How to design the master disk slave disk of two hard disks of the computer

1.Set it up in the BIOS.

It's OK to adjust a small order

Study, it's not bad, top down, hehe.

We all know that the hard disk in the computer is one of the main storage media of the computer, the hard disk is composed of one or more aluminum or glass discs, and the discs are covered with ferromagnetic materials. Hard drives are divided into solid-state drives (SSDs), machine hard drives (HDDs), and hybrid hard drives (HDDs). SSDs are stored using flash memory chips.

So, if there are two hard disks in the computer, how do you set up a master and slave? Let's show you how:

Step 1:

First of all, set the priority of the hard disk, open the BIOS settings page of your computer, enter the page and find the bootdevicepriority, this is the order of the hard disk, and then you need to set the priority of the hard disk. Step 2:

After finding it, enter, find the hard disk drive (harddiskdrivers) in the above figure, set the order of the two hard disks specified, you can adjust it with the arrow keys (generally by pressing the page turn key to adjust), and then put the hard disk that needs to be set to the main bit at the top.

Step 3:

At this time, return to the BootDevicePriority page, and 1stbootdevice will be automatically listed after entering, in this case, it is the first boot device, and then select the hard disk to complete the operation.

1. Start the computer and press the DEL key at the same time to enter the BIOS interface (some computers press the F2 key).

2. Press the left and right buttons, move the cursor to "Advanced BIOS FEAtrues" and press Enter.

3. Press the up and down buttons, move the cursor to "first boot device", press enter, and an options small dialog will pop up, which is all the boot items.

4. Select Hard Disk in the pop-up menu.

5. Press F10 to save and restart the computer.

Extended Information: How to use the computer hard disk:

When the hard drive is working, never force it to turn off the power. Turning off the power while the hard drive is working can lead to physical damage to the hard drive and data loss. In addition, if there are parts running at high speed in the hard disk, if the high-speed disc stops suddenly if it is forcibly shut down, and if it is turned on immediately after shutting down, it is more likely to cause damage to the hard disk.

So don't turn your computer back on right after shutting it down. Turn it on again at least half a minute later. When the hard disk is working, try to avoid it, because the distance between the head and the magnetic sheet is very close, if it is violently **, it will cause the magnetic head to hit the magnetic sheet, it is possible that the magnetic head will scratch the magnetic sheet, and it may also lead to complete damage to the magnetic head, making the entire hard disk unusable.

There is no need to set up a special set, which disk the operating system is installed on, that is the disk that guides the computer to start. Dispose of the other disk in the PE system of the USB flash drive first, and delete the boot partition.

It's much the same.

1. Boot into the BIOS settings, you can see the boot device priority, this is the selection of the boot order of the hard disk and other devices. If you have two hard drives, you need to set the priority of the hard disks first.

2. Go to the hard disk drivers in the figure above and specify the order of the two hard disks. Just move the disk that needs to be started to the top. Generally, it is adjusted by pressing the page turn key.

3. At this time, go back to the previous level, enter the boot device priority, and the 1st boot device will be listed, which is the first boot device, and you can select the hard disk. 

Reinstall the system, you can chat privately.