What should I do if the boot time is too long and the computer boot time is too long?

Please use Windows Optimizer or Super Rabbit and other optimization software to remove some monitoring files, registry junk information, redundant DLL information, etc. in the system, which will significantly improve the running speed of your system.

It will be clear that the files in the temp, these are temporary files, it's fine.

Right-click on "My Computer - Properties", then click on "Hardware" and then click on "Device Manager", open "IDE ATA Pata Controller" in it (different chips are slightly different), then enter the primary and secondary IDE channels respectively, select "Advanced Settings", find the item "Current Transfer Mode" as "Not Applicable" here (this is the corresponding to the idle IDE channel), set the "Device Type" of this item to "None", and OK.

Solution: 1. It may be caused by too much system garbage, you can use third-party software to clean up, or you can clean up the disk of your computer, open the "Start" menu, select "Disk Management", select the disk that needs to be cleaned, and then right-click the disk, and select "Properties" - Disk Cleanup.

2. It may be that the operating system version is too low, and the computer system can be upgraded.

3. Using an SSD can also speed up boot.

Common computer usage problems:

1. If there is a problem with the graphics card of the computer, it may be that the cooling fan of the case is damaged, and it is recommended to replace the fan.

2. The local connection of the computer is gone, you can open the device manager of the computer, click "Network Adapter", right-click the driver and select "Update Driver Software".

Due to the uninstallation and installation of software in the process of using the system, there is a lot of garbage generated by the Internet, which causes our computer to be slower and slower. The boot time is getting longer and longer, what should I do? Here are two ways to improve boot speed!

Method 1: The simplest, crudest and most primitive method is to prohibit boot items.

1. First of all, press the key combination win (window key) + R at the same time to start the running taskbar.

Then enter msconfig in the run box and click the OK button, as shown in the following figure.

2. On the "System Configuration" page, click the "Startup" tab, and then remove the checkmark in front of the startup items that do not need to be booted! Click OK, as shown in the image below.

3. In order for the system modification to take effect, you need to restart the computer. We can directly click on restart the computer to complete the modification. After we remove unnecessary boot items, the system boot time will be significantly faster, as shown in the figure below.

Method 2: Optimize with the help of third-party software, and the following is 360 Security Guard.

Explain it as an example. 1. First of all, we open the 360 software installed in the computer, enter the home page, and then click Optimize Acceleration, as shown in the figure below.

2. Click on the startup item in the lower left corner, and then we will remove the antivirus software.

and the self-start of other software other than the input method is disabled, as shown in the figure below.

3. Finally, we restart the computer and it's done.

With the above two steps, we can easily help your computer**. If you want to know more about computer knowledge, you can click to follow me, if you have other computer problems to consult, you can also leave a message in the comments below the article, I will help you answer it! If you think the article is useful, please show it to more people!

The computer is taking too long to boot up.

Gingivitis.

Check whether the connection cable between the computer and the host is normal, if there is no problem with the cable, there may be a problem with the hardware of the host computer.

Turn off the main unit first, and remember to power off the power supply for the safety of your personal and computer.

Use a Phillips screwdriver to remove the screws on the back of the main unit, and push the cover of the main unit to remove the panel of the main unit.

After turning on the main unit, you can see the motherboard and other components, usually the display screen is black, this fault is caused by poor contact of the memory module.

Clean the memory module and card slot, and install the main unit.

First, there is a problem.

When a computer starts, it stays on the "Windows is starting" interface for too long and starts up slowly.

Second, the cause of the problem.

Generally speaking, the factor that affects the boot speed of the system is the loading of startup items at startup, if the system is loaded with a lot of unnecessary startup items when the computer starts, canceling the startup of these add-ons can speed up the boot of the computer. The long time that the Windows is starting page is usually caused by a problem with the Windows Event Log service.

3. Problem handling.

1.Select the Start - Windows Administrative Tools - Services command to open the Services window. (Shortcut key: "win+r" to open the run box, enter "msconfig" command).

2.Locate the Windows Event Log service option and find that the startup type for this item is Manual. Generally setting it to automatic will speed up the startup. After selecting "Automatic", click the "OK" button and restart the computer.

If there is a problem with the hardware of the computer, choose a computer with a relatively high configuration when choosing a computer, because the probability of the computer being stuck is very high and the computer is too slow to boot, you can choose to reinstall the computer system, which is also a good way. The premise is that all computer files are backed up first.

If the computer starts up for too long, there may be a lot of applications opened in the background, if you don't need the application or close it, don't count it when starting. Limit the startup, so that the boot is fast.