-
Generally speaking, it is three cymbals.
The hit hat is the kind of foot that is stepped on by two pieces.
crash is a crushed cymbal [well, the Chinese translation has no momentum of crash at all].
Ride is big.
The following is from: 5. Classification of cymbals 1.
Cymbals are generally divided into the following according to type:
Hi-hat hi-hats.
Hi-hat hi-hats. It consists of two pieces of cymbals. Complex tricks can be used using the pedals under the shelf. It is mainly used to produce a fixed beat with the snare drum, or to produce complex and varied beats on its own. The common size is 14'and 13'。
crash Broken cymbals, accented cymbals, hanging cymbals.
crash Broken cymbals, accented cymbals, hanging cymbals. This cymbal is used to emphasize the accent, so it is generally striking. Usually 16 to 19 inches in diameter, the most common basic combination is a 16-inch piece and an 18-inch cymbal, each placed on the left and right.
ride cymbals Ding Ding cymbals.
ride Ding Ding cymbal (named because of the sound that makes when you hit the cymbal). It is mainly used as a fixed tempo, and the tone is higher than that of hit-hat; But it can also be used like Crash, the sound is low, its explosiveness, and the volume is smaller than that of Crash. Generally 20 to 24 inches in size.
splash cymbals.
splash cymbals. A type of effect cymbal, it has a short and sharp tone, and the common size is:'。
China Chinese cymbal Han cymbal.
China Chinese cymbal Han cymbal. It is also a kind of cymbal effect, in fact, it is the cymbal in Chinese folk music, foreigners like its timbre and will improve the shape after the reverse hitting, the size is generally'。The crash ride can be used as both a crash and a cymbal for ride, and is generally 18 inches in diameter.
This is not a traditional cymbal, and is often used in low-cost products for beginners to practice.
-
The usual size of the code cymbal is 20 inches, also known as Ding Ding cymbal, and the English is ride
The usual size of the cymbal is inches, and the English word is crash
The broken cymbal is smaller than the code cymbal.
-
Not sure what you're talking about, the crushed cymbal aka the hanging cymbal crash is available from 14 to 18.
-
Drum kit. There are 3-7 drums, 2-4 cymbals, and bass kick drums.
Hi-hats, snare drums, barrel drums, and cymbals, and when I first started learning a drum kit, the standard equipment was five drums and three cymbals.
When the bass drum is played, the right foot is naturally flat on the pedal, and then the ankle and the sole of the foot are naturally relaxed when striking, and then the foot moves up and down with the pedal, and the ball of the foot cannot be raised too high, unless it is an accent, the foot does not leave the pedal.
When stepping on the cymbal cymbal, use the left foot, first lift the left heel, start playing with the heel under the ball of the foot, then under the heel of the heel, the heel naturally follows the pedal with the movement of the ball of the foot, the elevation action should not be too high or too slow.
The snare drum is played with the left and right hands palms down, and the cymbals are played with the right hand and the straight button is struck on the hi hats.
The hi-hat is also played with the right hand, and various rhythms are played instead of the hand cymbal, in the form of a straight wrist or a straight button, the gavel head is used to hit the cymbal surface, and the accent of the performance is to hit the edge of the cymbal with a mallet rod.
The drum kit is a very important percussion instrument in jazz music, and in addition to drums and cymbals, cowbells, wooden fish, shakers, and triangles are played.
Hanging bells and other instruments, but the performance is done by one person.
-
Five drums and four cymbals, hello! The standard drum kit is mainly divided into five drums, namely the ground drum, the ground drum, the snare drum and two toms, and their dimensions are as follows: 1. Ground drum:
22cm 16cm2, tom: 16cm 16cm3, tom: 12cm 9cm and 13cm 10cm4, snare drum:
The 14cm drum kit is a very important percussion instrument in a jazz band. It usually consists of a bass drum, a military drum, two or more drums, one or two bracelets, a rhythm bracelet, and a pedal bracelet. It can also add or subtract additional percussion instruments as needed.
The drum drum Henglu shout was formed in the 40s of the 20th century and has many types. In a band, the drummer masters important aspects such as speed and rhythm, especially in jazz, the drummer needs to maintain tacit cooperation with other players. Hope it helps.
-
The cymbal is a Han musical instrument derived from the cymbal. According to legend, in the Song people's painting of "Fan Wang according to the music map", there is an image of the Hu people's dance accompaniment, which can be known to be a long time. Ringing copper, bowl-shaped, the appearance is very similar to the cymbal, the general cymbal body is smaller, so the folk call the small cymbal cymbal.
The cymbal surface is flat, slightly thinner than the cymbal, slightly thicker than the cymbal, and the middle bowl is small and the top is round. Usually the face diameter is 12 cm 20 cm, the bowl diameter is 2 5 of the face diameter, the height of the bowl is cm cm, the top of the bowl is drilled with silk cloth, and the two sides are a pair. Flat Hit:
The two cymbals are struck face to face (they can be opened and danced when struck), and the sound is loud, and the flat strike of the cymbal is often used to enhance the atmosphere of splendor and grandeur.
