0x046d669b directive references 0x00000000 memory, which can t be wrtten .

Memory can't be"read"or"written"Most of this phenomenon is caused by a conflict between a newly installed software and other software or other hardware, or a hardware failure or damage, and in general, the compatibility of software and hardware is more likely to be caused. It is commonly found in some low-end motherboard configurations. There are a large number of so-called solutions to this problem on the Internet, but almost none of them are actually effective.

Solving this problem is not as simple as you think!

The following methods are carried out under the premise that the system is clean and virus-free, if you are not sure whether the system has viruses, please delete the previous anti-virus software, go to the Sky Software Park on **Kaba 2009 full-featured security software upgrade to kill the virus in the clean system, and then **360 Guardian to patch the whole system.

You can try the following methods first, but relying on this method to solve this kind of failure, it is too pitiful, and it can only be said that you can try it.

Start-run-cmd-input: for %1 in (%windir% system32*.dll) do s %1, and then try to start-run-cmd-input:

for %1 in (%windir%\system32\*.ocx) do regsvr32 /s %1

Please carefully recall whether you have installed any software before this problem occurs, and if so, please delete it and try again, because software bugs can also occur and often cannot be solved. If the program you want to execute has this failure, you can reinstall the program and try it, and if there is a newer version, try the new version. If you turn off IE or turn on IE, you can try to upgrade the IE version.

If it was IE6 before, you can upgrade to IE7 and try it, and if it was IE7 before, you can try to upgrade to IE8You can also try out third-party browsers, such as Maxthon.

If that doesn't work, you can only reinstall the operating system. Please install a different version of the operating system, the different versions here, refer to the previous installation of Tomato Garden, now replaced by Rainforest Wood Wind, used to use sp2, now use sp3...

If you still have problems after reinstalling the operating system, please carefully recall whether there is any replacement or repair or new hardware, if so, please remove the new hardware and find a way to find the previous hardware or find someone else's hardware to replace the replaced or repaired hardware, and then test.

If that doesn't work, check the hardware using the swap method, where the memory is the most likely to fail, please check the memory first.

Please be patient and follow what I tell you to check step by step until you find out the cause.

There is a problem with the system, and you can reinstall the system.