How to eliminate maintenance lights for Volvo S80L

The Volvo S80L eliminates the maintenance light as follows:

1. First of all, you need to park the Volvo S80L and close the four doors, otherwise the operation will fail.

2. Then insert the car key into the car key hole of the Volvo S80L, rotate and start normally.

3. Then find the maintenance reset button in the middle of the steering wheel of the Volvo S80L, and keep pressing it without letting go.

4. At the same time, rotate the car key with the other hand and rotate to the sign as shown in the figure below.

5. Look at the steering wheel, if the yellow wrench logo on the dashboard disappears, it means that the Volvo S80L has eliminated the maintenance light.

If the maintenance light is eliminated, it is recommended to go to the 4S shop and let them use the computer to help you eliminate it, and reset the next maintenance mileage.

Changan Volvo S80L setting method: 1. Put the ignition switch in the "ACC" position. 2. Press and hold the odometer reset button.

3. Turn on the ignition. 4. After pressing and holding the reset button for 10s, the maintenance light flashes. 5. Release the reset button within 5s, and the instrument will make a "tick" sound after the reset is successful.

6. Note: If you do not release the reset button within 5s, the setting will not be successful.

Hello, this car needs to be reset by the computer.

Hello, this needs to be repaired and then reset with a computer.

The maintenance lamp is usually zeroed using the general-purpose diagnostic tool Tech2.

Considerations for car maintenance include that the engine should be cleaned at the right time. Because long-term use will form a thick layer of carbon deposits on the surface of the engine, which will cause greater corrosion to the rubber parts in the engine. Also, in the summer, the temperature is relatively high.

So both gasoline and water evaporate more easily than usual.

Because the water tank and fuel tank should be checked frequently, and when the gasoline and water are relatively small, they should be added in time. Summer is the season when bacteria grow the fastest, so keep the interior of your car clean, especially car seat cushions, car steering wheel covers, and car floor mats that are prone to dirt.

Here's how to zero the Volvo S80L maintenance lamp:

1. Ignition switch position" "Insert key, radio position";

2. Press and hold and don't let go of the zero button on the silver slag meter;

3. Ignition switch position II (press the start ignition button, do not step on the brake);

4. After the odometer reset button is held down for 10 seconds, the maintenance front bridge indicator (service) starts to flash;

5. When the information light starts flashing, release the reset button. Release the reset button of the odometer within 5s, after the reset is successful, the instrument panel will sound "dang" (when the reset is successful, the instrument will beep "dang"). Note:

If the odometer reset button is not released within 5s, the indicator will not be reset, and the indicator will stop flashing.

Volvo S60L maintenance light to zero:

1.Turn off the ignition and turn off the ignition.

2.Press and hold the "OK" button on the top of the turn signal lever and don't let go. (The position of the keys is shown in the picture above).

3.Tap the ignition once without applying the brakes, then press and hold the ignition.

4.Until the yellow exclamation mark indicator flashes three times on the dashboard, release the "OK" button and the ignition switch, and the reset is completed.

Models prior to 2013 can be applied by simply replacing the "OK" button on the instrument cluster with the "T1 T2" mileage button on the instrument cluster.

On November 24, 2017, Volvo officially announced that the 2018 S60L Aggressive Edition was officially launched, and the new car includes a total of 4 models, including T3 Zhijin, T4 Zhiyuan, T5 Zhiyu and T6 E-wheel drive hybrid. The Volvo S60L is a mid-level sedan produced by the Chengdu factory in Longquanyi District, Chengdu, Sichuan, China. The Volvo S60L is based on the Volvo S60 as a prototype, but the wheelbase of the S60L is 80mm longer than the S60.

The 2019 Volvo S60L offers three powertrains: in addition to the T3 model, which has a combined fuel consumption of only 100 kilometers, there are also powerful T5 and T6 E-wheel drive hybrid models to choose from.

