Super slow boot, high score reward, what should I do if my computer boots super slowly?

This kind of problem is often encountered, and I have looked for many methods, but the effect is not very ideal, and usually this situation can only be reinstalled by reinstalling the system.

First, make sure that there is no virus.

Second, there are too many bootloaders in the system, and it is useless to use Windows Optimizer (or other tools) to remove random boot items.

Third, right-click on my computer - Properties - Hardware - Device Manager - IDE ATA ATAPI controller - the primary and secondary IDE channels are open to see - what is the transfer mode in the advanced settings, if it is only PIO, change it to DMA (if available) I think this problem is more likely.

Fourth, redo the system.

If the above still doesn't work, then you need to start with the hardware. See if the hard drive has bad sectors. Replace the hard drive as soon as possible.

It is recommended to use Kaka Security Assistant or Kingsoft System Cleanup Expert to check whether there are malicious plug-ins, clean up, in addition, too much content in the startup items will also appear in this situation, enter msconfig in the run, you can remove some unnecessary startup items. Then try again.

The machine configuration is not good, or the system used is not good, or there are too many boot software, or there is a virus, or...

Check whether the machine configuration is normal, look at the explorer, and see if the devices are yellow. If the configuration is too old, go and upgrade the hardware. There is no problem with the hardware, see if your system is too much junk, optimize the useless things in the boot item with optimization software, and then use anti-virus software to kill the poison and scan the Trojan!

If the system is still very slow, "move" the useful things in the C drive to other disks, and then format the C drive and reinstall the system! If the configuration is not very high, don't install the Vista system, use XP!

1 Full antivirus, 2 Restore the BIOS to the default settings, sometimes just the second method is fine.

I also had this problem with my computer, and then I reinstalled the system.

After installing it, make a backup of the C drive, and restore it if necessary.

Turn off all random startup items and take a look again, it is recommended to use Security 360 Guard or Super Bunny.

You make a list of things related to your computer's configuration and startup items and see if they can help you. There is also the first anti-virus and Trojan horse, and there is no effect to reinstall the system.

This is the case with the landlordGenerally, there are too many loaded programs before booting. If you play back the registry.

You can set it up directly inside. Unload useless stuff. If the landlord doesn't know anything about the registry, I still recommend that you get a master.

Hope I can help you.

I'm going to give you a trick, and I'm sure it's going to work, and my computer used to have this problem.

First of all, start-run-typemsconfig-start-remove the checkmark except ctfmon and antivirus, keep only ctfmon and antivirus, ctfmon is the input method, and then make sure to restart later.

And then, in general, our IP address is obtained automatically, so every time you start the computer, it will automatically search for your IP address, which is very delayed, so the startup is slow, so you can set it to a default fixed IP such as etc.

In addition, your temporary files should also be cleaned up in time This is very simple, the next optimization master is ok, restart it, absolutely done!!

It could be a system issue. Generally, the system needs to be reinstalled in three months, otherwise the system will run slower and slower.

Personally, I think that ha, in fact, viruses are not everywhere, the key is to look at the people who use the computer. You can install a 360 security guard, and then there is a small control for boot acceleration, and you can fully control the boot and startup items of the computer, as well as the service ha. This way you should be able to turn on and off faster.

The main root cause is the boot startup item and the fault caused by the service. Secondly, pay attention to your disk cache, which also has a bit of an impact.

The easiest way is to restore the system or reinstall the system if you have a backup on your computer, so that the problem can be solved faster.

There are too many boot items, just clean up with 360 Security Guard and clean up the temporary files of your computer.

Friend, I think "360 Security Guard" may be helpful to you.

Open path: Open 360 Security Guard - Function Encyclopedia - Boot Acceleration (the first one in the upper left corner) - One-click optimization.

Note: If you know a little bit about computers, you can further optimize it manually).

Optimize the system and eliminate unnecessary startup items.

Let's kill the virus first, and if it doesn't work, redo the system.

The computer is getting an IP address when the network connection is not available. It's normal.

If you want to come out as soon as you turn on the phone, you can manually set your own IP address. To do this, click on Properties on your network connection icon. Go in and find the IP protocol, and then set the IP by yourself, if you are ADSL dial-up Internet access, you can set it to: If you are a community broadband plugged in the network cable and go directly to the Internet, you can't set it up like this, which will lead to no access to the Internet.

If you are surfing the Internet through a router, remember to set the IP to the same IP range as the router.

Hello, at this time, because you do not set a fixed IP for the network, but use a dynamic way to obtain the IP, so that the computer will take up a lot of time to search for the IP after the boot, and you can set a specified IP. Hope it works for you.

0 security guard, a computer generally can't be installed with two killing soft. Also, you can try it out with 360 Security Guard's boot one-click optimization. You don't have to allow the software to start on its own, and probably a lot of the software has a background running process or something.

There are two processes in MATLAB that are like this, which start automatically at startup, but MATLAB does not start, and there are many similar software. Hope it helps. If you have any questions, you can ask them again.

My suggestion is that you remake a new system, install other required software and back it up, as long as the computer is slow in the future, you can restore it, and you can get it done in a few minutes.

As long as your computer configuration is not very low, all that garbage removal or anything is not of much use.

Always clean up the junk on your computer, control the startup project, and don't let it start when you turn it on.

There is a problem with the system, redo it.

Turn off unnecessary startup items, don't start everything on boot!