The computer is stuck when the computer is turned on to log in to the user, how to solve it?

1. After the computer starts, it has been stuck in the "Starting Windows" interface. 2. This kind of problem is very common, the computer version of the system is not compatible, and the general green lite version of the system is prone to this kind of problem. 3. Press Ctrl+Alt+del to automatically restart the computer before entering the "Starting Windows" interface.

Go to the system to upgrade the antivirus software, take a look at the antivirus, or install 360 Security Guard to scan it.

Also, you have disabled the system process service.

Enter the safe mode to see if the card is still installed, and the unknown software is not installed.

To repair the system, you can run cmd sfc scannow

I've also encountered this problem before, this should be caused by searching for local IP when the computer starts, or if you have Kaspersky installed on your machine, it will also search for IP, so add an IP or don't start Kaspersky when you start, and wait for the computer to boot up and then turn it on, and the problem will be solved.

This may not be the case in safe mode.

Reinstall the system, load the boot boot file time, no success, may be the system file loss, if the machine is an old machine, but also consider the hard disk bad disk.

Use the safe mode to restart, after entering the safe mode, create a new account, and then re-enter it, delete the original account.

According to what I have got.

1. Format the F drive directly in the XP interface, that is, open the computer and right-click under the F drive to format it.

2. Reinstall the computer, it is best to find a new installation disk, choose manual installation, and choose to format C disk when you choose to format it.

Remember not to choose automatic installation, if you don't install it to other drive letters, you will lose a lot.

Press F8 when powering on, enterSafe modeInterface.

But when you go in, if you wait for a few minutes and there is no response, it keeps saying that please wait a while and let it reset the key to restart the computer, if the computer is installed with a one-click ghost backup before, you can decisively restore it and try it, but if it is still the case after the restoration. If the computer is still stuck in the "starting windows" interface when it is turned on, it will take so long to enter the PE system.

Set it up again, restart and press the delete key.

Go to the boot page and set the boot to a USB flash drive.

Start, enter the PE system, reinstall it in the PE system with the newly prepared Sun Bureau Windows7, and install and restart. If the computer is still stuck on the "Starting Windows" interface, then clean the inside of the case from dust.

After the computer is turned on, after the host drops, the display motherboard can not self-check, and it stays on the screen of the motherboard and does not move, and the machine cannot be turned on.

If you have a USB flash drive or card reader.

Dial the USB flash drive and card reader, then check the optical drive, and dial the data cable and power cable of the optical drive. Then down is the hard disk, and it is also the most likely reason, you can unplug the hard disk first, start the computer and see the boot screen.

If there is no problem, it may be that the data cable of the hard disk is not of good quality, or the contact is not good, which can be caused by pickpocketing. Note that first plug the hard disk data cable into the motherboard, or change both ends of the cable. If it doesn't work, test it with another wire.

1. Start Task Manager.

Method 1: Press the shortcut key.

Ctrl + Alt + Delete, and then select "Launch Task Manager" on the popping up page.

Fong Song Tong Blind Pose 2: Right-click on the computer desktop.

1. CPU usage: refers to the usage of your computer's CPU at the current moment, the lower this value, the lower your CPU, the less your CPU is currently occupied, more idle, and the computer will not appear stuck;

2. Physical memory.

It's the situation when your computer's memory is occupied, and the empty memory in the inner field here is the memory module that we usually call 4G 8G.

The computer is 4G memory, and 74% of it is occupied here, which means that I started a program that takes up a lot of memory (because I started the LOL game, this game occupies more than 500M memory);

3. End task: The end task button can end the selected task;

4. Applications.

QQ chat box, LOL game client;

5. Process: refers to some processes started by the current computer, for example: I open the lol game, then some corresponding processes will be started, which will be explained later;

7. Performance: The performance window can see the usage of the computer's CPU and memory, and the quality of a computer's CPU and memory, you can go to the performance to see the parameters.

When the computer logs in, it suddenly freezes, the first piece can, wait for two minutes on the mirror, don't move anything, if it can return to normal, it will not affect the normal use.

If you can't return to normal after waiting for two minutes, you should consider shutting down the strong luggage, and then wait for 2 to 3 minutes before turning on the machine and lifting the liquid, which is basically caused by abnormal system detection.

