When the computer is turned on, the motherboard welcome screen freezes 100 as soon as it appears

Because the screen stops at the motherboard welcome screen, the preliminary judgment is not a software system problem.

Seeing that the performance is similar to overclocking failure, it is recommended to empty the BIOS and try it.

So when did this happen to your computer? What did you do to your computer before it came along?

Please describe.

Unplug the pluckable ones and see if they can go into the BIOS

Has the CMOS battery been under it?

And the memory slots are okay.

Poisoned, system files are corrupted, I used to be like that, just reinstall the system.

It is recommended to boot the system on the boot disk and then select the last correct configuration!!

Pay attention, I'm about the same as you, and I haven't solved it yet.

Is it the wrong hard drive?

You check.

There may be two possibilities: One is that there is a problem with your motherboard, you can find a repair computer to test it.

The second is that your computer is poisoned, and I have been in this situation before, so it's best to reinstall the system.

Sometimes, due to some system failures, the computer reboot stays on the motherboard interface, and even the computer standby state stays on the motherboard interface, and prompts "press f1 to run setup", how to solve this situation? Let me share the solution with you, welcome everyone to read and learn.

The computer reboots and stays on the motherboard interface, and the logo does not move

Press the del key to enter the following interface, and use the cursor key to select the rightmost option "exit".

After entering the exit, this interface will appear, at this time, we use the upper and lower cursor keys to select the "load setup defaults" option, press the enter key to confirm and save.

Doing the previous step and pressing F10 to save and quit and restarting the computer should solve the problem, if the problem is not resolved, it may be another problem mentioned above. Let's tell you how to skip the motherboard logo interface when restarting and booting, we use the left and right cursor keys to select the boot option, select the white English option, that is, guide the boot configuration settings, after entering this option, use the up and down cursor keys to move to the white English option.

Press the Enter key to bring up the option box, select Disabled, then confirm, press F10 to save and exit, restart the computer and you will find that the full screen logo interface is gone.

Dear, what are the reasons why the new motherboard computer crashes when it is turned on: 1. There are many reasons why the computer crashes when it is turned on. There are hardware reasons, such as hard disk quality problems, CPU temperature is super hot, motherboard has minor faults, power supply quality problems, etc.; There are also software reasons, such as system failures.

2. Because you need to turn off the power again before you can turn on it normally, there may be many reasons for the hardware. It is recommended that you reinstall each piece of hardware on your computer again. Then turn it on and try it.

3. If the problem persists, you need to change the hard disk and reinstall the system for testing, so that you can eliminate the fault of the hard disk or system first. Then troubleshoot the motherboard and power supply one by one.

The computer has a bad screen and power supply, graphics card output, poor memory contact, and viruses in the system.

If you use the discrete graphics card output, you can uninstall the previously installed unstable graphics card driver and reinstall it, and the integrated graphics card driver can also be updated by using the integrated graphics card output on the motherboard;

Poor motherboard circuit or unstable power output will also affect the display output screen, you can replace the power output and replug the power line to see if it is improved;

Poor memory contact or memory damage will directly cause the failure of the display screen or no signal output;

You can regularly clean the dust on the memory, replace the memory slot, wipe the gold finger before installation;

If the screen is blurred due to a virus in the system, you can reboot the computer to enter the safe mode and select "Last correct configuration to start";

This is a memory problem with the graphics card, and if it is an integrated graphics card, it is a memory problem. Nothing to do with the motherboard.