How to play billiards long distance pull

It is necessary to wait for the strength of the plug and the shot, which is generally used for defense. If the target ball is far away and hit in a straight line, you can't go back far no matter how low you put the low shot!

Scold. Hello. The cue ball has a safety zone, the slider is because of the safety zone, the hand holding the rod is slightly raised after posing under the premise of not leaving the safety zone, rather than the flatten, the better, there should be a downward pressure action when the rod is released, and the rod should be quickly closed, which is the basic action of pulling the rod down from a distance.

The rest is to practice diligently, practicing the long-distance low stick method: when frying the ball, use the basic action of low stick to fry, and the cue ball is retracted to the position near the tee position for success. Scold.

Practice often.

The moment the shot is played, press the rod down slightly and the ball will not jump.

The long-distance tie rod is very technical, and it is difficult to say the specific here, but I suggest that you can add a plug and use a little low rod, and the effect is almost the same, but you need to practice more.

It needs to be very low and the rod must be flat, pay attention to the rhythm of the front stop rod pull rod and rear stop, and the grip of the back hand is very important. Be sure to hit the ball through the rod and don't withdraw your hand immediately, that is, the rod runs with the ball. There is also the problem of force, billiards to exert force, not the big arm, but the small arm to drive the rod.

It's the rod that's playing, not the hand. In addition, the speed of the shot is also very important, and the shot must be fast.

Don't grip the rod too tightly and don't get too loose.

The posture is right, and I am thinking about the way to play.

Kiss, hello, billiards playing the lever is easy to produce results: 1Correct Stick Posture and Core Position:

The pole posture should be stable and the body should be balanced. The core position should be at the top of the shaft, so as to ensure the stability and accuracy of the shaft. 2.

Appropriate putting strength and speed: The force and speed of the putter should be moderate, not too light or too heavy. The force and speed of the putter are adjusted according to factors such as the position, distance, and angle of the ball.

3.Accurate putter direction and angle: The direction and angle of the putter should be accurate and adjusted according to the position of the ball and the position of the target.

The angle of the putter is generally less than 45 degrees of Li Que, which can be adjusted according to the specific situation. In addition to the above points, it is also necessary to pay attention to the techniques and techniques of training the pole, and you can improve your technical level through multi-object bend practice and competition. In addition, it is also necessary to pay attention to the quality of the club and the choice of the clubhead, and choose the club and clubhead that are suitable for the cover to disturb yourself can better play your technical level.

Finally, keep a calm mind and don't be nervous and impatient, so that you can perform better at your level.

Hello, playing the pull rod is a more difficult skill than the hall waiter in billiards, which requires a certain amount of practice and skill. Here are some tips for hitting the lever:1

Arm movements: The movement of the arms is very important when hitting the lever. When you're ready to hit the lever, keep your arms steady and don't shake, keep the club at a certain height, pull the club back quickly when you're ready, and hit the ball quickly.

2.Point of Impact: It is very important to find the point of impact accurately, which determines the accuracy and strength of the lever.

In general, the point of impact should be on the left or right side of the centre of the club1 3. 3.Eye gaze:

When you're ready to hit the lever, your eyes should be on the point of impact and stay focused. 4.Posture:

Posture when hitting the tie bar is very important. Maintain a smooth body position, keep the club level, and place your other hand on the bottom of the club to maintain balance. 5.

Practice: Playing a pull bar requires a lot of practice, and this technique can only be mastered after repeated training and honing. It is important to take care to stay focused and calm when hitting the lever, and not to overexert yourself or strain.

In billiards, if you need to play from a distance, you can usually use the following kinds of sticks:

1.Short Game: Also known as a "playstyle club", this type of game is usually around 36 inches in length and is suitable for situations where you need to play in tight spaces.

2.Long Pole: Also known as an "assault rod" or "rod", this type of rod is usually around 57 inches and is suitable for use when you need to strike long distances or cross a source such as a skin, such as a large span or a large size table.

3.Tie rod: Also known as an "extension rod", it combines the advantages of both short and long rods. This kind of rod can be retracted as needed, and can adapt to both narrow spaces and large spans of hail balls.

Different rods are suitable for different occasions, and in actual use, it is necessary to choose the rubber trap according to the need.

In billiards, the long-distance ball is hit with a long rod, often referred to as a "cue extension" or "cue extender".

A set-piece is an additional device that can be inserted and secured on a standard billiard cue to help players better shoot balls farther away. By using set-pieces, players can extend the length of their clubs, increase the distance they can hit, and reduce the amount of effort they need to stay consistent for greater accuracy.

When using the positioning rod, special attention needs to be paid to adjusting the muzzle position and force control. Because of the longer poles, players need to spend more time and effort to keep the muzzle in the desired position, and they need to have more manual adjustment power and skill when hitting the ball.

In conclusion, the use of set-pieces can help players handle long-distance balls better, but it requires a higher level of skill and personal experience, and requires constant practice and honing.

Summary. 2.Billiards Playing Skills Step 2: Playing Stick The biggest kinetic energy of the playing stick is to relax the back hand and make sure that your swing is naturally relaxed. Straight.

Hello, happy to answer for you, for your question the answer is:1Step 1: Set up the ball The stick is an action to make sure that the club and the hole are bright and the ball line coincides when the body is not lying down.

2.Billiards Playing Skills Step 2: Playing Stick The biggest kinetic energy of the playing stick is to relax the back hand and make sure that your swing is naturally relaxed. Straight.

3.Billiards Stroke Skills Step 3: Forward Stop The importance of front stop I think everyone knows it. The forward stop is the double ridge of the goal goal and the cue ball hit point, and the front stop must be naturally fixed in a position that is very close to the cue ball.

4.Billiards Skill Step 4: Pull the rod When pulling the rod, you still have to keep the back hand relaxed.

1. The middle rod, hitting the middle of the ball, can completely transmit the energy to the target ball, while the cue ball is stationary, commonly known as a fixed rod;

2. The high rod, hitting the upper part of the ball, can completely transmit the energy to the target ball, the cue ball is stationary first, and then rotates to run forward, commonly known as the heel stick;

3. The low rod is judged to hit the lower part of the ball, which can completely transmit the energy to the target ball digging and digging, and the cue ball is stationary first, and then rotates backwards, commonly known as shrinking the rod;

4. The left deflection rod hits the left side of the cue ball, and there is an arc;

5. The right deviation rod, the right side of the cue ball is scattered, and there is an arc;

6. The right low stroke, hit the right side of the cue ball downward, the running track is the arc first, and the low stroke is made after hitting the ball.

1. The middle rod, hitting the middle of the ball, can completely transmit the energy to the target ball, while the cue ball is stationary, commonly known as a fixed rod;

Bi Qiao 2, high rod, hit the upper part of the ball, can completely transmit energy to the target ball, the cue ball first stationary, and then rotate to run forward, commonly known as the following club;

3. The low rod, hitting the lower part of the ball, can completely transmit the energy to the target ball, the cue ball is stationary first, and then rotates backwards, commonly known as shrinking the rod;

4. The left deflection rod hits the left side of the cue ball, and there is an arc;

5. The right side is high and resistant, and there is an arc on the right side of the cue ball;

6. The right low rod, hit the right side of the cue ball under the bias button, the running track is the arc first, and the low rod is out after hitting the ball.