The computer crashed, and it was okay to directly force the mess to shut down, and it was okay to be able to recover it if you reopened it. Press and hold the power button directly, and the computer will automatically shut down for about ten seconds. Then press the power button, turn on the computer and it can be used normally.

Method 1: When the device is turned on, press "F8" to enter the "Safe with Command Prompt" mode, and enter "net".

user+username+123456 add" to forcibly set a user's password to "123456", and then log in.

Method 2: When the icon appears on boot, press the limb in time to call "F2", enter the Chinese BIOS interface of the ASUS laptop, find the power item, and change it to "Enable Fast Boot" to skip the password input and turn on directly.

Method 3: Buy a password cracking disc (of course, for the sake of your ASUS laptop, it is still not recommended unless you have to).

1.After checking the hardware, I didn't find any problems, and I started to think that the system was not doing a good job, and after reinstallation, the fault was still there, and finally I replaced the data cable of a hard disk, and the fault was solved.

2.A few days ago, every time I ran XP to the scroll bar, the scroll bar didn't move, and the machine died. When I turned on the phone, there was a normal prompt sound "dripping", and I estimated that the system may not be doing a good job, but pirated.

After reinstalling, it still freezes. I checked the hardware, and found no problems, according to the first method, it will not collapse will be a problem with the data cable, so replace the data cable of a hard disk, but the fault is still there. I wanted to give up completely, thinking that maybe there was something wrong with the motherboard.

It occurred to me that the chance of death would not be due to a problem with the memory value setting, and finally, I went into CMOS and set the BIOS to safe factory settings. Exit, actually passed the XP scrollbar, can enter the XP system normally.

3.Today, a friend called ** and said that the computer crashed and couldn't enter the system, and occasionally if you were lucky, you could get in, but it would crash after a while. I went over and found that it was very similar to the fault description above, I thought it was a virus, so I restored the system, and the result was still the same, it still crashed in that place, but it could enter safe mode.

Because the system that has just been restored should not have viruses. So it is estimated that it is due to the hardware aspect. I opened the case to check the hardware, and found that the light display of the network card was not normal, so I unplugged the network cable, who knew that the mouse could move, and it was connected again, and it crashed again.

It seems that the problem arises and the jujube town is hidden here. So I guess there is a problem with the network card, because they did it because of the network cable. So I asked my friend to find a network card, and because my friend's house was being renovated, I went to another computer and found that this computer was not connected to the Internet now.

The network cable is removed and thrown on the ground. Why is there no connector for this network cable, and suddenly I found that the light of the router was flashing abnormally, so I checked, and finally understood, why the computer crashed, it turned out that there is no Internet access to the Internet now, and both ends of the network cable of this computer are all connected to the router, causing a short circuit. So it crashed.

Here is a reminder to pay attention to the connection of network cables, and never connect all of them to the port.

Hello, it is possible to force the shutdown. After pressing and holding the power button for a while, it will automatically turn off, and then restart.

If the computer is stuck when logging in, you can click to restart, or you can click to restart on the computer's host.

The computer is stuck when it is turned on, generally because the memory module is loose, at this time, you can take the host apart and pull out the memory module, and then wipe the contact point of the memory module with your hand or an eraser.

When the computer logs in, it is stuck, it means that there is a certain problem in your system, you should log in in time, and then reinstall the system is imitating, if the reinstallation system can not solve the problem, you have to consider whether there is a question about the hardware on the fiber?

If the computer is stuck when logging in, most of them are system problems, of course, there are also hail rock factions that may be hardware problems, if your hard disk is faulty or the memory module is in poor contact, such a problem may occur, at this time there is no other way, but to force a restart.

The computer logs in and shouts when it is stuck, which means that there is too much garbage in this computer system, which causes the system to not be able to start normally, and there is a possible reason that the computer has been attacked by a virus and cannot log in. You can take the Wild Brain to a computer repair shop to repair it.

First consider two possibilities: one is that there is a problem with the game version of **, there is a file Qingxiao missing and so on, which causes it to not run, or the game path cannot have a Chinese name; The second is that there is a problem with the computer itself. The first situation is easy to judge,Look at other games with similar configuration requirements,Whether there will be a black screen situation where you can't enter the game,If not, it's a problem with the game itself.,Install it again.。

The second type of computer problem may be insufficient configuration, or the game is not switched to the independent graphics card and cannot be entered. It is recommended to add ** games, and your FPS and hardware running data will be displayed in real time in the game. High temperature of hardware such as graphics cards can easily cause black screens, etc.

