What is the reason why the host keeps calling the police?

Depending on your situation, it should be: your computer self-protection alarm, that is, your host temperature is too high, he will alarm the alarm! It is recommended that you check the temperature of your console and take a cooling method! This issue should be fixed immediately!

Wuqunshan's worth collecting, thank you, very useful.

That's the CPU high temperature alarm, and the CPU fan can be replaced to improve the heat dissipation of the CPU.

If the CPU fan is running for a long time, you can go to the CMOS to see what the CPU temperature is, you can also turn off the alarm item in the CMOS, or you can set the alarm temperature higher in the CMOS...

Tai Luo instigated. It's an alarm caused by your CPU temperature being too high.

It is recommended to remove dust or change the fan.

If it's an alarm sound like an ambulance, it's a problem with the CPU fan.

Turn on your computer and see if the hardware is overheating, mainly the CPU fan!

There's also the possibility of a problem with the memory module, dial it down and erase it with an eraser"Goldfinger"

Is it not turned off when you move the console? Does the display show it? Is there any poor contact between the cable connecting the main unit and the monitor?

Press the F8 key to turn on,Can the selection menu appear,If you can,Select the last Zhengqing Cave configuration to try whether Shizheng Li can enter the system。 The integrated graphics card cannot be replaced separately, and a discrete graphics card can be plugged in later.

First of all, the motherboard will not be scrapped, and the graphics card can be replaced separately.

It is recommended that you remove the motherboard and graphics card heatsink from Brother Zao.

And then they pretend to be a land raid and try to see if they can turn on the system and get into it.

The sound of the emergency alarm is loose, that is, the memory is loose, check it,.

1. A short sound, the memory refresh failed. The memory damage is serious, and I am afraid that the memory will have to be replaced.

2. Two short sounds, memory parity error. You can go to the CMOS settings and turn off the memory parity option, that is, set it to disabled. However, in general, the memory module has parity and turns on parity in the CMOS setting, which is good for the stability of the microcomputer system.

3. Three short sounds, the system basic memory (the first 64kb) check failed. Let's replace the memory.

Paragraph leaks state 4 and 4 short sounds, and the system clock is wrong. Repair or replace the motherboard.

5. Five short sounds, CPU error. But it's not necessarily all the fault of the CPU itself, it could also be the CPU socket or something, if the CPU is fine on other motherboards, then the fault must be with the motherboard.

6. Six short sounds, keyboard controller error. If the keyboard is not plugged in, then it is easy to do, just plug it in; If the keyboard connection is normal but there is an error message, you may wish to try a better keyboard; Otherwise, there is a problem with the keyboard control chip or related parts.

7. Seven short sounds, the system real mode is wrong, and it cannot be switched to the land protection mode. This is also the fault of the motherboard.

8. Eight short sounds, memory reading and writing errors. The memory chip on the graphics card may be damaged. If the memory plate is pluggable, just find the bad card and replace it, otherwise the graphics card will need to be repaired or replaced.

9. Nine short sounds, ROM BIOS test error. Try a good BIOS of the same type, and if it turns out that there is a problem with the BIOS, you can use rewriting or even hot-swapping methods to try to recover it.

10. Ten short sounds, register reading and writing errors. It can only be to repair or replace the motherboard.