-
Cooking headphones is an artificially used way to accelerate the process of equipment entering the maturity stage. Generally, the equipment is allowed to work continuously for a certain period of time. For the power amplifier, as long as it is not turned off, it is burned, and for the headphones, it must also be fed with a certain power signal to make the diaphragm vibrate constantly.
Taking HP100 as an example, the most important component to be boiled is the internal tube, which can only be stabilized after about 100 hours of cumulative work.
When the earphones are burned, it should be decided according to the type and power of the input signal. The best way to do this is to use a specialized burn-in signal (a noisy signal with a very wide spectrum) to nominal power of 2 3 without stopping for 40 50 hours, which is equivalent to the level of normal listening for 2 to 3 months.
If you use ** burning, the continuous burn-in time should not be too long, no more than 12 hours a day, and the cumulative time should be more, about 60 70 hours. For devices with tubes, it is important to note that the continuous time should not be too long, and that the continuous time should not be too long, and that the equipment should be stopped every 30 hours.
-
People who like to use headphones with ** must understand what is a pot headphone, if the pot is not good, it is possible to shorten the service life of the headphones and even the physical damage that will occur to the headphones, among which the choice of the headphones ** is crucial, let's take a look at the special ** introduction of the headphones!
Dedicated to headphones**.
1. What does it mean to cook headphones?
The sound system of the dynamic headphones is driven by the voice coil, and the diaphragm is fixed on the frame of the earphones, theoretically speaking, the diaphragm movement should be a piston (vertical) movement, which requires the edge of the diaphragm to have a larger compliance, the pot is the pot here, the edge of the diaphragm of the new earphone is relatively tight, the elasticity is large and the compliance is small, the earphone is to let its edge move, the sound is not so tight. The purpose of boiling headphones is to make the headphones move in all directions in the initial continuous time in the three frequency bands of low, medium and high, and the warm-up activities are done, so no matter what type of listening to ** will not be so laborious.
What does it mean to boil headphones.
Second, the earphone is special**.
Cooker earphones are generally divided into four stages, namely low frequency, low frequency, high frequency and high audio, the following is recommended for each frequency**!
1. Low frequency. 0 12 18 hours, the volume is small and can be heard, comfortable:
The Ferry", Long Time No See, Pink Noise, Californiaho.
Low midrange**.
2. Mid and low frequency.
18 24 hours, low volume:
Radio Love Song", "Cloudy", "You Are My Eyes", "It's Not That Simple", "Ifiwereaboy".
3. Medium and high frequency.
24-32 hours, low volume close to normal:
Ferry", Californiaho, Sky, Badday, Southampton.
4. High frequency.
32 40 hours, slightly louder volume :
Love Song", "Opera", "Pompous", "Myheartwillgoon", "Tellmewhy".
When cooking headphones, you should also pay attention to the fact that the limbs cannot work continuously for too long! Because there is resistance in the voice coil, it will heat up after working for a long time, and it will burn the voice coil if you don't do it! It's every two hours, stop for a few minutes, and then continue.
In addition, the volume must not be too large, the earbud diaphragm is a very fragile material, if the volume is large, the stroke of the voice coil movement will be large, so as to pull the diaphragm violently, which will cause the voice coil to loosen, the vibrating finger to touch the membrane deformation or even tearing, etc. The above is the relevant content of the headphones and the relevant recommendations for the earphones**, I hope it can help you, please stay tuned for more decoration details.
Earphone burn-in means that the newly purchased earphones will only improve the sound quality of the playback after they have been powered on for a period of time. >>>More
The so-called reliance, that is"Grass"of the spoken language. I suggest that LZ don't talk about this! @!It's very uncivilized!
It's Edison Chen, CGX is the initials of his name.
Now his business is so hot, everyone is just shorthand like this for the convenience of typing. >>>More
nz is a well-known e-sports commentator in China, who has served as a commentator for various maps in the Qifan series, and is currently a commentator for the Three Kingdoms of Heroes and League of Legends! >>>More
1.Warcraft game map.
TD is an abbreviation for Tower Defence, a type of confrontation map in the famous real-time strategy game Warcraft. >>>More