Of course, an inappropriate driver may also cause a black screen.

Generally, there will be a reset button on the computer host, and the filial piety pants in the state of the smart shed power can be pressed to restart the computer. If you don't have the restart button, you can also press and hold the power button for 6 seconds, shut down the strong pure rotten system, and start it again later.

Hello, the computer is stuck, shut down and restart, and then press f8 when Xihuai boots up, select the latest correct configuration only crack. Wait to enter the system, if it is still stuck, you can only reinstall the system. I hope Lu Zhiwang can help you this time!

If the computer is stuck when logging in, it is recommended that you can restart it, unplug the power, and restart it, but it is best to wait for a period of time to make it clear before starting it. Hunger.

At the time of booting, press "F8" to enter the "Anju Touch Full with Command Prompt" mode, enter "net user+username+123456 add" to forcibly set a user's circle judgment talk password to "123456", and then log in.

can turn off the blind stupid machine and stop the first heavy grinding Qin to accompany Qi!

If the computer is stuck when logging in, you can reinstall the system, and it should be fine! Give it a try!

Modify the startup options. Turn off some unnecessary startup options. Cleaning up your computer junk can speed up your startup.

In this case, you can either wait, react, or restart.

Hello, I am glad to serve you and give you the following answers: Solution: 1. Check whether the computer has a virus, if so, please use anti-virus software to remove it; 2. Check whether the computer has a system update, if you have a good reputation, please install it in time; 3. Check whether the computer has hardware failures, if so, please repair them in time; 4. Check whether there is a software conflict on the computer, if there is, please uninstall the conflicting software in time; 5. Check whether the computer has a system error, if there is, please use the system recovery function to recover; 6. Check whether the computer has a hard disk failure, if so, please test the hard disk in time; 7. Check whether the computer has insufficient memory, if so, please upgrade the memory in time; 8. Check whether the computer has any system file corruption, if so, please use the system installation disk to repair it.

The above are the methods and steps to solve the problem of computer creation users have been stuck, I hope it can help you.

Summary. Hello dear, the computer creation user has been stuck: the new computer is stuck in the account creation and does not respond.

At present, it is connected to the wireless network, and then when you set up a Microsoft account, if there is no response, you can unplug the network cable first, or unplug the power of the wireless router. Then press and hold the power button for 10 seconds to force it to shut down, and then turn it on again. At this time, restart the system configuration.

Then do not enter the wireless password when the wireless network link interface. In this case, follow the steps below. Press the shortcut key, and on the network activation page, press the shortcut key shift+f10 or shift+fn+f10.

Enter the command and press Enter, enter the command "taskmgr" in the command prompt, and press Enter. Open the details and go to Task Manager to open the details. Select the task and select the task options.

Right-click to end the task, and this will successfully skip the network activation. Hope mine can help you; Once again, I wish you good health and a good mood! 

Hello dear, the computer creation user has been stuck: the new computer is stuck in the account creation and does not respond. At present, it is connected to the wireless network, and then when you set up a Microsoft account, if there is no response, you can unplug the network cable first, or unplug the power of the wireless router.

Then press and hold the power button for 10 seconds to force it to shut down, and then turn it on again. At this time, the system is re-established to imitate the rotten system configuration. Then do not enter the wireless password at the time or delay in the interface of the wireless network link.

When this backup group misses, follow the steps below. Press the shortcut key, and on the network activation page, press the shortcut key shift+f10 or shift+fn+f10. Enter the command and press Enter, enter the command "taskmgr" in the command prompt, and press Enter.

Open the details and go to Task Manager to open the details. Select the task and select the task options. Right-click to end the task, and this will successfully skip the network activation.

Hope mine can help you; Once again, I wish you good health and a good mood! 

Hello dear, the computer is stuck in the registration interface, reason: the first is the problem of the memory module, if it is a problem with the memory module, you can solve this problem by directly replacing a new memory module, the second is caused by too many bad sectors of the hard disk, if there are too many bad sectors of the hard disk, you can directly repair the bad sectors of the hard disk can solve this problem, through the operation of these two methods, you can completely solve the problem of the stool stool, and attack the stupid computer stuck in the registration page.