How boxwood hedges are planted and how boxwood trees are raised

1. Sowing and reproducing

2. Seed selection and germination: In order to ensure the emergence rate of boxwood seeds, select seeds with full particles, soak them in clean water for germination, and gibberellin can also be used, but you must pay attention to the concentration. <>

3. Potting soil preparation: planting boxwood requires loose and fertile soil, organic fertilizer should be applied to the soil, and carbendazim and other sterilization and disinfection should be sprayed to ensure the healthy growth of plants.

4. Sowing: After mixing the seeds of boxwood with sand, sprinkle them evenly on the surface of the soil, cover them with a layer of fine soil, and cover them with a straw curtain for moisturizing. Wait until March of the following year to remove the straw curtain and pay attention to temperature control. <>

2. Propagation by cuttings

2. Cuttings treatment: boxwood usually uses the young branches of the year as cuttings, lignified or semi-lignified branches can be, and the upper and lower cuts should be in a place near the knots in centimeters, and put them in a cool and ventilated place after cutting. <>

3. Choose the seedbed: The seedbed of boxwood cuttings should generally be selected in a place with deep soil layer and high terrain. Remove the stones inside before cuttings so as not to affect the root growth.

It is then made into a 1-meter-high furrow and watered with imidacloprid and mancozeb to eliminate pests and germs in the soil, and then fertilized appropriately.

4. Cuttings: Insert the branches of boxwood into the soil, and the depth is about 1 cm for the stem nodes to be buried in the soil, and at the same time form a 45-degree angle with the ground. Water thoroughly after cuttings and wait until it takes root.

1. Soil:Boxwood trees should be raised in fertile, highly permeable soil.

2. Watering:In the later stages of growth, to avoid growth, stop watering. Watering cannot be done in the middle of the day when it is hot, it is better to choose morning or night.

3. Fertilization:Apply 2-3 times of fully rotted cake fertilizer water during the growth period of boxwood trees, and do not apply too much fertilizer. Basal fertilizer can be applied once in winter. <>

The size of the large-leaved boxwood hedge is 60 cmLarge-leaved boxwood can also be called holly euonymus, which is relatively cold-tolerant, likes moist soil, grows on fertile land, and has a relatively high chance of survival. Big-leaved boxwood is the preferred plant for landscaping, whether it is multiple together or one can grow into a round vegetable, after pruning, it is very beautiful.

1.Methods for planting large-leaved boxwood

For example, cuttings, in the spring and autumn seasons, choose large-leaved boxwood branches for cuttings, the chance of survival is not bad. Grafting is also possible, and grafting large-leaved boxwood on other green plants is also possible. Secondly, it can also be used to press the strip, and the survival rate is higher.

2.Varieties of large-leaved boxwood

As a good ornamental large-leaved boxwood, there are still many varieties of it, such as: golden heart, the leaves are golden yellow, and the twigs and petioles are pale yellow. Silver-edged, the edge of the blade has a very narrow silvery-white band.

The golden-edged ones are more densely grown, and the edges of the leaves are sometimes golden yellow. The backbone of Hokkaido is relatively easy to identify, and its advantages are obvious.

3.Planting requirements for large-leaved boxwood

When planting large-leaved boxwood, there are no particularly strict requirements for the soil, and relatively fertile and moist land can be. It can be planted in both spring and autumn of the year, so be sure to water it frequently, and don't forget to prune it regularly when the boxwood is grown.

About 6-8 trees per meter of h60p40 is more suitable.

1. EnvironmentBoxwood has strong shade tolerance, it is not strict with soil requirements, planting boxwood can choose flat terrain, fertile soil, loose, good drainage and irrigation plots, planting land to the sun and ventilation, which is conducive to the growth of boxwood. Before planting, we select the plot, then clean the impurities, then turn the soil deeply, apply organic fertilizer, and level the plot. <>

2. Planting densityBoxwood planting plant row spacing 0

5 meters, 1000-1500 plants can be planted on an acre of land, this density is still relatively large, but if it is to cultivate small seedlings, it can be properly densely planted, and the seedling planting density can be larger. Boxwood tree growth process also needs to transplant, if the cultivation of medium and large size seedlings, this step is essential, planting boxwood to open a deep ditch, after covering the soil will be the bottom of the soil compact, the depth of the covering soil is slightly deeper than the original, which is conducive to survival. <>

