Why do I always show up when I close the program

According to you, your computer system is fundamentally poisoned, that prompt, is to indicate that there is a memory unit occupied by a program, always refuse to exit, resulting in your program in the shutdown of the writing of information error, there are many kinds of viruses with this characteristic, especially some boot viruses, these viruses have a high priority, always enter the bottom layer of your system first, so, I think you want to deal with it thoroughly, you need to carry out a more thorough anti-virus on your system, It's best to use the DOS version to deal with it.,I think it's not easy for your phenomenon to deal with thoroughly in Windows.。

In addition, you can also observe,Is there a special program in the partition outside the system disk,Usually that is the characteristic that will cause you this phenomenon,For example, a batch of viruses such as the recent epidemic in August,All have this characteristic,There are illegal programs in the D disk E disk,In this way,How many times do you install the C disk,The virus will be copied immediately as soon as it is turned on :)

Test the memory with memtest86 and reinstall it if there is no problem, if there is a problem, there are bad blocks in your memory

Haha, I used to have this problem a lot, but now it's fine.

It should be that there is a file mismatch or a problem with the file name in your system, usually you accidentally destroyed a file when you were blind and deleted!

If there was no such problem before, if it was only recently, it was caused by a virus out of 10!

The computer always shows that there is a problem that causes the program to stop working properly, please close the program! What's going on?

This kind of prompt is usually an error prompt of the Windows operating system, and it usually appears when there is a problem or error in the application or system. Possible causes include: Software bugs:

An error or crash occurred in the application, causing the program to not function properly. System Failure: System file corruption, hardware failure, etc., can lead to system errors.

Virus or malware: When a computer is infected by a virus or malware, it can cause the program to malfunction or stop working. If you encounter this kind of problem, you can try the following methods to solve it:

Restart your computer: Sometimes, restarting your computer can help you fix some temporary issues in your computer by clearing them out. Update or reinstall the software:

If there is an error with an application, try updating or reinstalling the software to fix the problem. Virus scanning: Use anti-virus software to conduct a comprehensive scan to detect possible viruses or malware.

Check the hardware: Check for hardware damage, such as hard drive failures, low memory, and other issues that can cause errors in the system. If none of the above methods solve the problem, it is recommended to contact the relevant technical support or seek professional help.

There are three reasons why an application will automatically close in order:

1. Viruses. 2. Software Conflicts.

3. Security software shielding.

Specifically, you need to check the system logs and analyze the ** that went wrong, and the operation steps are the same for Windows 7 and Windows 10.

1. Press "Windows key + R" to enter it in the start-> menu""。

2. Enter appears"Event Viewer", open it, and then tap"Apply the slag program and service logs", just like Slow Oak after the scan and load the log is finished.

3. Check each item under it separately, if there is a red error item, double-click it, and you can see the specific error message.

Then, the error message is corrected.