nero7 burning problem urgently

Nero7 also encountered this kind of problem, because my writing is a trial version, and after using it for a while, the CD can't be engraved. Later, I switched to Sony's ***architect to burn. You can go and give it a try.

Nero this thing I engrave the data disk line, and I can't engrave *** and CD. It's going to be bad, and if you carve it a little, you won't carve it, and you'll die there. To engrave *** it is recommended to take ***** architect.

I feel that the menu interface is better than nero, too.

I'm also using a sp3 system.,There has been no problem with burning.,Suggestion:

1.Defragment the C drive.

The remaining capacity of the disk must be greater than that, of course, the more left, the better.

3.Do not open any programs during or before burning, including those in the taskbar.

4.The above is the key to ensure the success of the burn, if it still doesn't work, it is a problem with the power supply.

The first problem is a bit of a dead end, I feel like your hardware and software are fine, but if you want to burn ***, first convert the movie to GPPE1 (***) format with a **converter, and then use nero software *** to convert and burn. Otherwise, relying on nero conversion alone, it will consume a lot of memory space to convert, and one of the link problems will appear "fake crash" phenomenon, that is, you will be stuck in the write guide for a long time, and there will be a burning failure error after the difficulty, whether to save the log, and then the burning drive will disappear from the system.

The second problem, *** RW reads and writes the CD, and uses the nero software to "format". (The same is true before the new disc is launched)、Of course, before the format*** CD disk, don't make a mistake. FYI.

Use nero7 first point the option to burn** to adjust the option to the minimum and then click to burn the data disc and then add ** and then click burn after burning you can *** in the machine ** can also be on the computer ** if you want to use a slide on the computer you can next IE8 browser can be able to become a slideshow.

Use the Shadow Factory software to convert to *** format, and then burn *** with Nero.

Nero burns always fail :

1. When the burning file exceeds 200M, do not operate the computer during the burning process, which is easy to cause crash and cause burning failure.

2. If you burn a CD, the total file size of the burned should not exceed 680M, and the total file size should not be exceeded.

3. Select "Check Disc Data After Burning" for each burning

4. Try to choose the carrier you want to burn above the software, CD or ***, don't make a mistake.

5. Buy a medium-to-high quality burning disk.