost 2 years, and there has been no problem, although it is a little expensive, but it is completely worth it, saving me a lot of things, it is recommended not to be greedy for cheap, or you get what you pay for. I'm sharing this, I hope it can help you.