Electric vehicle battery repair method, how to repair electric vehicle battery

Updated on Car 2024-03-08
8 answers
  1. Anonymous users2024-02-06

    1. Repair the battery with an electric vehicle battery chargerThe voltage and current charged by the EV charger match the model and specification of the EV battery. Therefore, the battery pack cannot be repaired with a car charger, and the electric vehicle battery can only be repaired with an electric vehicle charger with a higher power.

    2. Repair the battery with hot water from a dry cleaner:Battery water loss is the starting cause of lead-acid battery failure, and the battery will lose water after about 6 months of use for electric vehicles charged by three-stage chargers. The water in the electrolyte lost during the use of the battery is not sulfuric acid, and the addition of a supplementary solution (dilute sulfuric acid solution) increases the specific gravity of sulfuric acid in the electrolyte, although it has the effect of temporarily increasing the capacity of the battery, and then accelerates the sulfidation of the battery and scraps.

    Therefore, the electric vehicle battery can only be replenished with pure distilled water, and no other liquid can be added.

    Precautions for the use of electric vehicle batteries.

    In the process of use, if the driving range of the electric bicycle suddenly drops by more than ten kilometers in a short period of time, it is very likely that at least one battery in the battery group has a short circuit phenomenon such as broken grid, plate softening, and plate active material falling off. At this time, you should go to a professional battery repair institution for inspection and repair in time.

    In general, the battery is charged at night, and the average charging time is about 8 hours. If it is shallow discharge (the mileage is very short after charging), the battery will be fully charged quickly, and if it continues to charge, it will be overcharged, causing the battery to heat up and reduce the battery life.

    The above content refers to People's Daily Online-In the event of a sudden failure of the battery, there are several ways to "save yourself".

    People's Daily Online-The battery can also "self-recover" after a short circuit (new knowledge).

  2. Anonymous users2024-02-05

    Whether the electric vehicle battery can be repaired mainly depends on what causes the failure of the electric vehicle battery.

    Taking lead-acid batteries as an example, most of the battery failures are due to the battery bulge caused by the battery charging and discharging for a long time, and this bulging is irreversible and quite difficult to repair, so it can only be replaced with a new one.

    Single battery failure, although theoretically. As long as you find a small battery with the same voltage and current to repair the battery failure, but from a practical point of view, it is difficult to achieve, because the batteries are in groups, and the conditions of the repair shop on the market are not allowed.

    Although the construction of the battery may seem simple, it still requires a certain amount of expertise from the maintenance personnel. At present, for the maintenance of batteries, many masters are accumulated from the profession of bicycles and motorcycles, and some theoretical knowledge is not deep and familiar. Therefore, from this point of view, if the battery of an electric vehicle is broken, it is generally replaced with a new one!

    And even if it is repaired, it may not be durable. Each electric vehicle battery has a certain charge and discharge limit, generally damaged, and then choose to repair, the battery will only recover for a short time, and then use it again for a period of time, the electric vehicle will still have insufficient power to run far!

    In short, if there is a problem with the battery of an electric vehicle, as long as it is not a line problem, general maintenance is unlikely, and the best option is to replace the battery with a new one. For users, to make the battery more durable, this factor can only start from the daily maintenance of electric vehicles.

    As a veteran lead-acid battery production group, Changxin Battery has excellent reputation and quality, and has been praised by the market for many years. As a high-end product in lead-acid batteries, Changxin graphene series adopts a more scientific direct connection structure, an upgraded formula with higher energy density, and a higher technology content, bringing longer life, longer endurance and more stable performance.

  3. Anonymous users2024-02-04

    The problem is incomplete.

    Is it because you can't ride far after charging?

    This method is easy to solve, boil the water, remove the fire to cool down, open the battery cap, add cold boiling water to it, stop the water just after flooding the plate, add the same for each grid, start charging without covering the battery cap, charge longer, if you charge 3 before

    hours, now charge for 4-5 hours, and you can use it!

    Why is it okay to add water?

    It is because the water has evaporated and the sulfuric acid is still there, and it is reduced after dilution with water, and after two or three times, sulfuric acid has to be added, and it has to be done in proportion.

  4. Anonymous users2024-02-03

    Electric vehicle battery repair method, absolutely dry goods please collect.

  5. Anonymous users2024-02-02

    Electric vehicle battery repair methods: repair methods for water loss, crystallization repair methods, and power loss repair methods.

    1. Repair methods for water loss.

    The battery is composed of electrolyte, lead plate and other parts, among them, the only liquid is the electrolyte, which is fused by distilled water and sulfuric acid, which is used to store and discharge the battery when it plays an important role in conduction and chemical reaction.

    2. Crystallization repair method.

    Crystallization is one of the manifestations of battery aging, because every time the battery is in the working state, the lead sulfate will be reduced to lead during the charging process, and the discharge process is that the sulfuric acid reacts with the lead and lead dioxide on the positive and negative plates to generate lead sulfate and water, but if the charging is insufficient or not timely, it will cause the lead sulfate to be completely reduced to lead, resulting in sulfation, that is, crystallization.

    3. Repair method of power loss.

    The charger can be identified for charging, because the loss of power leads to the inability to charge, mainly because the battery voltage is too low, the charger can not identify the voltage, can not complete the charging, at this time use some chargers that can automatically identify the voltage, if not, you can go directly to the fast charging station, as long as the voltage is identified, charging to the voltage that can be identified by the original charger, you can solve the problem of not being able to charge.

