What should I do if I can t find the name of the Huawei CD28 Dual Gigabit Wireless Router?

This route is intelligent, and the name of the secondary router becomes the same as the name of the primary router after bridging. Distinguish which route management page is entered by IP address.

Turn off the power for 1 minute and try to power it back on.

There is a problem with your router settings, restore the default settings and reconfigure it, note that you need to know the bandwidth and password, otherwise you will be done playing. For details on how to set up the router, see the following section: How to set up the router to access the Internet.

Your phone is too far away from the router, try it closer, or your router is broken, which is unlikely.

Hello, after the wifi password is set, click the save button, the wifi password will take effect, and the mobile phone and laptop can go online normally after entering the wifi password, and there will be no changes.

Slow wired or slow wifi? This is sent by the operator, what good performance can it have. Or you check to see if anyone is ...... the net

It is recommended to make a TP or Mercury or Tengda route.

Huawei's hardware is really bad, but the router's software is not very well written.

Honor Router CD28 is a product that has been deeply customized in terms of software and hardware for operator customers, which is different from the Honor Router 2 sold through channels, there will be some operator customization functions, please choose a router that meets your needs.

Huawei Gigabit Router CD28V2 slowed down after a few days, are you sure it's not your network that is slowing down, and it has nothing to do with the router?

1. Light modem. If there is a problem with the optical interface, you need to replace the optical modem. (This is rare).

2. Indoor pigtail.

The connector of the connecting optical modem is loose. Plug the connector in and it can be restored.

3. The bending of the indoor part of the optical fiber is too large. Excessive collapse and bending of the optical fiber will affect the total reflection of the optical signal in the optical fiber.

Transmission, as long as the fiber is straight.

4. The outdoor part of the optical fiber is broken, and you need to find the operator to deal with it.

5. If the optical port failure of the operator's equipment in the computer room is faulty, the operator also needs to deal with it.

After checking the above problems, there is still a red light