How to remove the full protection of the Mayjet motherboard? 100

Hello, you turn off the power, cut off the power, and press and hold the power button for more than 5 seconds. After that, open the case, remove the motherboard battery, and then install it back, boot into the BIOS, restore the factory settings, press F10 to save and exit, and you can solve the problem.

The first step is near the south bridge of the motherboard, there is a silver-white disc button cell battery with a plus sign on the back and a diameter of about two centimeters.

The second step is to press the tenon on the CMOS battery holder with a flat tool.

Step 3: The battery on the motherboard will automatically pop up and then take it out by hand.

Install the battery: first put the side without the buckle, then put the battery flat on the card position, press it with the edge, click, and the battery replacement is completed.

Before disassembling the battery, pay attention to:

First, the way to remove one's own static electricity is to touch the ferrous object with your hands.

2. Unplug the CPU, graphics card, hard disk and other devices on the motherboard.

3. Pay attention to the model of the battery. Now it's generally CR2032.

Extended Information: How to tell if the battery is dead:

1. The system time is not accurate, every time the computer is turned on, the system time will be restored to the initial time.

2. Unable to save the motherboard BIOS settings.

3. The computer cannot be turned on normally, and you need to press F1 every time you turn on it to enter the system.

The motherboard BIOS restores the default settings and discharges the buckle battery.

What do you mean by total protection? Restore card? Restore software?

Test the stability with the software orthos, bake it for 3 hours, and you basically passed the test.

Look at the hardware, use everest CPU-Z GPU-Z Windows optimization master.

There are system tests and system stability tests in the everest software.

Why don't you use CPU-Z GPU-Z! How easy it is to use this!

The main purpose of the motherboard test is to see if the motherboard can light up!

There is no need to make your own, the motherboard diagnostic card is less than 10 yuan a, it is through the ** display of the information when the motherboard starts the self-test, and you can buy it in places like the computer city.

Right-click on my computer properties Device Management and it will come out with a very complete information.

The failure of the computer motherboard and hardware cannot be judged by the software, because the normal operation of the software is based on the normal operation of the hardware, in other words, the software can run normally and the hardware will not have problems.

Computer motherboard and hardware failures can be detected with a "fault test card", which can be regarded as a hardware tool, but it can only measure the approximate range of faults.

It seems that there is a big problem, and it is recommended to send it to a professional repair shop.

1.This kind of fault detection is the first choice hardware detection card, which is the PCI interface, and the LED display fault code is seen.

2.Software is just using everest and the like, but it's just information.