The white earphone cable of your iPhone is getting dirty, is there an easy way to make it white back

Here's how:1Put the earphone cable on a white paper, squeeze the toothpaste on the toothbrush, and rub the earphone cable slightly, after the toothbrush has roughly brushed the earphone cable, then use a cotton swab to search for fine brushes (use toothpaste because toothpaste is more friendly, and other alkaline and acidic things such as soap are easy to corrode the earphones).

2.Soapy water: Take a small piece of soap, melt it with warm water, then wipe the earphone cable with a small amount of cotton war zone solution, and finally dry it with a dry towel, of course, you can also put it in dry and clean rice for a few hours. Note: Do not clean the interface.

3.Alcohol: Drop alcohol with cotton, wipe along the earphone cord, and finally air dry. This method can clean the interface, but alcohol is easy to cause the earphone cable to age, and it is easy to harden over time. This method can also be replaced with alcohol-based wipes.

The white earphone cable looks good, but it turns black after a long time and feels sloppy. Soak the toilet paper with hot water (very hot temperature), then pull the end of the earphone cable, pinch the earphone cable with the toilet paper soaked in hot water and pull it, and it will be done in just 2 seconds.

Gasoline is inconvenient to have residues. Dish soap: Don't make a fuss. It's better to throw it in the washing machine.

Alcohol is also acceptable, but the alcohol should be a high-purity industrial alcohol.

Zippo oil solves this problem perfectly. , First pick up the earphone cable vertically, then pour the zippo oil down and take the napkin to the end (men know it) Perfect as ever! If you still haven't rubbed it, repeat the steps above!

Pros Fully volatile and no residue **Absolutely no residue This is not questioned Disadvantages** is gasoline. More than ten times 335ml28-36 yuan A certain treasure water depth Don't blame me if you buy a fake

Gently wipe with white vinegar and dip a napkin in white vinegar

See what kind of dirt it is, if it's sludge or dust, you can try it with an eraser.

Don't touch the water.

Alcohol 99% or eraser can be recommended Alcohol is better.

Mine is the same. What to do.

Method: Can be cleaned with an alcohol smear. Alcohol breaks down dirt and acts as a sterilizer.

Preparation: alcohol, tissues, cotton swabs. The specific steps are as follows:

1. Use a cotton swab to dip an appropriate amount of alcohol, as shown in the figure below.

2. Then use a cotton swab to gently wipe the earphone head, as shown in the figure below.

3. After that, pour an appropriate amount of alcohol on the paper towel, as shown in the picture below.

4. Then wipe the earphone cable from top to bottom with a paper towel, as shown in the figure below.

It is recommended to use toilet paper or a handkerchief with water, pinch the thread and wipe it back and forth slowly, which can return to about 80% of the appearance. It is not recommended to wipe it with chemicals, I used to wipe a pair of earphone cables with dish soap and alcohol, and after two months, the earphone cables became very hard and slowly broke into sections. Headphones have a lifespan, so if you can't do it, you can replace them with new ones, and about 200 can also buy headphones with the same or better sound quality as the original headphones.

Just wipe it with alcohol, I just happened to make this piece of thread length before.

Wipe with toothpaste, milk, in fact, the easiest and most convenient is to wipe with wet wipes.