-
That is, the sealing is not good, the hose and pipe under the noodle pool can be sealed with glass glue, and then fold a water trap, the floor drain is replaced with a good seal, and then the gaps are tightly hooked There is no problem, It is recommended that you take a look at the Jindal floor drain This kind of floor drain is a large water seal odor-proof floor drain, the water seal height meets the national requirements of 5cm, and the water seal storage capacity exceeds 300ml, which can ensure that it does not dry up for 30 days. The water seal of other products on the market is located in the drainage pipe, the volume is too small, and it is easy to dry up, resulting in the failure of the water seal, which cannot play the role of actual anti-odor, anti-virus and anti-bacterial insects. At the same time, it also has a siphon function, and the water is faster than the general floor drain.
-
Floor drains in the bathroom and steam from the washbasinCheck whether the water seal of the floor drain can store water, and if the floor drain cover can be closed, see if there is no smell. The basin is directly used with the hose with accessories with the S bend If not, you can use the hose to make the S bend, so that there is water in the S bend, and then seal the hose and the pipe inlet with glass glue.
For example, hardware stores sell sewer uncloggers. Hope mine can help you.
-
Why does the water in the washbasin come out of the floor drain, it is because the water is blocked. Floor drains are one of the most important components of a drainage system, which can play a role in drainage and waterproofing, but sometimes they can overflow. To remove the old floor drain, you can use a cutting machine to cut, but pay attention to the principle of cutting the edge of the floor drain when cutting, and do not damage the floor.
1.If the washbasin and floor drain in your bathroom share the same sewer pipe, when the washbasin drains more and more frequently, the floor drain will appear to be flooding. If there is a washing machine in the bathroom, this phenomenon can also occur when running the drain, because if there is air in the pipe, when the water pressure comes in, the pipe cannot drain quickly, and then the floor drain will be flooded.
After cutting, you can use a tool to tap the floor drain to loosen the gap between the floor drain and the floor tiles, so that the floor drain can be easily removed. After the floor drain is removed, you can first plug it in the sewer with a rag, which can prevent cement, sand, etc. So as not to fall into the drain and cause blockage.
After the mud around the floor drain is cleaned, you can take out the rag, and then put a new floor drain in it, check whether the floor drain is high or low, and level it if it is uneven.
2.When choosing a floor drain, it is important to check the depth of your own sewer pipe, and then confirm the height of the floor drain according to the height of your own sewer pipe. But this usually requires a professional construction team to confirm, otherwise it is easy to buy the wrong model.
In the process of purchasing floor drain, it is necessary to choose the kind that can prevent odor, and the style of floor drain must be sealed, otherwise for long-term use, the floor drain in the bathroom may have odor and other phenomena.
3.Floor drains are generally flush with the ground and are mainly used for drainage and pollution prevention. However, it can also be connected to the drain hose of the washing machine by means of a special connection, and the floor drain** has a removable lid.
After removing the cover, plug in the drain pipe of the washing machine to drain the water, which can be said to be quick and convenient. The above is the answer to the question of why the water in the washbasin will come out of the floor drain and whether the water is clogged.
-
It should be that the drain is blocked, if the washbasin in the bathroom is the same sewer pipe as the floor drain, when the washbasin drains more and faster, the sewer will not have time to flow down the water and will come out of the floor drain.
-
Yes, the sewer must be blocked, at this time you should immediately find some professional workers for maintenance, so that it will not affect the sewer in your home, otherwise it may be blocked, and life is very inconvenient.
-
It is indeed because the sewer is clogged, so the water will be reflected from the sewer, and the water will overflow from the floor drain.
-
In this case, the sewer is blocked!
-
Summary. First of all, check whether there is this kind of hair under this blockage, and this kind of backwater will appear, so this should be treated.
First of all, check whether there is this kind of hair under this blockage, and this kind of backwater will appear, so this should be treated.
Secondly, it may be because the problem of the pipeline Wang Sheng needs to be dredged and dealt with again, this is still to be solved by professionals, generally speaking, the floor drain trapped Liang Feng is opened to see if it is in a smooth state.
It is best to ask this kind of professional to deal with it, and not to solve it privately.
-
If it is a washbasin leakage, it is likely to be caused by the glass glue falling off at the sealing place, and you can directly find the leakage location and re-apply the glass glue. If the PVC sewer pipe is leaking, you can wrap the leak with raw meal tape first, and then buy a new sewer pipe to replace it as soon as possible. If the drain flap in the washbasin is leaking, you can replace it with a new one.
When replacing, you need to take out the old flap with pliers, then install the new drain flap, and finally close it with sealant.
1. Maintenance method of washbasin leakage.
1. Column washbasin leaking.
The basin of the pillar washbasin is usually stuck to the wall, and you need to use a wallpaper knife to cut the glue against the wall and remove the basin.
After removing the entire washbasin, remove the flap and female screws in the sink. Finally, according to the original order, the new flap is installed, and then glued and fixed.
2. Leakage of washbasin on the countertop.
The washbasin of the countertop basin does not need to be dismantled, and can be operated directly in the lower cabinet. The same is to take out the old copy and replace it with a new one.
If the bottom of the basin is sealed, the sealed part can be removed and the basin can be removed as much as possible to avoid damage to the sink as a whole.
Second, the way to replace the washbasin drain flap.
1. Prepare tools and materials.
First of all, prepare a new launching flap, and the size should be consistent with the original flap maintenance group. Then the necessary tools and materials such as raw material belt, universal tongs, glass glue and so on should also be prepared.
2. Disassemble the launching flap.
The drain flap is stuck on the basin and needs to be removed with universal pliers, which are easy to damage the ceramic layer.
