Ask a silly question, how do you take the CPU fan off the AMD AM2? Details.

If you remove the radiator, there is a wrench on it, turn it in the opposite direction, and then the lock will be loose, if the new one is tighter, you can use a screwdriver, take the screws down, so that you can take the fan off without removing the radiator.

Remember to have a clasp.

Twist the clasp to the other side, and the whole clasp will open.

After that, it can be dismantled.

It's simple. Just do it.

The buckle position of the fan is there, one is the buckle, and the other is the hook corresponding to the buckle.

After breaking the buckle arm, the buckle can't come down, and you have to use your hand to push the hook under the buckle inward, and pull the buckle out a little bit, so that the buckle and the hook are separated, and then mention it, it's OK.

In addition, there is silicone grease between the fan and the CPU. When removing the fan, be careful to lift it directly upwards with a little force, and try not to slide or rub it.

It is the buckle buckle on the protrusion of the CPU slot, after pulling it up, you pull the metal buckle out a little, and it is detached, and the other side is the same.

That's right, it's the handle on one side, after moving it, the fan is loose, but the buckle below is still hanging on top, you can detach the buckle under the handle.

Get the buttons off on both sides and bring the remote sensing on the fan first.

Then loosen the buckles on both sides and push the fan away to both sides without pulling it hard.

It's easy to unplug the CPU together, and the heat transfer cake on the AMD fan is sticky.

The best thing to do is to push the fan out on both sides.

There is a snap underneath. You pull the buckle outward. It will come out.

Isn't there a clip on the side of the fan, and you break it to the other side and release it, so that the fan becomes active and you can take it off. Note that because the fan is stuck very tightly, and the fan clip is plastic, you may not dare to break it hard, it's okay, just break it boldly, the fan clip will not be so fragile. I used to install it every day when I installed it.

Rotate the wrench 90 degrees in the opposite direction and remove the lock.

The solution is: 1. The wrench should be able to move away, but due to the high temperature of the CPU heat sink, some old CPU fans are easy to be sticky.

2. Some old CPUs (7 years ago), there is a small screw correction in the middle, you can take a look.

It's best to keep the relationship between the fan and the heatsink clean and unobstructed.

I had a lot of dust before, which directly caused the CPU to overheat and shut down, and after checking more than 100 degrees, it dropped directly to 30 degrees.

It's hard to say how much impact you add this layer of paper.

It won't burn, how can it be so hot! It doesn't matter if there's a little bit of paper, don't put too much of it. The fan and the heatsink are not so integrated, you can polish the heatsink.

No, because the thermal conductivity of the paper is very poor, and it is easy for you to burn out if you do this.

This is not good, the paper heat dissipation is not good, or it is better to add silicone grease.

Between the CPU and the fan, in order to conduct heat better.

A thermal conductive agent should be applied in the middle.

You're good, get a piece of paper.

Do you want to keep the CPU warm?

I see your CPU isn't far from burning.

Everyone is optimistic, what the landlord is talking about is between the fan and the radiator, what kind of thermal conductive silicon is painted! The first thing to be sure is that it won't burn, if you can burn the paper, the fan will already be on fire, but it will affect the heat dissipation, it is recommended that you replace the fan! It doesn't cost much, and the heat dissipation effect is good.

It's better not to let it go.

In general, I also use 4800+ handshake brothers.

Both are AMD platforms, and the CPU designed for games must have some heat, and if you are afraid of burning out the fan, just change to a better fan, dozens of dollars, which is completely enough for you, and there will not be too much pressure.

"Afraid of burning out the fan" The fan is more important than the CPU...

The base is not the same and cannot be used universally, unless you keep the base and see if the heatsink box fan can be installed.

1 All this fan is very common, and there are all in the computer city, and it is estimated that it is only 10 yuan, and the 8cm fan. Generally, it is three-wire or four-wire, general.

My brother buys a new U and doesn't overclock I mainly play 3D games.

The 8650 clock is only clocked to me.

From these 2 points, you can conclude that you are using the frequency now, and you are playing the game.

Your motherboard should be able to play on the AM3 CPU, I know that the Onda 78GT can be used. You should be fine with this.

But a little bit to tell you ... On this board on the 965, the performance is limited, mainly because there is no DDR3 memory support. Secondly965The original frequency is not high,Although it is 4 cores,But the game generally supports dual cores at most,Many games are single-core runs。

In other words, you don't have much performance improvement when you change it. Maybe you can run a little more.

If you really want to change, it is better to change to a high-frequency dual-core.

On the 1st floor, others are upgrading the CPU and other accessories are available Others say that the money for multiple motherboards can't afford it.,You still ask someone else to match it.。。

2nd Floor: You say, "Secondly, the original frequency of 965 is not high, although it is 4 cores", AMD Phenom 2 x4 965 black box The default frequency is not high?

You said "965 on this board, performance is limited, mainly because there is no DDR3 memory support" He said that next year, change the AM3+ board, and then you will definitely change DDR3

In terms of memory, Kingston 4G is a little better.

No way. The 462 is fixed by a bridge-like thing in the middle, and the 939 and 940 are fastened by the buckles on both sides. If you want to buy a radiator and can't find the 462, you can look for the full interface.