3. ManagementPay attention to regular watering after planting, maintain a certain humidity in the soil, if the climate is relatively humid, you can not water, and water frequently in the dry season to ensure the growth needs of seedlings. Plots planted with boxwood trees are prone to weeds and need to be weeded regularly, loosen the soil, and remove dead branches and leaves from the surface. Boxwood grows fast and requires a large amount of fertilizer, so compound fertilizer is applied twice during the growth period, and thin fertilizer and water solution are added during the period.

Personally, I think it is inseparable from environmental factors, it is not strict with soil requirements, select a good land, and then clean up the impurities, and then turn the soil deeply, apply organic fertilizer, and level the plot.

Boxwood likes light, can grow normally in both sunny and semi-shady environments, and is planted in areas with open surroundings, sufficient sunlight and good water and fertilizer soil conditions. By the time of flowering, water should be replenished in time. Divide.

Boxwood is a variety that does not require much soil, so it can be planted on a flat plot with good drainage and irrigation.

Boxwood and boxwood for greening are the same.

Boxwood is a dicot plant, boxwood, 1 6m high, oval leaves, is a shrub often used in landscaping or called small trees. The most widely distributed species of East Asian boxwood is boxwood, and there are many varieties with excellent traits. Boxwood is suitable for planting in areas with fertile soil and soft soil, has strong resistance to stress, can grow in weakly acidic and weakly alkaline soils, and has strong tolerance to extremely hot and cold or arid environments.

Boxwood loves light and water, and is suitable for growing in a sunny and humid environment, although it can grow and maintain its characteristics in an environment with short sunshine hours and weak sunlight, but the leaves often grow or weaken in this environment. Because of its strong environmental adaptability, it has a wide range of distribution.

The answer to give you a clear answer is the same.

A series of boxwoods, including boxwood balls, are cultivated from cuttings to different specifications that we see. For details, please see this kind of **.

Boxwood trees are formed by the cultivation or natural growth of large-leaved boxwood or wild boxwood, the only difference is that they are different in age, and boxwood trees have grown for more than ten years or even decades.

Same. The pruning of the greenery is more diverse.

Tips for planting potted boxwood.

1. Watering. Boxwood likes water, the principle of watering is rather wet than dry, the seedling root system is shallow, very sensitive to water, proper watering to keep the surface soil moist, seedlings should be irrigated with water during the rapid growth period, watered enough to irrigate, so that it is wet and dry.

2. Fertilization. Phosphorus fertilizer was applied more at the seedling stage, nitrogen fertilizer was applied more at the peak growth stage, and potassium fertilizer was applied when the growth rate was slower in autumn. After planting, spray the trium potassium dihydrogen phosphate solution as foliar fertilizer, spray 3-4 times a month, and the newly transplanted boxwood socks tease the seedlings to tell Wang Sellwood to pay attention to the concentration of fertilizer in the early stage of fertilization, which is easy to burn new roots.

Second, the main points of potted boxwood planting.

1. Potting soil selection.

Use purple sand clay pots, the color of the pot is purple or light yellow, the shape is different, the requirements for choosing the pot are different, the cliff type should use the deep thousand cylinder basin, and the oblique or curved dry type is used oval or rectangular basin. Use ripened garden soil or humus soil mixed with an appropriate amount of ridge bran ash to mix the soil, which requires the soil to be fertile and loose, and have good aeration and water permeability.

2. Turning time.

Repeat the pot once every 2-3 years, complete the repotting before spring germination, and take the lodging soil when changing the pot, cut off part of the old roots, too long and too dense root system, replace half of the old soil, and add fertile and loose new cultivation soil.

3. Shaping method.

Before modeling, the boxwood trunk is truncated, to promote the growth of new skills around or below the section, and then climb the branches, it is better to climb with brown silk in spring, and cut it into a cloud sheet or steamed bread or process it into a natural tree shape, and the trunk is made into an oblique dry type or a horizontal type.

It can be transplanted into a pot, and it needs to be watered more to grow quickly.