Windshield fog, how to remove windshield fog?

The foggy imprint has nothing to do with the glass No matter what the glass is, it can't be scraped with a knife, let alone the shock-resistant glass of the car The white powder you said is the glass glue used in the installation is not good The acid-iodine object in the glass glue is too high The acid-iodine object will increase the evaporation into acid-iodine gas under the sun's irradiation, and the acid-iodine gas will condense into a solid once it touches the sliding surface The surface of the glass and the car is slippery, so there is what you said.

1 You can wax the surface of the car, because the waxing paint becomes brighter, you can't see it, but after a few days, you can also take a quick cotton cloth [must be cotton] dipped in a small amount of gasoline to clean it [Note that you can only wipe iron and glass, don't wipe the plastic part will corrode.]

2. You can go to the 4S store and ask them to help you change the glass glue, but generally the 4S store refuses to warrant.

3 Just ignore it, the general acid iodine can be evaporated in 5 months under the sun's irradiation. When the time comes, you will use gasoline to clean it up, and it will not be there.

I am a maintenance worker for 4S.

1. It may be that there is a problem with the quality of the body waxing, it is recommended to try a different variety of wax, before waxing, it is best to wash the car, dry it in the shade, and then choose a delicate polish to throw off the light slightly.

2. Spray the car glass with paint cleaner, wipe it well, and then rinse it with water. Observe it later.

3. Replace the parking space, see if there is the possibility of spilling liquid in the upper space of the original parking, if there is an air conditioner upstairs, there may be atomized water, floating far away.

I guess it's a problem with the membrane, but generally speaking, there will be no problem with glass.

Can be wiped with a cloth.

Hot air blowing. Wipe with dish soap with a dry cloth".

1. The reason why the car glass is prone to water droplets in autumn.

In autumn and winter, the temperature difference between the inside and outside of the car begins to increase, and the front windshield of the car is easy to appear as fog when driving in the morning. When the temperature difference between the inside and outside of the car is large, the water vapor exhaled by the occupants of the car will condense into water vapor when it encounters the cold glass.

Second, the solution and the advantages and disadvantages of various methods.

1.The most primitive method is to wipe the glass directly with a dry cloth. This kind of scene must have been seen by many citizens:

The old drivers always have a towel and wipe the glass vigorously when they stop at a red light. The disadvantage of this method is that it is more laborious, and it will leave marks on the glass after wiping, and it will quickly fog up again. If you wipe while driving, it is easy to cause accidents.

2.Blow directly with hot air. However, this method works relatively slowly, and when the hot air is turned on in the middle of the vehicle, the fog on the front windshield becomes larger and larger, and it will take about ten minutes for the glass to gradually become clear.

It is recommended to turn on the hot air immediately after the car is warmed, blow first with a "high temperature" of more than 25 at the beginning, and then slowly lower the temperature after the fog disappears, and control it at about 22.

3.The method of "dish soap with dry cloth wiping" is not bad. Choose a sunny day, mix the kitchen dish soap with water (about 1 6), apply it evenly to the glass in the car with a sponge, and wipe it with a dry cloth after it is dry, without leaving traces.

Under normal circumstances, the effect can last for half a month. This method is feasible because the dish soap contains surfactants, which can change the surface tension of the water, so that the droplets quickly condense into large droplets, which can have an anti-fogging effect. However, this is a precautionary measure, and it is necessary to send an inspector in advance, and if you wait until you find a fog to get it, it will be too late.

Please look for the defrost button to defrost in the center console of the car and press it:

There are several ways to defog the front windshield of a car:

1. Wipe with a dry cloth or paper towel, the most primitive way is to wipe the glass directly with a dry cloth. This kind of scene must have been seen by many passengers: old drivers always carry a towel and wipe the glass vigorously when they stop at the traffic light.

Although the method is primitive, there are many people who use it, but it is relatively laborious, and there will be traces on the glass after wiping, and it will soon fog up again. If you wipe while driving, you are prone to accidents. A friend once admitted that on the first rainy day after he picked up the car, he helped the driver's wife clean the glass in the passenger seat"But in the end, it scraped with other cars"；

2. Dish soap is wiped with a dry cloth, and many people have mentioned the method of wiping some dish soap with a dry cloth to slow the nuclear glass. On a sunny day, mix dish soap with water (1:6), apply a sponge evenly to the glass in the car, and wipe it off with a towel after it dries, leaving no marks.

In general, it is updated every two to three weeks to maintain the effect;

3. With special defogging products, there will be some stalls selling special products for defogging and anti-fogging in many markets and auto parts cities. For example, the Xiayu anti-fogging agent is sprayed on the inner surface of the car glass, and wiped clean and even, while removing the glass dirt, it can also form a thin layer of transparent protective film on the glass, which can prevent the condensation of water vapor on the glass and form a fog layer, which can really be effectively maintained for about a month, which is more convenient.

Millions of car purchase subsidies.