The total method of playing cymbals:
1.Muffled: The two cymbals do not immediately separate after striking each other, but join together, causing him to make a short, muffled sound, controlling the aftermath as needed.
2.Hammering: Hit a single piece of cymbal with a small hammer or chopsticks or a wooden stick.
3.Grinding: The two cymbals are crossed and grinded, which can produce a "rustling" sound, which is often used to express the sound of water and wind and the restless emotions of the characters.
4.Side hits: Two cymbals and cymbals are struck in the opposite direction, and the pronunciation is lighter than that of flat hits.
5.Fighting: One side of the cymbal is horizontal, the other side of the cymbal is erect, and the center recess of the horizontal cymbal is vertically struck with the edge of the cymbal erected with the cymbal, and the sound is short and rapid.
-
You're talking about crash, cymbals. Its size is between 14 and 20, and the so-called lowest on the right is ride, which is also known as dingding, rhythm cymbals.
Hi-hats are called hihit.
There are actually many types of cymbals, hihit (mostly cymbals 14, there are also 12, 13, 15, ,,), crash (accent cymbals), ride (rhythm cymbals this is mostly 20, there are also 18, 19, 20, 21, 22, 24, 26, the largest ever seen 28, hit jazz), splash (water cymbals, mostly 6, 8, 10, 12 inches), China (Chinese cymbal sizes are more or less, I have seen 6, 7,8,10,12,14,16,18,19,20,22)。 There are also some deformed cymbals, such as Paiste's Novo China, Zildjian's Transformers (that name forgot, three flat and four not round anyway).
In addition, there is no standard for the number of cymbals, you can add as much as you need, for example, I am a pair of 14 hh, a pair of 15 hh, 16, 17, 19 crash, 22 ride, 16 and 18 China, the brand is not to say, this is more complicated.
So for cymbals, there is no such thing as a standard quantity, how much depends on your own choice.
It's original, it's not pasted.
-
A crash cymbal, a ride cymbal, and a hi-hat with pedals.
The percussion instruments of the drummers include snare drums, toms, and cymbals, and the foot percussion instruments include the big drum and hi-hats. On this basis, additional percussion instruments can be added or removed at any time according to the needs of the performance. In a band, the drummer is in control of the tempo and rhythm of the piece, especially in jazz, where the drummer needs to maintain a tacit relationship with other musicians.
-
The drum kit consists of bass drums, hi-hats, snares, toms, and cymbals.
It usually consists of a foot-pedaled bass drum (also known as a kick drum), a snare, two or more tom-tom drums, one or two crash cymbals, a ride cymbal, and a hi-hat with pedals.
Sometimes, due to the need for performance, some such as cowbells, wooden fish, sand mallets, triangles, and sound trees will be added, and no matter how many devices are added, they are all played by one person. The drummer hits the parts with a drumstick to make it sound. Commonly used drumsticks in jazz include wooden drum sticks, drum brushes made of steel wire, and bundle sticks made of thin wooden strips.
-
The general drum kit is five drums and three cymbals, usually the most played and with a sand belt is called the snare drum, two barrel drums, plus a floor bucket drum, the largest one is called a bass drum, there are concert special drums with four barrel drums, two floor bucket drums, two bass drums, the combination is varied, but generally five drums and three cymbals, the cymbals have cymbals, rhythm ding cymbals, sand cymbals, bell cymbals, rhythm cymbals, accent cymbals, the general drum kit is equipped with 14 inches of cymbals two pieces, 16 inches of rhythm between cymbals, There are also 20-inch ding-ding tablets, and the others can be added according to different song effects, but the general five drums and three cymbals are enough for ......
-
This is a lot, so I recommend going to the music exhibition to see it.
Hello LZ: Hehe, congratulations, friend, you have this idea, I only started to learn to play drums in June this year, and I had a foundation of folk guitar and rock music for 2 and a half years >>>More
The drummer is the soul of the band, and the reason for this is that he controls the rhythm and speed of the whole group. A good drummer must not only have comprehensive skills, but also have a strong understanding and expression ability. Of course, this is accumulated little by little from the roots! >>>More
Provision for bad debts accrued at the end of 2006: 1,200,000 * 3% = 36,000 >>>More
You can euphemistically play a double reed in front of your best friend, just say that you don't sleep well、、、 anyone who has the vision can understand it >>>More
The generation of rolling friction is caused by the deformation at the contact point between the object and the plane. The object is pressed into the bearing surface by gravity, and at the same time it is also deformed by compression, so when rolling forward, the bearing surface in front of it is uplifted, which makes the point of action of the elastic force n of the support facing the object move forward from the lowest point, so the elastic force n and gravity g are not in a straight line, but form a force couple moment that hinders rolling, which is rolling friction. The magnitude of rolling friction is measured by the coupling moment, and is proportional to the positive pressure, and the proportional coefficient is called the rolling friction coefficient δ, which is numerically equivalent to the elastic force to the force arm of the center of mass of the rolling object, so it has a dimension of length; It is related to the material, hardness and other factors of the rolling object and the bearing surface, and has nothing to do with the radius. >>>More