Summary. Hello dear and happy to answer your <>

Replacing the Volvo S80 running lights requires the following steps:1Turn off the power to the vehicle and pull open the hood to facilitate the replacement of the bulb.

2.Open the lid of the running light from inside the car, or remove the fastening buckle and open the lampshade to remove the original bulb. 3.

Buy a new bulb with the same specifications based on the original bulb model. 4.Confirm that the new bulb is the same as the old one, then gently wipe off finger marks and dust with a clean rag.

5.Gently insert the new bulb into the light set and rotate it so that it is held tightly.

How to change the Volvo S80 running lights.

Hello dear and happy to answer your <>

Replacing the Volvo S80 running lights requires the following steps:1Turn off the power to the vehicle and pull open the hood to facilitate the replacement of the bulb.

2.Open the lid of the running light from the inside of the car, or remove the fastening buckle and open the lampshade to remove the original bulb. 3.

According to the original bulb model, buy a new bulb with the same specifications. 4.Confirm that the new bulb is the same as the old one, then gently wipe off finger marks and dust with a clean rag.

5.Gently insert the new SoluSlow bulb into the light cluster and rotate it so that it is held tightly in place.

Kiss <>

Expansion: The Volvo S80 is a premium luxury sedan from Swedish automaker Volvo that debuted in 1998. It adopts the front and rear drive cloth code macro bureau, equipped with a variety of high-tech equipment Sun Qiao and luxury equipment, intelligent driving assistance system, full LCD instrument panel, leather seats, automatic air conditioning, for the owner to provide a comfortable, safe, luxurious driving experience.

When the vehicle is turned off, press and hold the reste on the turn signal pole. At this time, turn on the ignition, then turn off the ignition switch, and press and hold the reste until a yellow exclamation mark appears on the vehicle's dashboard. After flashing three times, release the reste, turn off the ignition, and it can be eliminated.

How many kilometers does the Volvo S90 maintenance light on?

The model is the first to balance 10,000 kilometers. At 10,000 kilometers, the car's maintenance light will turn on, reminding the owner that it is time to maintain. After that, it will be the same, but the maintenance light will be on once every 10,000 kilometers.

In general, it is not advisable to manually eliminate service lights. Continuing to use the oil and filters of vehicles that have traveled 10,000 km will affect the oil.

What is the maintenance** of my Volvo S90?

Small maintenance** is about 1500 yuan, and large maintenance is about 6000 yuan. For minor maintenance, the oil needs to be changed, which requires the use of fully synthetic oil. One time, ** is about 900 yuan, the oil filter ** is about 200 yuan, and the working hours are about 200 yuan.

There will be some differences in different regions.

The above is about how to manually troubleshoot the Volvo S90 maintenance lights. Hope it helps.

Millions of car purchase subsidies.

If you want to manually clear your Volvo S90 maintenance lights, follow these steps:1Fasten your seatbelt and turn the start knob to start quickly without stepping on any pedals to set the vehicle usage mode to "Convenient" usage mode.

2.Press and hold the cruise control deceleration button on the left keyboard of the steering wheel for a long time (i.e., the "-" button).

3.Start the engine and set the vehicle mode to "Driving" mode.

4.Press and hold the cruise control button for about ten seconds, and the information symbol will start flashing on the instrument cluster display.

5.After the information symbol starts flashing for 1 4 seconds, release the cruise control button.

6.The instrument cluster display shows a message that the recognition is reset. The maintenance light reset was successful.

A simple summary is to guess the paragraph: fasten your seat belt, press and hold the deceleration button while cruising, do not step on the brake to ignite first, and then step on the brake to ignite. After a few seconds, wait for the exclamation mark to flash two or three times, release the hand holding down the deceleration button while cruising, and you're done.

Car owners can also check the vehicle's instruction manual (user manual), which will also have a detailed description. If you still can't read the manual, you can call the staff of the 4S store and ask them to teach you.

Millions of car purchase subsidies.