3. Install a new launching flap.
Install the new drain flap in the basin, pay attention to pick up the basin countertop, take out the sealing ring of the drainer, and buckle the sealing ring of the drainer on the basin.
4. Sealing treatment.
Wrap the raw tape around the seal a few times to prevent water leakage, and then apply glass glue over the weekend. Because the ceramic adhesion of the sewer pipe is not firm, it is necessary to apply a little more glass glue to ensure the sealing.
5. Tighten the nut.
In a clockwise direction, tighten the nut on the lower part of the hand-washing riser plate with universal forceps. Pliers must be used during installation, and cannot be twisted by hand, otherwise it is easy to twist the threads in the water valve.
6. Connect the drainage pipe.
Finally, insert the other end of the sewer hole into the drain pipe, wait for the glass glue to cure, and then open the hole faucet to check the sealing effect.
-
In life, when decorating the basin of the washbasin, a layer of waterproof silicone will be put on the joint between the washbasin and the wall, so as to prevent water from leaking from the gap to the basin, causing water leakage. Therefore, once the silicone cracks or loosens, you must buy a new jar of glue, clean the original silicone, wipe it with a damp cloth and dry it, and then apply a new layer of silicone, so that the washbasin will have a waterproof function again.
Therefore, if the washbasin leaks, you need to clean up the silicone around it, buy a new can of glue and apply it to form a new waterproof strip, so that there will be no leakage.
-
There may be blockage, dredge it, I have a pump-type puff to try, if not, find a professional dredging.
The aftertaste must be that the floor drain is not deodorant, and the deodorant core can be installed, and the new moist silicone core is the best to use.
Most floor drains are not odor-proof, and those that are odor-proof may not work, shallow water seals are absolutely useless, deep water seals are easy to hang and plug, the structure of gear cores and magnet cores is easy to break, and drum washing machines will overflow. Submarine or very core floor drain, you dare to use it? In the end, I have to replace my silicone core if it breaks!
Why go around in so many circles? How good is it to buy mine directly? Don't just look at the brand and material when buying a floor drain, the anti-odor function, convenience and service life are the most important!
It's good to change the core, but it's troublesome to change the floor drain!
Xinrunshuang universal anti-odor floor drain: the extended silicone core seal is more reliable, five prevention and one free function, no cleaning and no hanging hair, anti-odor, anti-insect, anti-overflow and anti-blocking, and the straight-through type is the fastest to ensure that the drum laundry does not overflow! There are many styles and varieties, and there are 8 kinds of cores of different sizes and materials that can be interchangeable (silicone, magnetic, deep water seal, flap, etc.).
There are also a variety of washing machine joint tee accessories to comprehensively solve the problem of drainage. The new runshuang silicone core is easier to use than other water seals, magnets, and mechanical anti-odor cores of the flap core, no cleaning and no hanging hair, anti-odor and insect-proof, the overall elastic silicone seal will not be blocked and will not fail, and the longest design is faster than Bange silicone core, -50 200 degrees of cold and hot water are not afraid, and the life span is the longest, up to 50 years. There are four types of Xinrunshuang silicone cores, which are long and short, 30 cores, suitable for 27-55mm aperture, and it is very convenient to plug and play!
There is also an antiodor device suitable for hand basins and bathtubs, which comprehensively solves the problem of aftertaste!
Floor drain transformation: the inner diameter of the sewer hole 25-90mm old-fashioned water-sealed floor drain or pipe can be done anti-odor, insect-proof and overflow-proof transformation, please choose the odor-proof floor drain core and accessories, will not choose the accurate sewer pipe inner diameter, depth, hose diameter, it is best to have ** to explain the actual situation. 、
Attention to the problem of anti-odor and anti-odor: the smell is basically from the sewer pipe, pay attention to check whether the floor drain can effectively prevent odor, other sanitary ware including sinks, hand basins, bathtubs, shower rooms, and whether the sewer pipes of the mop pool have anti-odor measures, whether the air duct is not baffled back, and whether the bolt holes of the toilet are sealed. If you don't cook but there is fume, the smoke check valve does not work, you can replace the high-grade effective flue check valve, pay attention to whether the flue opening is in the main flue (public flue).
Floor drain handbasin anti-odor, insect-proof, anti-overflow and anti-blockage to find me to solve the problem, please go to**search ID: swqs or store: Tianjin special bathroom hardware store, specializing in kitchen and bathroom anti-odor and anti-odor, bathroom hardware accessories, water-saving pressurized shower.
-
Pipeline dredging agent can sterilize, deodorize, and prevent blockage.
You can replace the floor drain of your home, the sinks you said are relatively shallow, which refers to the more common shallow water seal floor drains, and the current floor drains have other anti-odor floor drain products, the principle is different, there is an anti-odor core. >>>More
Kitchen. Balcony.
or bathroom. Floor drains will be installed. >>>More
1. Floor drain In the past, in addition to the flush toilet drain design with a reverse bend, the bathroom and kitchen floor drain also had a reverse bend, usually relying on the sealing of water to prevent odors. At present, in order to increase the floor height and reduce the cost, many new residential areas have canceled the anti-drain under the floor drain, but adopted a new type of anti-odor floor drain to ensure that the sewer odor does not escape. These odor-proof floor drains are often made of PVC materials, which are far less beautiful than the stainless steel and copper floor drains sold on the market. >>>More
Preamble: When installing floor drains in the bathroom at home, the location of the installation must be selected close to the corner of the wall, and the position of about 10 cm is the best. When installing floor drains in the bathroom, most of them are designed by water and electricity installers. >>>More
The problem is that the engineering manager has tampered with your bathroom.