Seagate Seagate 500G 7200 11 because the firmware gate is now powered on and is not recognized

Find a leading vendor to brush the new firmware, the hardware is completely normal, and it is a bug problem of the firmware; If the business does not recover, the attitude should be tougher.

If it is returned to the factory for repair, it is also required to retain the data completely.

The data on the disk is indeed still there.

There is no damage. This is how today's merchants bully the soft and fear the hard.

Know that the average consumer is afraid of trouble.

So use the word "drag".

There are two ways to do this:

1.Find a consumer association or a reporter, and let those who are afraid of the business go out to help.

Often for the sake of credibility may compromise you.

2.Fix it yourself.

Find a hard drive of the same model and carefully remove the circuit board on it.

Swap it out on your hard drive and copy out what's inside.

The method on the first floor is the best, the firmware is originally stored in the chip on the circuit board, and changing a circuit board solves the problem.

This is a hard disk circuit fault, the platter should be fine, you can take off the exact same hard disk circuit board and replace it with the faulty hard disk, so that you can save the data.

If there is no problem with the hard drive, you can try to operate it unconventionally, but you must be careful of electric shock!! Specifically, you can use the hard drive as a USB flash drive on a machine that can run the Windows operating system, and you need to connect your Seagate hard drive to another IDE interface after boot or during boot.

over！！

It depends on what is the problem with your hard drive, that is, what is the specific fault? If you go to data recovery most people will not change it for you, and then test it well, to see if it is the failure of the hard disk itself, install the hard disk on other computers to see if it is still impossible, most of the hard disk is broken, you can only replace it with a new one, don't change the circuit board yourself, you will definitely not be able to change the new hard disk when you turn back. As for the manufacturer's data recovery, you can ask the merchant.

After three years, has it been solved? - Hard disks are valuable, and data prices are higher.

I have a "identical" hard drive to you, DIY OK - it's all there!

First of all, your hard drive definitely belongs to the solid hail simple balance door.

The firmware gate doesn't just say that the hard drive suddenly stops responding, the official description is: "In a very small number of seagates

A firmware issue has been found in the hard drive that causes data to be inaccessible after powering on and off. "The official description is definitely relatively simple.

In the actual process of use, the problems are: the hard disk is easy to have bad sectors, suddenly stop responding, or directly unrecognizable.

It is unlikely that your data can be retrieved, take the warranty, generally send it to the manufacturer, and the manufacturer will replace it with a brand new or good product (not a new product that has been tested by Seagate Repair Source, but it is also sealed in plastic packaging) to you. The cycle depends on whether your city is a first-tier city, generally about 20 days.

If your data is very valuable, you can find a professional data recovery company, spend a few k dollars, in a dust-free environment, change the circuit board, and the data will be dispersed, because yours is just the firmware is broken, and the platter is intact. Of course, if you only have some small movies on your hard drive, don't think about it.