    Electric Vehicle Charging Method:

    1. The battery cannot be charged until the battery is exhausted.

    Try to charge the battery after riding to one-third of the remaining power every day, so that the electric vehicle battery can be in a shallow cycle state, the life of the battery will be extended, and at the same time pay attention to regular deep discharge, and the battery is also conducive to "activating" the battery through a deep discharge on a regular basis, which can slightly increase the capacity of the battery.

    2. The battery is also not suitable for frequent charging.

    Generally, the service life of a group of batteries is 600-800 cycles, and if it is charged too frequently, it will undoubtedly shorten the battery life. It is recommended to wait for the electric vehicle battery indicator to turn yellow before charging the electric vehicle.

  6. Anonymous users2024-02-01

    1. Open the battery cover and remove the 6 hard hats. 2. Use a syringe to fill each well with distilled water, if you add a standard electrolyte, the plate may burn out due to high acid solubility. For example, when we eat hot pot, why do we eat more and more salty, that is to say, when the water is evaporated and airlifted, the salt will not evaporate through the water vapor, and in the same way, the acid in the battery will not be evaporated, what is missing is water, so we only need to add about 20-30ml of distilled water to each small hole.

    3. After filling, let the battery stand still for half an hour, so that the sponge body around the plate can fully absorb the water. Then discharge with resistance, the electricity in the battery, all discharged, there is no resistance, you can use a 12V bulb instead, such as: motorcycle headlights, car turn signals can be, as long as it can play a role in discharging to 0V.

    How to judge that the battery is close to running out, the cement resistance discharge is hot at the beginning, and slowly gradually does not heat, and then the battery is out of power. As long as the light is slowly not lit, it means that the battery discharge is over, and the discharge time depends on the capacity of the battery when it is discharged. 4. After the discharge is over, the battery can be charged by pulse charging, because the pulse charging method can effectively remove the vulcanization of the plates and improve the capacity of the battery.

    If you don't have it, you can also replace it with a car charger. 5. After the charging is completed, use a syringe to pump out the excess water from each hole.

  7. Anonymous users2024-01-31

    Kiss. Hello. We'll be happy to answer for you.

    How to repair the electric vehicle battery, the first one: when the battery capacity of the electric vehicle is not less than 70%, the battery activator can be supplemented. Because when the battery power is not less than 70%, it indicates that the battery is gradually short of water and vulcanized rubber, at this time we fill a little rechargeable battery active agent, also called battery repair liquid or rechargeable battery expander Huai Mao, which is added to the ineffective battery car battery, can repair the volume of the rechargeable battery, increase the service life of the rechargeable battery, and improve the performance index of the rechargeable battery.

    The second type: when the battery capacity is not less than 50%, you can add repair solution. This is similar to the above, when the battery power is not less than 50% of the lead buried, indicating that the vulcanized rubber has been more serious, at this time will occur a slight softening situation, but if it is less than 50%, then the actual effect of the repair solution is not large, but it can still be used, in the middle of 30%-50% plus or there is some practical effect, but the lower the actual effect, the less significant the actual effect.

  8. Anonymous users2024-01-30

    Hello dear, <>

    I am glad to answer for you, electric vehicle battery repair method 1, water replenishment of the battery that has been used for about 4 months, can prolong the life of the battery, and the extension time is more than 3 months on average. It should be noted that after each water replenishment, the battery is in an overcharged state to change the battery from a "quasi-lean liquid" to a "lean liquid" state, and this overcharging is beneficial to improve the battery capacity. 2. Particle generator The particle generator is connected in parallel to the battery to repair the battery.

    This method is better for repairing the battery, but because the repair is more thorough, if there is no over-discharge, for the continuous use of the battery, it is often completely eliminated the possibility of battery vulcanization. 3. Eliminate vulcanization Battery repair equipment is used to eliminate vulcanization of the battery. 4. After re-configuring the whole group of batteries, we often carry out charge and discharge tests on the batteries, and often find that 50% of the batteries in a group of batteries are not damaged.

    The reason is that in the series battery pack, the individual batteries lag behind and the function of the whole group of batteries declines, so that the function of the whole group of batteries declines.

Related questions
20 answers2024-03-08

48V20A means that you can discharge for 20 hours with a current of one A. Therefore, it takes about 120 minutes to discharge with a current of 10A, and it is also 120 minutes to discharge with a current of 6A for 48V12A.

14 answers2024-03-08

Battery Charging 6 Note:

1. Use a special charger to avoid damaging the battery. >>>More

5 answers2024-03-08

1.First use a multimeter to test whether there is voltage in the battery, if the voltage is there, it can be charged, if there is no voltage in the shelf life can be replaced. >>>More

5 answers2024-03-08

Maintaining correct usage habits can effectively extend the life of the battery. When charging, be sure to use a suitable charger and be sure to prevent the battery from overcharging. If you don't need to use the car for a long time, set the key to charge the battery early. >>>More

13 answers2024-03-08

Generally, each electric vehicle battery is 12V, but also 6V (rarely used); The battery shell is generally printed with 6-dzm- (number), the number represents the battery capacity, such as: 12, that is, the battery is 12ah (ampere-hour); Generally, there are 10ah, 12ah, 14ah for small electric vehicles, 16ah, 17ah, 18ah, 20ah for large electric vehicles, etc., the capacity of the battery represents the size of the mileage that can be run, and the mileage of the large capacity is larger, and the larger one can be selected, ** The difference is not big; It can be connected in series to form 36V, 48V, 60V, etc., the general safety voltage is 36V, but with the current situation of overspeeding of people and goods, the voltage is getting bigger and bigger, and you can choose according to your actual situation.